Edelbrock 2001 PT Cruiser Bedienungsanleitung

Edelbrock Cat-back Exhaust Systems

Catalog #5759

Application: 2001 PT Cruiser

Please study these instructions carefully before installing your new Cat-

questions or problems, please contact our Technical Hotline at : 1-800-416-–

through Friday, Pacific Standard Time.

Installation of this system will require the relocation of the spare tire. The spare tire can be placed in the rear

area of the vehicle on the floor with the adjustable shelf in its lowest position covering the spare.

Suggested tools needed fo

•15 mm & 9/16” deep socket and ratchet

•Floor jack & jack stands

•Penetrating oil

•Punch and hammer

•Tin snipes

•Half round file

•Grease pencil and masking tape

DISASSEMBLY

1. Raise rear of vehicle on smooth flat stable surface and support using jack stands.

2. Remove spare tire and spare

3. Use penetrating oil on clamp that attaches front I-pipe to over axle pipe. Loosen stock clamp. Carefully

bber hangers off of the stock exhaust system (these will be reused) , these hangers are all that

e, so use caution. Remove OEM system at this time.

4. Unbolt front muffler hanger from floor pan (this will be reused in anoth

1. Find the exact center of the vehicle and mark it on the valance below the license plate location. The

o find the center of the vehicle is to find the center of the license plate opening.

2. Cut out supplied template and tape to valance panel using lower edge of the bumper as a guide, starting

at the center line of the vehicle and working to the right side

3. Mark the opening in the template for the exhaust tip and carefully remove the template. Visually check the

tip cut out mark for being symmetrical, remember measure twice cut once! Carefully cut out the marked

it is best to cut to the inside of the marked line and then file or sand to the

cutting is also the bumper cover and will be very

4. Place supplied over axle pipe stamped #25- -pipe with supplied 2 ¼ u-

tighten clamp at this time.

5. -clamps on to muffler crossover inle -3179 and install pipe into over axle pipe

only snug one of the 2 ¼ clamp at the slip connection.

6. Install the 2 ½ clamp on to muffler inlet pipe. Slide muffler on to the muffler crossover pipe, support and

tilt the muffler approximately 60° (se

7. Install supplied hanger strap to the spare tire rack support tab on the right side of the vehicle, using the

supplied 5/16” bolt, washers, and nut. Slip the hanger strap clamp end under the unused 2 ¼ clamp on

; this strap is used to align the system laterally in the vehicle. Hanger strap

Qty. Part No. Description Qty. Part No. Description

125-5519 Muffler 125-3180 Tailpipe

125-3178 Over axle pipe 125-3181 Tailpipe

125-3179 Muffler crossover pipe 122-5759 Instruction kit

123-4038 Hanger clamp assembly

PARTS LIST

WARNING: Exhaust gas contains carbon monoxide, a deadly invisible gas. Correct any leaks

ASSEMBLY (Continued)

8. Place clamp hanger assembly #23-4038 on to the left muffler outlet and slip hanger bar into the rear OEM

rubber hanger, slide left tail pipe in to the muffler outlet. Long arm of hanger goes toward rear of vehicle.

over right muffler outlet and install right tailpipe. Position the system in the cut outs in the

9. Slide OEM hanger assembly removed earlier on to the left tailpipe hanger assembly (see figure 2). Punch

holes for sheet metal screws and screw in the OEM hanger assembly with OEM sheet metal screws. Hole

an drilled so as to reduce chance that screws will work loose.

10. Centering of the whole system can be done at both the over axle and the muffler crossover pipe. Center

tailpipes in the cut outs in the valance, using the hanger strap on the right side in fr

adjust so tailpipes extend equally on both sides. Height and amount of total extension for the tailpipes can

be adjusted by tilting the muffler. When system has been adjusted for position, check system for

sion, brake lines, fuel lines, and floor pan. When system is positioned

11. Open up ground strap eyelet end to 3/8 diameter and using supplied 3/8 nut. Install onto hanger clamp

Edelbrock Corporation

2700 California St.

Torrance, CA 90503

Tech Line: (800) 416-8628

E-Mail: [email protected]

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock 72285 Bedienungsanleitung

Edelbrock

Edelbrock 60469 Bedienungsanleitung

Edelbrock

Edelbrock 5247 Bedienungsanleitung

Edelbrock

Edelbrock 65022 Bedienungsanleitung

Edelbrock

Edelbrock 60179 Gebrauchsanweisung

Edelbrock

Edelbrock Axle-Back Exhaust Systems 5773 Bedienungsanleitung

Edelbrock

Edelbrock 351-M/400 Bedienungsanleitung

Edelbrock

Edelbrock 8192 Bedienungsanleitung

Edelbrock

Edelbrock 5694 (Stainless Steel) Bedienungsanleitung

Edelbrock

Edelbrock 4462 Handbuch

Edelbrock

Edelbrock 2121 Bedienungsanleitung

Edelbrock

Edelbrock 5787 Bedienungsanleitung

Edelbrock

Edelbrock 2 & 4 W/D Bedienungsanleitung

Edelbrock

Edelbrock PERFORMER-PLUS 2167 Bedienungsanleitung

Edelbrock

Edelbrock 15018 Bedienungsanleitung

Edelbrock

Edelbrock 7880 Bedienungsanleitung

Edelbrock

Edelbrock 65102 Bedienungsanleitung

Edelbrock

Edelbrock Nitrous System 63-71940 Bedienungsanleitung

Edelbrock

Edelbrock Russell 641550 Bedienungsanleitung

Edelbrock

Edelbrock 5253 Bedienungsanleitung

Edelbrock

Edelbrock 1483 Bedienungsanleitung

Edelbrock

Edelbrock 3637 Bedienungsanleitung

Edelbrock

Edelbrock 6601 Bedienungsanleitung

Edelbrock

Edelbrock Intake Manifolds Anwendungshandbuch

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung