Edelbrock 5275 Bedienungsanleitung

Brochure No. 63-0440 Page 1of 2 Catalog #5275

Rev. 8/05 - DA/mc

EDELBROCK LOWER TRAILING ARMS RELOCATION BRACKETS

for 1982-2002 Camaro / Firebird

Catalog #5275

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new trailing arms relocation brackets. If you have any

questions, please contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday,

Pacific Standard Time or e-mail us at [email protected]. Please fill out and mail your warranty card.

Application: Designed for 1982-2002 Camaro/Firebird vehicles. These trailing arm relocation brackets are designed to

correct the rear suspension trailing arm angle on vehicles that have been lowered.

Suggested Tools for Installation:

❑Jack and proper load rated jackstands ❑Blue Locktite

❑Tire chocks ❑Torque wrench

❑Lug wrench ❑Grease gun

❑18mm socket and combination wrench ❑Mig welder

❑Hand grinder

REMOVAL OF STOCK TRAILING ARMS

1. Place vehicle on level surface and place tire

chocks in front of and behind front tires.

2. Support rear of the vehicle on the jackstands

and remove the rear wheels (See Figure. 1).

3. Placeafloorjackunderthedifferentialandliftup

slightly to remove tension from the trailing arm

bolts. Make sure not to lift the vehicle off the

jackstands (See Figure 1).

NOTE: Keep floorjack under vehicle during

the complete removal and installation

procedure.

CAUTION: Do not remove both trailing arms

at the same time or the axle will rotate and

the trailing arm installation will be much

more difficult.

4. Remove rear bolt of trailing arm and rotate arm

out of the way (See Figure 2).

5. Using the relocation bracket as a reference,

clean the surface of the stock lower trailing arm

mount bracket for welding.

Fig. 1

Fig. 2

Brochure No. 63-0440 Page 2of 2 Catalog #5275

Rev. 8/05 - DA/mc

NOTES:

a. The parking brake cable retaining bracket

on later model cars will need to be modified

(See Figure 3).

Fig. 3

b. The spacer sleeves in this kit are used to go

between the factory lower arm brackets in

the OE arm location. Using the supplied

bolts in stock arm location along with nuts

and thick hardened washers, install the

relocation bracket onto the stock lower

trailing arm bracket. Relocation bracket

should sit tight against the stock bracket for

proper welding (torque bolts to 70 ft./lbs.).

6. Using the supplied bolts, nuts, spacer sleeve,

and thick washers, attach the lower trailing arm

to the relocation bracket. Snug but do not

torque at this time.

Kit Contents

Qty. Part # Description

❑125-4070 Left Relocating Bracket

❑125-4071 Right Relocating Bracket

❑ 122-5275 Installation Kit

Edelbrock Corporation, 2700 California Street, Torrance, CA 90503

Toll-Free Tech Line: 1-800-416-8628

Tech E-Mail: [email protected]

7. Make several tack welds around edges of

relocation bracket. Remove the lower arm from

relocation bracket and stitch weld around edges

of relocation bracket.

NOTE: Welding should be done by an

experienced welder.

8. After welding is complete, paint bracket and

welded area to keep from rusting. Re-install the

lower arm into the relocation bracket using

Locktite on threads (torque to 70 ft./lbs.) and

repeat steps 4-8 on other side of vehicle.

NOTE: It is highly recommended that you run

Edelbrock tubular lower control arms part

#5274. Stock arms tend to flex and twist under

hard acceleration and aggressive cornering.

Check out other Edelbrock suspension upgrades

for your 1982-2002 Camaro or Firebird.

Inhaltsverzeichnis

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock Performer RPM 60219 Bedienungsanleitung

Edelbrock

Edelbrock 3844 (65mm) Bedienungsanleitung

Edelbrock

Edelbrock 4771 Bedienungsanleitung

Edelbrock

Edelbrock 2001 PT Cruiser Bedienungsanleitung

Edelbrock

Edelbrock 5292 Bedienungsanleitung

Edelbrock

Edelbrock 1926 Bedienungsanleitung

Edelbrock

Edelbrock VICTOR 8841 Gebrauchsanweisung

Edelbrock

Edelbrock 66082 Bedienungsanleitung

Edelbrock

Edelbrock 3847/3 Bedienungsanleitung

Edelbrock

Edelbrock 15018 Bedienungsanleitung

Edelbrock

Edelbrock 2860 Bedienungsanleitung

Edelbrock

Edelbrock 7892 Bedienungsanleitung

Edelbrock

Edelbrock 15015 Bedienungsanleitung

Edelbrock

Edelbrock 15005 Bedienungsanleitung

Edelbrock

Edelbrock Performer 70011 Technisches Handbuch

Edelbrock

Edelbrock 1997 Bedienungsanleitung

Edelbrock

Edelbrock 47480 Bedienungsanleitung

Edelbrock

Edelbrock 8135 Bedienungsanleitung

Edelbrock

Edelbrock 5683 Bedienungsanleitung

Edelbrock

Edelbrock 6502 Bedienungsanleitung

Edelbrock

Edelbrock 6571 Bedienungsanleitung

Edelbrock

Edelbrock 66042 Bedienungsanleitung

Edelbrock

Edelbrock Intake Manifolds Anwendungshandbuch

Edelbrock

Edelbrock 68982 Bedienungsanleitung

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung