EAW SMS3 Bedienungsanleitung

SMS3

Compact Two-Way Loudspeaker

INSTRUCTION MANUAL

2 – SMS3

SMS3 – 3

1. SAFETY INSTRUCTIONS

1.1. Read Instructions — Before connecting and using the equipment, please read this Instruction

Manual carefully and keep it for future reference.

1.2. HEED ALL WARNINGS — Always follow the precautions provided on this EAW Commercial

product and in the instruction manual.

1.3. Water and Humidity — Do not use this EAW Commercial product near water; for example, in the

vicinity of a bath tub or sink, in a damp cellar, near a swimming pool, etc.

1.4. Foreign Bodies and Liquids — Be careful not to allow any foreign bodies or liquids to get into this

EAW Commercial product.

1.5. Servicing — The user should never attempt to make any repairs on this EAW Commercial product

unless otherwise indicated in the instruction manual. All repairs should be made by qualied service

technicians.

1.6. Installation — Do not install this EAW Commercial product in any way that is not provided for in

the instruction manual.

1.7. Respect the Safety Standards — The entire sound system must be designed in compliance with

the current standards and laws regarding electrical systems.

1.8. Specications — When installing and using this EAW Commercial product, keep in mind the

technical specications indicated in the dedicated section of the manual.

1.9. Accessories — Install and use this EAW Commercial product only with the accessories specied

by the manufacturer or supplied with the product.

1.10. Hearing Loss — Exposure to high sound levels can cause permanent hearing loss. The sound

pressure level which leads to hearing loss varies considerably from one person to another, and depends

on the duration of exposure. The U.S. Government’s Occupational Safety and Health Administration

(OSHA) has established the maximum sound pressure levels that can be with stood without causing

damage, which are shown in the table below. According to the OSHA regulations, any exposure over

the maximum limits indicated in the table can reduce the hearing capacity of a person. To prevent

potentially dangerous exposure to high sound pressure levels, anyone subjected to such levels must

use suitable protection. When a EAW Commercial product capable of producing high sound levels is

being used, it is therefore necessary to wear ear plugs or protective earphones when the limits shown

in the table are exceeded.

Consult the specications provided in the instruction manual to know the maximum sound pressure

(SPL) the speaker is capable of producing.

repnoitaruD

)sruoh(yad

leveldnuoS

)ABd( elpmaxelacipyT

8 09 b

ulcllamsaniouD

6 2

4 59 n

iartyawbuS

3 7

2 0

01 cisumlacissalcduolyreV

5.1 201

1 5

01 teef05taevitomocoL

5.0 011

sselro52.0 511 trecnockcoratastraptseduoL

WARNING! This equipment has

been designed to be installed

by qualied professionals only!

There are many factors to be

considered when installing

professional sound reinforcement

systems, including mechanical

and electrical considerations, as

well as acoustic coverage and

performance. EAW Commercial

strongly recommends that this

equipment be installed only by

a professional sound installer or

contractor.

Part No. 0010158 Rev. C 08/04

2 – SMS3

SMS3 – 3

TABLE OF CONTENTS

1. SAFETY INSTRUCTIONS ............................................................................................................ 2

2. KEY FEATURES............................................................................................................................. 3

3. INTRODUCTION........................................................................................................................... 3

4. INSTALLATION............................................................................................................................. 4

5. REAR PANEL FEATURES AND CONTROLS .............................................................................. 4

6. CONNECTIONS ............................................................................................................................ 4

7. SPECIFICATIONS......................................................................................................................... 5

8. SERVICE INFORMATION ............................................................................................................ 6

9. WARRANTY.................................................................................................................................. 7

2. KEY FEATURES

• 4.75" high-efciency carbon ber woofer

• 0.5" mylar dome tweeter loaded by a 110° x 100° constant directivity horn

• Built-in, multi-tap constant voltage transformer

• Built-in, low-inductance passive crossover

• Lightweight, UV/weather resistant, high density polystyrene, trapezoidal

shaped enclosure for multiple applications and minimum visual intrusion

• Integrated mounting points for use with optional mounting hardware

• Articulated surface mount hardware

included

3. INTRODUCTION

The SMS3 and SMS3W are a compact two-way loudspeaker system designed for constant-

voltage. The 4.75” (120 mm) carbon ber woofer, in combination with a 0.5” (13 mm) mylar dome

tweeter mounted on a 110° x 100° constant directivity horn, provide natural, smooth sound

reproduction, ideal for use in business music systems and indoor/outdoor background music

applications. The passive crossover is designed to reduce heat dissipation and optimize the

power response of the loudspeaker. Connections are made to recessed, color-coded spring-loaded

terminals. The enclosure is constructed of high-density plastic, with M6 threaded inserts for use

with the optional mounting hardware, and includes a protective perforated steel grille.

4 – SMS3

SMS3 – 5

4. INSTALLATION

The special hexagonal shape of the cabinet makes it possible to

position the speaker in various ways, as shown in the gure. The

logo plate on the front protective grille can be rotated to adapt

it to the position of the speaker. The speaker body has four M6

threaded inserts, one each on the top and bottom and two on the

back, used for attaching accessories for installing the speaker in

different ways.

SMS3 (SMS3W) speakers are supplied with a black (white)

ball joint support for wall mounting.

WARNING: Consult a professional rigger or structural

engineer prior to suspending loudspeakers from a

structure not intended for that use. Always know the

working load limit of the structure supporting

the loudspeaker array. Always make sure

that the rigging hardware minimum rating is

at least ve times the actual load.

5. REAR PANEL FEATURES

AND CONTROLS

This rotary control selects the power tap for the internal

constant voltage transformer. Choices are 1W, 2.5W, 5W,

10W, 20W, and BYPASS (used for 4 ohm operation).

2. This rotary control selects the constant voltage

distributed system in which the speaker is used.

Choices are BYPASS (used for 4 ohm operation), 0 (Off), 25V, 50V, 70V and 100V.

Note: Use a slot-head screwdriver to adjust the rotary controls.

6. CONNECTIONS

The spring-loaded speaker terminals are designed to accept

bare wire, up to a maximum of 18 gauge. Strip 1/4’’ (6 mm)

of insulation off the end of the speaker wire, press in the tab,

and insert the bare wire into the hole. When you release the

tab, the wire is locked in place. Make sure there are no stray

strands of wire outside the terminal connection.

WARNING: To prevent the risk of electrical shock,

always fit the protective cover over the terminals after completing the connections.

SMS3

Ω



Ω







 

 

 





4 – SMS3

SMS3 – 5

7. SPECIFICATIONS

SYSTEM

Freq. Range (–10 dB): 100 Hz–20 kHz

Freq. Response (–3 dB): 150 Hz–20 kHz

Horz. Coverage Angle (–6 dB): 100° averaged 800 Hz to 16 kHz

Vert. Coverage Angle (–6 dB): 110° averaged 800 Hz to 16 kHz

System Sensitivity1: 88 dB, 1W @ 1m

Rated Maximum SPL: 105 dB, @ 1m

System Nominal Impedance: 4Ω (bypassed)

System Input Power Rating2

Applicable Power: 30W rms (bypassed)

Musical Power: 60W rms (0.5 sec ON, 0.5 sec OFF, bypassed)

Peak Power: 90W rms (30W rms + 4.5 dB crest factor, bypassed)

Constant Voltage: 25V, 50V, 70V, 100V

Power Taps: 1W, 2.5W, 5W, 10W, 20W

Crossover: 3.0 kHz

TRANSDUCERS

Low-Frequency: 4.75 in/120 mm carbon ber woofer

High-Frequency: 0.5 in/13 mm mylar dome tweeter

PHYSICAL

Enclosure: 45° back angles, high density polystyrene

Attachment Inserts: Four points M6 threaded, two on back, one on top, and one on bottom

Mounting Hardware: Wall-mount ball-joint support bracket

Color: Matte black (SMS3) or white (SMS3W), scratch resistant paint

Grille: Matching perforated steel grille

Input Connectors: Spring-loaded terminals

Dimensions (HxWxD): 8.50 in/216 mm x 6.06 in/154 mm x 5.35 in/136 mm

Net Weight: 4.9 lb/2.2 kg

1) Measured on axis in the far eld with 1 watt (2.00 V rms @ 4 ohms) input and referenced to 1 meter distance using the inverse square law. Listed

sound pressure represents an average from 300 Hz to 3 kHz.

2) The specications provide three power values, which are determined by submitting the speaker to a series of laboratory tests lasting two hours

each. In the test for Applicable Power, pink noise is applied in the operating range of the speaker, and the signal is ltered at the ends of the band

with a 12 dB/octave slope. The applicable power value indicated is an rms value. The signal peaks present in the pink noise, adjusted according

to the type of speaker being tested (e.g., +4.5 dB with respect to the average level), are used for determining the Peak Power value. To identify the

Musical Power, the rms power value obtained in the rst test is doubled, applying it with impulses lasting 0.5 seconds (0.5 sec ON), and at an interval

of 0.5 second between one application and the next (0.5 sec OFF). For all the tests, the maximum power that the speaker can withstand without sus-

taining permanent damage is assumed as the power value.

6 – SMS3

SMS3 – 7

Disclaimer

EAW Commercial continually engages in research related to product improvement, new materials,

and production methods. Design renements are introduced into existing products without notice

as a routine expression of that philosophy. For this reason, any current EAW Commercial product

may differ in some respect from its published description, but will always equal or exceed the

original design specications unless otherwise stated.

“EAW Commercial” is a trademark of LOUD Technologies Inc.

All other brand names mentioned are trademarks or registered trademarks of their respective

holders, and are hereby acknowledged.

8. SERVICE INFORMATION

In the event that your SMS3 or SMS3W should require servicing, please follow these instructions:

1. Call EAW Commercial Tech Support at 1-888-337-7404, 7 am to 5 pm PST (Monday-Friday),

to verify the problem and obtain a Return Authorization (RA) Number. Be sure to have the

serial number of the unit when you call. You must have a Return Authorization Number in

order to obtain warranty service at the factory or at an authorized service center. You can also

email EAW Commercial Tech Support at: [email protected]

2. Pack the unit in its original packaging. THIS IS VERY IMPORTANT. EAW Commercial is not

responsible for any damage that occurs during shipping due to non-conventional packaging.

Original packaging helps to minimize the possibility of shipping damage.

3. Include a legible note stating your name, (no P.O. boxes), daytime phone number, Return

Authorization Number, and a detailed description of the problem, including how we can

duplicate it.

4. Write the Return Authorization Number in BIG BOLD PRINT on the top of the box.

5. Tech Support will tell you where to ship the unit when you call for an RA Number. We suggest

insurance for all forms of cartage.

6 – SMS3

SMS3 – 7

9. WARRANTY

Warranty: LOUD Technologies Inc. requires its authorized EAW Commercial distributors to abide

by the following warranty terms for all EAW Commercial brand products (all dates are from the

date of delivery from an Authorized EAW Commercial Distributor to the end user/installation site):

Loudspeakers – 5 years; Active Electronics – 5 years; Accessories – 2 years.

What Is Covered: Defects in workmanship and materials and against malfunctions. EAW

Commercial distributors must remedy all such defects and malfunctions without charge for parts

or labor if the warranty applies. Final determination of warranty coverage lies solely with each

authorized EAW Commercial distributor.

What Is Not Covered: This warranty does not extend to damage or malfunctions resulting from,

but not limited to, shipment, improper installation, misuse, neglect, abuse, normal wear, accident,

or to any product on which the serial number has been modied or removed. Exterior defects in or

damage to the exterior appearance are specically excluded from this warranty. EAW Commercial

distributors shall not be liable for incidental or consequential damages resulting from the use

of EAW Commercial products. Repairs and/or modications by other than an Authorized EAW

Commercial Distributor automatically voids this warranty.

EAW Commercial | One Main Street | Whitinsville, MA 01588 USA

TEL toll free within US/Canada 888.337.7404 | TEL outside US 425.892.6503 | FAX 425.485.1152

www.eawcommercial.com

Inhaltsverzeichnis

Andere EAW Sprecher Handbücher

Beliebte Sprecher Handbücher anderer Marken

argon audio

argon audio IE20 Bedienungsanleitung

Denon

Denon SC-N7 Bedienungsanleitung

Gemline

Gemline Ace 3952 Bedienungsanleitung

Focal

Focal ON WALL 300 Bedienungsanleitung

HEADRUSH

HEADRUSH Maximus HRSP 5024 Bedienungsanleitung

SoundLogic

SoundLogic BCCS-6/6395 Bedienungsanleitung

Peavey

Peavey DTH 218 Bedienungsanleitung

Avantree

Avantree Pluto Air Bedienungsanleitung

Morel

Morel Integra Series INTEGRA OVATION 4 Bedienungsanleitung

Oppo

Oppo SONICA Bedienungsanleitung

Bose

Bose SoundLink Wireless Music System Bedienungsanleitung

Rocksteady

Rocksteady Stadium Bedienungsanleitung

Bowers & Wilkins

Bowers & Wilkins 4 Bedienungsanleitung

Sonance

Sonance SONOS OUTDOOR Series Bedienungsanleitung

Electro-Voice

Electro-Voice EVID FM4.2 Bedienungsanleitung

Pioneer

Pioneer XW-HTD630 Bedienungsanleitung

Onn

Onn BWA16AA002 Bedienungsanleitung

HP GL313AA - USB Speakers PC Multimedia Bedienungsanleitung