Dometic MF20-60 Bedienungsanleitung

RH 131 RH 141

Type: MF20-60

Operating Instructions

207.5184.81

Thank you for choosing our appliance. We are sure it will

provide you with trouble-free use. In the following, we

would like to familiarise you with some symbols, which we

bring to your attention to ensure the safe and efficient

operation of the appliance: source of danger, in event of

improper operation suggested useful tips to read

information concerning environmental protection This

refrigerator is intended for the storage of food and drinks.

1. 1. Unpacking

2. 2. View of the appliance

3. 3. Cleaning

.4. Positioning the appliance

.4.1. Installation instruction

.5. Using the appliance

.5.1. Temperature regulation

4. 6. Ice cubes

5. 7. Useful suggestions

6. 8. Defrosting, cleaning and maintenance

7. 9. Changing the lightbulb

8. 10. Reversing the door hang

9. 11. Replacing the decorative door panel

10. 12. Customer service

.13. Putting into operation, technical data

.13.1. Connecting to electrical mains

11. 14. Environmental protection information

12. 15. Recycling

7. Ventilation grills, if used, must have

3. Cleaning

Clean the refrigerator thoroughly at intervals, as

necessary. Remove the shelves; these parts, as well as the cabinet interior and the door should be

washed with a warm solution of sodium bi-carbonate. Finally wipe over with a cloth rinsed in warm

water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand

warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly

with a clean, damp cloth.

NEVER USE STRONG CHEMICALS OR ABRASIVE CLEANING MATERIALS ON ANY PART OF

THE CABINET.

4. Positioning the appliance

When first using this refrigerator please consider the following points:

ENSURE REFRIGERATOR IS LEVEL

a. THE PIPEWORK AT THE BACK GETS HOT IN USE

b. THE REFRIGERATOR HAS NO 'MOTOR' AND IS THEREFORE VIRTUALLY SILENT

c. ALLOW AT LEAST 3 HRS. FOR SIGNS OF

COOLING

During the refrigeration process, the appliance

gives off heat from the condenser (under the upper part of the rear cover) into the surrounding air.

The more ventilated the condenser is, the more effective the refrigeration will be.

The other condition for satisfactory operation is that the appliance is levelled. This could be checked

by placing a glass of water on top of the appliance.

It is important that the appliance is not directly exposed to radiated heat (sunlight, radiator, near an

oven, etc.).

4.1. Installation instructions

The refrigerator is equipped with an electrically heated absorption cooling unit which is virtually silent

in operation. The fridge is designed for free-standing installation, but can be built-in if the following

conditions are complied with to ensure satisfactory operation and maximum cooling efficiency.

IMPORTANT

Please follow the installation details below carefully Guarantee is valid for products installed

as described only.

1. 1. The refrigerator must be level both directions

2. 2. There should be 20 mm clearance to the wall

3. 3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 2-3)

4. 4. The ventilation duct must at least measure 105 mm x the width of the refrigerator

5. 5. Only the entire cooling unit must project into the duct as shown

6. 6. Air passing through the duct must not be preheated by any source of heat

Figure 2.

Figure 3.

The refrigerator can be fixed to the bottom of the furniture through its fixing feet using screws of an

appropiate length. (Fig. 4)

Figure 4.

During installation, please ensure the mains plug is accessible at all times.

5. Using the appliance

To start the refrigerator connect the plug to the socket outlet and switch on the socket. The cooling fins

should show signs of cooling after about 3 hours.

The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage

compartment.

for two hours in every 24 hours. The frost will melt and the defrost water will run through the drain tube

from the drip channel into an evaporating vessel located at the bottom rear of the refrigerator. (Fig 6)

The defrost water will evaporate automatically into the circulating air and the vessel will not need

emptying manually.

To switch off the unit, turn the thermostat knob

5.1. Temperature regulation

The usual setting required is in the region of 2 to 3 on the thermostat knob (Fig. 5), but this can vary

with conditions of load and installation. If it is found necessary to change the setting, the knob can be

turned to a higher symbol to give a lower temperature, or a lower symbol to givea higher temperature.

The effect of any adjustment can be checked by means of a thermometer when the refrigerator has

reached the new temperature after some hours.

Figure 5.

6. ICE CUBES

Fill the ice tray to 4/5 with drinking water, and place the ice tray on the ice-tray shelf. Wipe off any

excess water to prevent the ice tray from freezing to the surface.

To speed up the making of ice cubes, turn the thermostat to position 5 for a short while. Remember to

turn the dial to its normal setting when the ice cubes are frozen.

To remove the cubes from the ice tray, hold it under running water. The ice cubes can now be taken

out easily.

7. Useful suggestion

Do not overfill the appliance. If possible, always store pre-cooled food and/or drinks. It is advisable to

leave some space between the products in the cabinet to ensure efficient and even cooling. If the

shelves are packed too tightly there may be unacceptable temperature variations.

8. Defrosting, cleaning and maintenance

Frost will gradually form on the cooling surfaces and it must not be allowed to become too thick since

it restrict the cooling.

This frost-formation is kept back by the FUZZY LOGIC system built into the appliance by switching off

the unit "0", disconnect the refrigerator from the electricity supply and leave the cabinet door open.

After defrosting the cabinet interior should be wiped out with a clean, damp cloth.

Figure 6.

9. Changing the lightbulb (If available)

If the lightbulb needs changing, pull out the plug

and proceed as follows:

Press the metal reflector to one side and draw the

lamp covering backwards. Replace the bulb and

push the covering back into place.

A new 10-watt bulb can be obtained at any service

shop.

10. Reversing the door hang, (Fig. 7)

Lay the appliance on its back. Remove the 8

screws (1). Remove the door, together with the two

hinges (2), from the housing.

Remove the two cover caps (3) from the housing

and place them in the open hinge holes in the

housing. Place the bottom righthand hinge in the

top left of the door and the top righthand hinge in

the bottom left of the door and hang the door on its

hinges in the open cover cap holes in the housing.

Secure the hinges and cover caps with the 8

screws.

Check that the door closes easily and is sealed properly.

Figure 7.

11. Replacing the decorative

door panel, (Fig. 8-10)

Remove the two screws (1) from the upper hinge of

the door.

Pull the door together with the hinge away from the

housing and up off the lower hinge bolt (2-3).

Remove screws (4) and pull off the frame edge (5).

Slide the decorative panel (6) out of the door frame

and insert the new panel (7), so that the upper edge

of the panel runs exactly parallel to the upper edge of

the frame. A new panel can be inserted more easily

into the upper edge of the frame when the two corners

are cut off by approx. 5 x 5mm (8). Put the frame edge

(5) back in place and secure with screws.

Place the door on the lower hinge (9), slot the upper

hinge into the opening, press together with the door

against the housing and secure with the two screws

(11).

Figure8.

Andere Handbücher für MF20-60

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dometic Kühlschrank Handbücher

Dometic

Dometic EA3100 Bedienungsanleitung

Dometic

Dometic CRX Series Bedienungsanleitung

Dometic

Dometic Waeco MyFriedge MF-05 Bedienungsanleitung

Dometic

Dometic MF20-60 Bedienungsanleitung

Dometic

Dometic REFRIGERATION 10-Series Bedienungsanleitung

Dometic

Dometic 8 Series Bedienungsanleitung

Dometic

Dometic DE15F Bedienungsanleitung

Dometic

Dometic RM2301 Bedienungsanleitung

Dometic

Dometic A30S1 Bedienungsanleitung

Dometic

Dometic CDF-11 Bedienungsanleitung

Dometic

Dometic RM2191 Bedienungsanleitung

Dometic

Dometic RMSL8 Series Bedienungsanleitung

Dometic

Dometic RM2351 Handbuch

Dometic

Dometic RM2310 Handbuch

Dometic

Dometic RM 7401 Handbuch

Dometic

Dometic RM1300 Handbuch

Dometic

Dometic RML 8551 Bedienungsanleitung

Dometic

Dometic COOLMATIC CRP40 Bedienungsanleitung

Dometic

Dometic NRX Series Bedienungsanleitung

Dometic

Dometic 9 SERIES Bedienungsanleitung

Dometic

Dometic RM2612 Montageanleitung

Dometic

Dometic C18B Bedienungsanleitung

Dometic

Dometic CoolMatic CRX 50 Bedienungsanleitung

Dometic

Dometic 9 SERIES Bedienungsanleitung

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

Stengel

Stengel KU 1101 A++ Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Samsung

Samsung RF323TE Bedienungsanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung