3
EN
Wireless Receiver Intended Use
• The installation must comply with all applicable local
or national codes, including the latest edition of the
following standards:
U.S.A.
– ANSI/NFPA70, National Electrical Code (NEC)
– ANSI/NFPA 1192, Recreational Vehicles Code
– ANSI Z21.57, Recreational Vehicles Code
Canada
– CSA C22.1, Parts l & ll, Canadian Electrical Code
– CSA Z240 RV Series, Recreational Vehicles
1.4 General Safety Messages
WARNING: IMPACT OR CRUSH HAZARD.
Failure to obey the following warnings could
result in death or serious injury:
• This product should be installed in a controlled
environment (inside). Do not install product during
windy conditions, or when wind is expected.
Otherwise, product could move unpredictably,
become unstable, and could detach, bend, or
collapse.
• Make sure the awning retract button and the awning
extend button operate the awning in the intended
direction.
• Keep your hands, arms, head or torso clear of the
awning hardware during periods of rain, wind, etc.
These conditions may cause the wind sensor to
unexpectedly activate and retract the awning.
WARNING: FIRE OR ELECTRICAL SHOCK
HAZARD. Failure to obey the following
warnings could result in death or serious
injury:
• For all wire connections, use only NEC-approved
connectors and terminals that are appropriately sized
for the wire gauge.
• Disconnect 120 VAC power from RV. Failure to do so
could result in death or serious injury.
2 Intended Use
The Wireless Receiver is intended for use in recreational
vehicles. Pair devices with the receiver to allow
communication between the device and the awning.
The manufacturer accepts no liability for damage in the
following cases:
• Faulty assembly or connection
• Damage to the product resulting from mechanical
influences and excess voltage
• Alterations to the product without express permission
from the manufacturer
• Use for purposes other than those described in the
operating manual
Dometic Corporation reserves the right to modify
appearances and specifications without notice.
3 General Information
This section describes the awning series compatibility
and the recommended tools to install the wireless
receiver.
IThe images used in this document are for reference
purposes only. Components and component
locations may vary according to specific product
models. Measurements may vary ±0.38 in. (10 mm).
3.1 Compatibility
The wireless receiver is compatible with the following
power awning pro series:
• 9100
• 9200
• 9500
3.2 Recommended Tools
The following are the recommended tools for
installation:
Recommended Tools
Phillips Screwdriver Flat-Blade Screwdriver
