Dimplex ELECTRALOG CS1205 Bedienungsanleitung
SERVICE MANUAL
FOR
COMPACT STOVE
Model CS1205
7400290000R02
CS1205
1
Table of Contents
OPERATION ............................................................................................................................. 2
REPLACEMENT PARTS........................................................................................................... 4
WIRING DIAGRAM ................................................................................................................... 5
TO REPLACE LIGHT BULBS.................................................................................................... 6
TO REPLACE LAMPHOLDERS................................................................................................ 7
TO REPLACE ON/OFF AND HEATER SWITCHES ................................................................. 8
TO REPLACE HEATER ASSEMBLY........................................................................................ 9
TO REPLACE TERMINAL BLOCK.......................................................................................... 10
TO REPLACE FLAME MOTOR/FLAME ROD......................................................................... 11
TO REPLACE THE POWER CORD........................................................................................ 12
TROUBLESHOOTING GUIDE................................................................................................ 13
CS1205
2
OPERATION
Compact Stove Controls
A. Main on/off switch
1. The fireplace has a manual power ON/OFF switch located on the lower right side of
the stove.
2. To operate, press the switch to turn the unit on or off
B. Low Heat Switch
Press this switch to turn the stove to low heat.
C. High Heat Switch
Press this switch to turn the stove to high heat.
RESETTING THE TEMPERATURE CUTOFF SWITCH
Should the heater overheat, an automatic cut out will turn the heater off and it will not
come back on without being reset. It can be reset by switching the MAIN ON/OFF
SWITCH to OFF and waiting 5 minutes before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug the unit and call Dimplex North
America Limited at 1-888-346-7539.
CS1205
3
7
4
3
2
5
12
8
10
6
11
9
1
CS1205
4
REPLACEMENT PARTS
COMPACT STOVE, DIMPLEX
PART NO. 6902340100
REPLACEMENT PART REPLACEMENT PART NO.
1. Log Set Assembly 0477850100RP
2. Flame Motor 120V 2000210200RP
3. Heater Assembly (comes with cutout) 2200491000RP
4. Main On/Off Switch 2800070700RP
5. Heater Switch 2800070200RP
6. Cord Set 120V 4100090103RP
(When 4100090103RP is gone use 4100090201RP)
7. Moulded Lampholder 4200121000RP
8. Flame Rod 5900250100RP
9. Mirror 5900530200RP
10.Foot 0477830159RP
11.Terminal Block 4000070100RP
12.Capacitor 2300030100RP
CS1205
5
WIRING DIAGRAM
CS1205
6
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
Light bulbs need to be replaced when you notice a dark section of the flame. There are
four bulbs under the log set which generate the flames and embers.
It is a good idea to replace all of the light bulbs at one time if they are close to the end of
their rated life. Group replacement will reduce the number of times you need to open
the unit to replace the light bulbs.
TO REPLACE LIGHT BULBS
1. Remove the 5 fastening screws from the back access panel and remove the panel.
2. Examine the bulb to determine if replacement is required.
3. Unscrew the bulb counter clockwise.
4. Insert and install the new bulb.
5. Re-secure the access panel to the unit.
LIGHT BULB REQUIREMENTS
Quantity of 1 clear chandelier or candelabra bulbs with an E-12 (small) socket base,
60 watt rating.
CS1205
7
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE LAMPHOLDERS
1. Remove the light access panel from the bottom of the rear panel of the stove.
2. Remove the light bulb from the socket by turning counter clockwise.
3. Turn the stove over onto its top.
NOTE: A protective barrier between the top of the unit and your work surface is
suggested, (i.e. cloth, cardboard, thick plastic) to avoid scratching the finished
surface of the stove.
4. Remove the 5 screws which secure the bottom heater cover to the fireplace: 2 at the
front and 3 at the back.
5. Lift the heater assembly and cover off the body of the stove and turn sideways
resting it against the legs of the unit, exposing the light harness/socket assembly
and terminal block.
6. Cut the plastic wire-ties which secure the wires to the base of the stove.
7. Remove the blue and white wires from the terminal block by loosening the screw in
the associated terminal to release each wire, noting their original locations.
8. Remove the screw which secures the lampholder to the base of the fireplace.
9. With a flat head screwdriver, push the lampholder sideways to allow mounting tab to
release so that it can be pushed through the opening in the base of the stove.
10.Through the access panel in the back, pull the original lampholder and the wire
leads out of the stove.
11.Through the same location feed the new lampholder back into the base of the stove.
12.Secure the socket with the original screw.
13.Insert the wires into the terminal block following the original configuration and tighten
the terminal screws to secure the wires into position.
14.Re-assemble the covers and the light bulb in reverse order as described above.
NOTE: When securing the bottom panel to the fireplace, take care that no wires are
in the way of the heater fan and are not caught or pinched between the cover and
the stove.
CS1205
8
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE ON/OFF AND HEATER SWITCHES
1. Turn the stove over and place it top down.
2. Remove the bottom heater assembly cover being careful not to damage any of
the wiring.
3. Remove the 4 heater retaining screws from the bottom of the heater assembly
cover and move the heater to gain access to the switch connections.
4. Locate the switch to be replaced mounted on heater assembly cover and
disconnect the wiring clips and connections noting their original locations.
5. Depress the retainer clips on the rear of the switch and push the switch out of the
rear of the cover.
CS1205
9
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE HEATER ASSEMBLY
1. Turn the stove over and place it top down.
2. Remove the bottom heater assembly cover being careful not to damage any of the
wiring.
3. Remove the 4 heater retaining screws from the bottom of the heater assembly cover
and move the heater to gain access to the heater connections being careful not to
damage any of the wiring.
4. Disconnect the 2 heater switch leads from the heater.
5. Remove the wire nut and disconnect the thermal cut-out wire.
6. Remove the 2 mounting brackets from the bottom of the old heater and install them
on the new heater.
7. Reassemble in the reverse order as above.
Andere Handbücher für ELECTRALOG CS1205
3
Inhaltsverzeichnis
Andere Dimplex Herd Handbücher
Dimplex
Dimplex COURCHEVEL CVL20E Bedienungsanleitung
Dimplex
Dimplex VLT-OV Bedienungsanleitung
Dimplex
Dimplex CLUB Bedienungsanleitung
Dimplex
Dimplex ELECTRALOG CS1205 Bedienungsanleitung
Dimplex
Dimplex CS-12056A Bedienungsanleitung
Dimplex
Dimplex DS7420 Kurzanleitung
Dimplex
Dimplex Optiflame Electric Fireplace Bedienungsanleitung
Dimplex
Dimplex contempra ef KDS6401E Bedienungsanleitung
Dimplex
Dimplex Club CLB20 Bedienungsanleitung
Dimplex
Dimplex Opti-V 360 Bedienungsanleitung
Dimplex
Dimplex ELECTRIC STOVE Bedienungsanleitung
Dimplex
Dimplex Bellingham 8kW Bedienungsanleitung
Dimplex
Dimplex CDS8515 Bedienungsanleitung
Dimplex
Dimplex Noir RTOPSTV20GN Bedienungsanleitung
Dimplex
Dimplex Burgate Bedienungsanleitung
Dimplex
Dimplex ELECTRALOG CS3311 Bedienungsanleitung
Dimplex
Dimplex ELECTRIC PATIO STOVE Bedienungsanleitung
Dimplex
Dimplex Opti-myst Cassington CSN20 Bedienungsanleitung
Dimplex
Dimplex DS3311 Bedienungsanleitung
Dimplex
Dimplex ELECTRALOG CS4416 Bedienungsanleitung
Beliebte Herd Handbücher anderer Marken
Vermont Castings
Vermont Castings Intrepid 2 Bedienungsanleitung
Italiana Camini
Italiana Camini CLASSICA Kurzanleitung
Avalon
Avalon Vashon Avanti DVS FS Bedienungsanleitung
Spartherm
Spartherm ambiente a1 Bedienungsanleitung
Warmlite
Warmlite WL46040 Bedienungsanleitung
Regency
Regency Ultimate U39E Series Kurzanleitung