Eaelec Studebaker US6 Bedienungsanleitung
Assembly Instructions For TT-Scale
Studebaker US6 2 ½ ton Cargo Truck
Page 1
Production of the US6 truck started in 1941
and over 200,000 were built during World War 2.
Over 150,000 were exported under the lend-lease
program mostly to Russia. The US military used
these trucks in the construction of the Burma Road
and in North America on the Alcan (Alaska) highway.
Parts Included in the kit:
A. 3D printed chassis.
B. 3D printed cab
C. 3D printed cargo bed
D. Decal
Required to complete the kit:
Paint - Flat black and flat army olive for US Army
(Testors 1165 or Tamiya XF49)
Paint - Flat black and flat army green for Red Army
(Humbrol 76 or Tamiya XF74)
Glue - Slow setting CA is best.
Tools Required:
1. X-acto knife with a sharp #11 blade.
2. #400 and #600 sandpaper.
www.eaelec.com
Made in Canada
WARNING: CHOKING HAZARD
Keep out of reach of small
children!
Note that these ARE NOT TOYS,
AND ARE NOT INTENDED FOR
USE BY CHILDREN UNDER
AGE OF 14. These products are
model railroad equipment and
accessories intended for use by
adults.
U.S.A.
4352931
U.S.A.
4352931
Decal
US6 Painting and Decal Placement for US Army
Decal
Decal
Olive
Olive
Olive
Olive
Olive
Olive
Olive
Olive
Olive
Decal
Top View
Left View
Right View
Decal
The 3D printing process requires a supporting frame during printing, see below left. The
printed part is cut from the frame using flush cutters and this sometimes leaves small bumps on the
part. Use a knife with a sharp new blade to cut away the bumps. When trimming bumps off the
wheels you should place the wheel on a flat surface as shown below on the right. Putting too much
stress on the wheel can cause the axle to break. For bumps on the cab body, sanding is
recommended.
Page 2
www.eaelec.com
When gluing the cab to chassis, front
of the cab should extend to red line
Final Assembly
?????????
????????? ?????????
UFE5176
UFE5176
X
V
?????????
US6 Painting and Decal Placement for Red Army
and Warsaw Pact
Decal
Decal
Green
Green
Green
Green
Green
Green
Green
Green Green
Red Army Warsaw Pact
Left View
Right View
After cleaning up the bumps, paint the both the cab and the cargo bed olive (or green for Red
Army) and the entire chassis flat black. Once these have dried paint the wheel hubs, fuel tank and
front bumper olive or green using a fine brush. Apply a coat of gloss to the cab, let dry and then
place the decals as show below.After the decals are completely dry, apply dullcoat to the cab.
When everything is dry, glue the cab and the cargo bed onto the chassis using CA glue. See
photo below for cab alignment.
Inhaltsverzeichnis
Andere Eaelec Spielzeug Handbücher
