DFI NS80-EA Bedienungsanleitung

NS80-EA

NS80-EC

NS80-EL

Rev. A+

System Board

User’s Manual

63500233

This publication contains information that is protected by copyright.

No part of it may be reproduced in any form or by any means or

used to make any transformation/adaptation without the prior

written permission from the copyright holders.

This publication is provided for informational purposes only. The

manufacturer makes no representations or warranties with respect to

the contents or use of this manual and specifically disclaims any

express or implied warranties of merchantability or fitness for any

particular purpose. The user will assume the entire risk of the use or

the results of the use of this document. Further, the manufacturer

reserves the right to revise this publication and make changes to its

contents at any time, without obligation to notify any person or

entity of such revisions or changes.

Trademarks

Windows® 98, Windows® 98 SE, Windows® ME, Windows® 000,

Windows NT® 4.0 and Windows® XP are registered trademarks of

Microsoft Corporation. Intel® and Pentium® 4 are registered

trademarks of Intel Corporation. SiS® is a registered trademark of

Silicon Integrated Systems Corporation. Award is a registered

trademark of Award Software, Inc. Other trademarks and registered

trademarks of products appearing in this manual are the properties

of their respective holders.

Caution

To avoid damage to the system:

• Use the correct AC input voltage range.

To reduce the risk of electric shock:

• Unplug the power cord before removing the system chassis

cover for installation or servicing. After installation or servicing,

cover the system chassis before plugging the power cord.

Battery:

• Danger of explosion if battery incorrectly replaced.

• Replace only with the same or equivalent type recommend by

the manufacturer.

• Dispose of used batteries according to the battery

manufacturer’s instructions.

Joystick or MIDI port:

• Do not use any joystick or MIDI device that requires more than

10A current at 5V DC. There is a risk of fire for devices that

exceed this limit.

FCC and DOC Statement on Class B

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC rules.

These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a residential

installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with

the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio TV technician for

help.

Notice:

1. The changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority

to operate the equipment.

. Shielded interface cables must be used in order to comply with

the emission limits.

Notice

This user’s manual contains detailed information about the system

board. If, in some cases, some information doesn’t match those

shown in the multilingual manual, the multilingual manual should

always be regarded as the most updated version. The multilingual

manual is included in the system board package.

To view the user’s manual, insert the CD into a CD-ROM drive. The

autorun screen (Main Board Utility CD) will appear. Click “User’s

Manual”.

System Board

This user’s manual is for the NS80-EA, NS80-EC and NS80-EL

system boards. The differences between these boards are shown

below.

RJ45 LAN por t

IEEE 1394A





NS80-EL



NS80-EA



NS80-EC

Table of Contents

Chapter 1 - Introduction

1.1 Features and Specifications..................................................................................

1. Package Checklist.........................................................................................................

Chapter 2 - Hardware Installation

.1 System Board Layout ..........................................................................................

. System Memory...........................................................................................................

.3 Jumper Settings for Clearing CMOS Data........................................

.4 Rear Panel I/O Por ts..............................................................................................

.5 I/O Connectors...........................................................................................................

Chapter 3 - Award BIOS Setup Utility

3.1 The Basic Input/Output System.....................................................................

3.1.1 Standard CMOS Features.............................................................

3.1. Advanced BIOS Features..............................................................

3.1.3 Advanced Chipset Features ......................................................

3.1.4 Integrated Peripherals.........................................................................

3.1.5 Power Management Setup............................................................

3.1.6 PnP/PCI Configurations....................................................................

3.1.7 PC Health Status...................................................................................

3.1.8 Frequency/Voltage Control............................................................

3.1.9 Load Fail-Safe Defaults.....................................................................

3.1.10 Load Optimized Defaults..............................................................

3.1.11 Set Supervisor Password...............................................................

3.1.1 Set User Password..............................................................................

3.1.13 Save & Exit Setup.................................................................................

3.1.14 Exit Without Saving..............................................................................

3. Updating the BIOS.....................................................................................................

Introduction

106

Chapter 4 - Supported Softwares

4.1 Desktop Management Interface...................................................................

4. Drivers, Utilities and Software Applications.......................................

4.3 6-Channel Audio Output via Software.................................................

4.4 Installation Notes........................................................................................................

Appendi A - Using the Suspend to RAM

Function

A.1 Using the Suspend to RAM Function.....................................................

Appendi B - System Error Messages

B.1 POST Beep.....................................................................................................................

B. Error Messages.............................................................................................................

Appendi C - Troubleshooting

C.1 Troubleshooting Checklist...................................................................................

101

108

Introduction

1.1 Features and Specifications

1.1.1 Features

Chipset

•SiS

® 648/963

Processor

The system board is equipped with Socket 478 for installing a

Pentium® 4 or Celeron® processor.

• Intel® Pentium® 4 processor (478-pin)

- 533MHz system data bus - supports up to .53 GHz CPU

speed

- 400MHz system data bus - supports up to .4 GHz CPU

speed

• Intel® Celeron® processor (478-pin)

- 400MHz system data bus - supports up to 1.7 GHz CPU

speed

System Memory

• Three 184-pin DDR DIMM sockets

• Supports 6 banks up to 3GB using PC1600 (DDR 00),

PC 100 (DDR 66) or PC 700 (DDR333) unbuffered DDR

SDRAM DIMM, .5V type

• 16Mb, 64Mb, 1 8Mb, 56Mb and 51 Mb SDRAM technology

with page size from KB up to 16KB

Chapter 1 - Introduction

Introduction

Expansion Slots

The system board is equipped with 1 AGP slot and 6 PCI slots.

AGP is an interface designed to support high performance 3D

graphics cards. It utilizes a dedicated pipeline to access system

memory for texturing, z-buffering and alpha blending. The universal

AGP slot supports AGP 8x with up to 13 MB/sec. bandwidth and

AGP 4x with up to 1066MB/sec. bandwidth for 3D graphics

applications. AGP in this system board will deliver faster and better

graphics to your PC.

Onboard Audio eatures

• AC'97 . extension compliant codec

• Supports Microsoft® DirectSound/DirectSound 3D

• AC’97 supported with full duplex, independent sample rate

converter for audio recording and playback

• S/PDIF-in/out interface (S/PDIF-in is optional)

• 6-channel audio output

S/PDI

The system board is equipped with the S/PDIF (Sony/Philips Digital

Interface) digital audio interface. S/PDIF is a standard audio file

transfer format that transfers digital audio signals to a device without

having to be converted first to an analog format. This prevents the

quality of the audio signal from degrading whenever it is converted

to analog.

Introduction

Onboard LAN eatures (NS80-EA and NS80-EL only)

• Uses Phy fast ethernet controller

• Integrated IEEE 80 .3, 10BASE-T and 100BASE-TX compatible

PHY

• 3 -bit PCI master interface

• Integrated power management functions

• Full duplex support at both 10 and 100 Mbps

• Supports IEEE 80 .3u auto-negotiation

• Supports wire for management

IEEE 1394A Interface (NS80-EA only)

• Uses Realtek RTL8801 chip

• Supports three 100/ 00/400 Mb/sec ports

The Realtek RTL8801 Phy 1394A controller works with the SiS 963

chip to support IEEE 1394A. It is fully compliant with the 1394A

OHCI (Open Host Controller Interface) 1.1 specification. 1394A is a

fast external bus standard that supports data transfer rates of up to

400Mbps. In addition to its high speed, it also supports isochronous

data transfer which is ideal for video devices that need to transfer

high levels of data in real-time. 1394A supports both Plug-and-Play

and hot plugging allowing devices to be attached or removed from

the system, even with the power on.

PCI Bus Master IDE Controller

• Two PCI IDE interfaces support up to four IDE devices

• Supports ATA/33, ATA/66, ATA/100 and ATA/133 hard drives

• UDMA Modes 3, 4, 5 and 6 Enhanced IDE (data transfer rate

up to 133MB/sec.)

• Bus mastering reduces CPU utilization during disk transfer

• Supports ATAPI CD-ROM, LS-1 0 and ZIP

IrDA Interface

The system board is equipped with an IrDA connector for wireless

connectivity between your computer and peripheral devices.

Introduction

USB Ports

The system board supports 6 USB .0/1.1 ports. USB 1.1 supports

1 Mb/second bandwidth while USB .0 supports 480Mb/second

bandwidth providing a marked improvement in device transfer

speeds between your computer and a wide range of simultaneously

accessible external Plug and Play peripherals.

BIOS

• Award BIOS, Windows® 98/ 000/ME/XP Plug and Play

compatible

• Supports SCSI sequential boot-up

• Flash EPROM for easy BIOS upgrades

• Supports DMI .0 function

• Mbit flash memory

Desktop Management Interface (DMI)

The system board comes with a DMI .0 built into the BIOS. The

DMI utility in the BIOS automatically records various information

about your system configuration and stores these information in the

DMI pool, which is a part of the system board's Plug and Play

BIOS. DMI, along with the appropriately networked software, is

designed to make inventory, maintenance and troubleshooting of

computer systems easier. Refer to chapter 4 for instructions on using

the DMI utility.

Rear Panel I/O Ports (PC 99 color-coded connectors)

• Four USB .0/1.1 ports

• One RJ45 LAN port (NS80-EA and NS80-EL only)

• Two NS16C550A-compatible DB-9 serial ports

• One DB- 5 parallel port

• One mini-DIN-6 PS/ mouse port

• One mini-DIN-6 PS/ keyboard port

• Three audio jacks: line-out, line-in and mic-in

Andere Handbücher für NS80-EA

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere DFI Hauptplatine Handbücher

DFI

DFI P2XLX/e Bedienungsanleitung

DFI

DFI P5BTX/L Bedienungsanleitung

DFI

DFI PL610-C622 Bedienungsanleitung

DFI

DFI BW171 Bedienungsanleitung

DFI

DFI CD70-SC Bedienungsanleitung

DFI

DFI HU171 Bedienungsanleitung

DFI

DFI AD76 RAID Bedienungsanleitung

DFI

DFI 945G-TMGF Bedienungsanleitung

DFI

DFI CA230-BF Bedienungsanleitung

DFI

DFI CW65 Series Bedienungsanleitung

DFI

DFI AM36-EC Bedienungsanleitung

DFI

DFI AM33-EC Bedienungsanleitung

DFI

DFI G7L332-L Bedienungsanleitung

DFI

DFI CD101-N Bedienungsanleitung

DFI

DFI PB64-BX Bedienungsanleitung

DFI

DFI CA100-D Bedienungsanleitung

DFI

DFI SD631-C236 Bedienungsanleitung

DFI

DFI G586OPC/E Bedienungsanleitung

DFI

DFI GIC68-D Bedienungsanleitung

DFI

DFI SR100-N Bedienungsanleitung

DFI

DFI SD170 Bedienungsanleitung

DFI

DFI ADS630-R680E Bedienungsanleitung

DFI

DFI PIC-Q170 Bedienungsanleitung

DFI

DFI ADS310-R680E/Q670E Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Biostar

Biostar M7VIT Bravo Bedienungs- und Montageanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

EPOX

EPOX MU-8KHA0010 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung