Edelbrock 47493 Bedienungsanleitung

Catalog #47492, #47493 Page 1 of 2 Brochure #63-47492

Rev. 5/06 - DA/mc

Edelbrock Header

For 2000-2004 PT Cruiser

Catalog #47492 & #47493

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Header. If you have any questions, please contact our

Technical Hotline at : 1-800-416-8628 from 7 am - 5pm, Monday-Friday, Pacific Standard Time or e-mail us at

[email protected]. Please fill out and mail your warranty card.

Suggested Tools Needed for Installation:

❑ Metric wrench set, metric sockets, and ratchet

❑ Screwdrivers

❑Floorjack and Jackstands

SPECIAL NOTICE: This Edelbrock part has received an Executive Order number (E.O.#) from the California Air Resources

Board (C.A.R.B.) making it legal for street use in all 50 states. To assist you with emission equipment certification, we

have included a silver fan shroud decal to help testing personnel verify the this part is a legal replacement on the vehicle

for which it is cataloged. The adhesive-backed decal should be affixed next to the existing emission and engine

specifications decal. Do not cover any part of your original emission decal.

WARNING: The use of "Thermal Wrap" will void the warranty on your Edelbrock Headers. Those product will cause

excessive heat and moisture buildup resulting in corrosion and failure of the header.

Qty.Part # Description

❑1 25-9213 Header (#47492)

❑1 25-9300 Header (#47493)

❑1 54-4749 Port Gasket

❑1 54-4750 Collector Gaskets

❑3 60-4749 8mm x 1.25 Lock Nut

❑4 60-7275 5/16-18 Hex Nuts

❑10 68-0350 8mm x 30mm Hex Bolts

KIT CONTENTS

Catalog #47492 (Ceramic-Coated)

Catalog #47493 (Ti-Tech Coated)

Qty.Part # Description

❑1 68-4749 10 x 1.50 x 12mm Hex Bolt

❑4 68-6010 5/16-18 x 1 1/2” Hex Bolt

❑1 78-2004 Tie Wrap

❑1 79-9722 Heat Shield

❑7 82-8721 5/16 Hardened Washers

❑14 82-4620 Lock Washers

❑1 82-8722 Flat Washer

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Catalog #47492, #47493 Page 2 of 2 Brochure #63-47492

Rev. 5/06 - DA/mc

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: 1-800-416-8628

E-Mail: [email protected]

ASSEMBLY

1. Place the supplied port gasket over the studs (if

equipped) on the cylinder head. Install the Edelbrock

Header on the studs (if equipped) using the provided

8mm bolts, and lock washers on all bolts. Use

supplied lock nuts and hardened washers on the

studs (if equipped). Tighten all flange bolts and nuts

at this time.

2. Re-install the catalytic converter to the hangers.

Using the supplied 5/16 bolts, nuts, lock washers,

and hardened flat washers and gaskets, attach the

catalytic converter to the header collector flange.

Note: (The lower bolt of the collector is used to

secure the supplied heat shield). Using supplied

10mm bolt and washer, attach the heatshield to the

block just above the oil pan rail.

3. Check all hydraulic, vacuum, water, and fuel lines to

ensure there is adequate clearance from the header.

Using anti-seize on threads, install O2 sensor and re-

connect plug.

4. Re-connect the battery.

5. At this point, it is a good idea to check everything

over to make sure nothing was missed during

assembly.

6. Start vehicle and bring vehicle up to operating

temperature. Check for leaks of any kind.

7. Turn off engine and let cool. Tighten all the bolts

again.

DISASSEMBLY

1. Raise and support the vehicle on a flat stable surface

using the floorjack and proper load rated jackstands.

2. Disconnect the battery.

3. Remove nut and bolts retaining heatshield and remove

heatshields.

4. Remove four nuts that retain catalytic converter to the

stock manifold.

5. Unplug and unclip oxygen sensor wire located above

the catalytic converter.

6. Remove the clamp retaining the catalytic converter

pipe to the intermediate pipe and unhook the catalytic

pipe brackets from the hangers. Remove catalytic

converter.

7. Unbolt and remove the stock manifold and gasket.

INSTALLATION INSTRUCTIONS

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock Torker-Plus 265-400 Bedienungsanleitung

Edelbrock

Edelbrock E-Street 2 Bedienungsanleitung

Edelbrock

Edelbrock 68792 Bedienungsanleitung

Edelbrock

Edelbrock SBC Vortec 283-400 c.i.d. Chevy V8 Bedienungsanleitung

Edelbrock

Edelbrock Victor Jr. 70067 Bedienungsanleitung

Edelbrock

Edelbrock 440 Bedienungsanleitung

Edelbrock

Edelbrock 70206 Bedienungsanleitung

Edelbrock

Edelbrock 5061 Bedienungsanleitung

Edelbrock

Edelbrock 90 V6 200 Bedienungsanleitung

Edelbrock

Edelbrock 770769 Bedienungsanleitung

Edelbrock

Edelbrock 72176 Bedienungsanleitung

Edelbrock

Edelbrock 5761 Bedienungsanleitung

Edelbrock

Edelbrock 66792 Bedienungsanleitung

Edelbrock

Edelbrock 5724 Bedienungsanleitung

Edelbrock

Edelbrock 2475 Bedienungsanleitung

Edelbrock

Edelbrock Russell 694300 Bedienungsanleitung

Edelbrock

Edelbrock 4700 Bedienungsanleitung

Edelbrock

Edelbrock 65003 Bedienungsanleitung

Edelbrock

Edelbrock Performer 2261 Bedienungsanleitung

Edelbrock

Edelbrock 28385 Bedienungsanleitung

Edelbrock

Edelbrock 3637 Bedienungsanleitung

Edelbrock

Edelbrock 66662 Bedienungsanleitung

Edelbrock

Edelbrock 1100 Bedienungsanleitung

Edelbrock

Edelbrock 4462 Handbuch

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung