Ekwb EK-FC1080 GTX JetStream Backplate Leitfaden

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 25th of August, 2016.

Installation and mounting manual for EK-FC1080 GTX JetStream Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of Palit GeForce GTX 1080 JetStream graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC1080 GTX JetStream Backplate is very easy to install. First install EK-FC1080 GTX JetStream series water block according to its installation manual. If

you have it already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be removed.

Please remove the six (5) M2.5x4 AX1 screws and their PVC washers as well (marked with arrow).

STEP 3: APPLYING THE THERMAL PADS

EK-FC1080 GTX JetStream Backplate features passive cooling of the printed circuit board and its components therefore it is mandatory to install the

enclosed thermal pad. Please install enclosed 1mm thick thermal pad (Thermal Pad F –1,0mm (120x16) as shown on the picture below. You

may need to trim the excess thermal pad.

Thermal PAD F - 1mm (120x16mm)

EK-FC1080 GTX G1 Backplate

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 25th of August, 2016.

STEP 4: ATTACHING EK-FC1080 GTX JetStream BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. Use five (5) M2.5x7 AX1 screws, and tighten them using Philips head screwdriver.

Use one (1) M2.5x4 AX1 screw and PVC washer and tighten it using Philips head screwdriver on the other side of backplate (2nd picture on the right side).

HINT: Do not tighten screws until they are all positioned in their mounting holes. The backplate has milled in standoffs, so there is no fear of over tightening of

the screws. Nevertheless, do not exaggerate with screwing force as there is no need for it.

By all means users must also consider that this product is intended to be used only with EK-FC1080 GTX JetStream series water blocks. No other 3rd party heat

sinks or coolers are officially supported! EK does not offer any assistance or support in the latter application.

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24-hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the

top of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial

possible, EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water

Blocks cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling

products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased;

(II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or

used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other

than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not

affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

Philips head screwdriver scissors

M2.5x7 AX1

Plastic washer

M2.5x4 AX1

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-FC460 GS/SONIC Handbuch

ekwb

ekwb EK-FB GA X299 GAMING Monoblock Bedienungsanleitung

ekwb

ekwb EK-FB ASUS C6H Monoblock Bedienungsanleitung

ekwb

ekwb EK-FB GA AX370 Gaming RGB Monoblock Bedienungsanleitung

ekwb

ekwb EK-Quantum Reflection2 PC-O11D EVO D5 PWM... Bedienungsanleitung

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Bedienungsanleitung

ekwb

ekwb EK-Annihilator Pro ILM Series Bedienungsanleitung

ekwb

ekwb EK-FC780 GTX Ti Matrix Handbuch

ekwb

ekwb EK-XRES DCP 4.0 Handbuch

ekwb

ekwb EK-Quantum Vector RE RTX 3080 Active Backplate... Bedienungsanleitung

ekwb

ekwb Velocity - AMD Bedienungsanleitung

ekwb

ekwb EK-Classic 115x/20xx D-RGB Bedienungsanleitung

ekwb

ekwb EK-FC980 Handbuch

ekwb

ekwb EK-FB KIT ASUS R5-E10 Leitfaden

ekwb

ekwb EK-FB KIT ASUS R5E Leitfaden

ekwb

ekwb EK-FC R9-390X TF5 Leitfaden

ekwb

ekwb D-RGB Bedienungsanleitung

ekwb

ekwb EK-FB GA AMD KIT Handbuch

ekwb

ekwb EK-Pro Bedienungsanleitung

ekwb

ekwb EK-PRO GPU WB AMP-Trinity RTX 4090 Ni+Inox Bedienungsanleitung

ekwb

ekwb EK-FC5x0 GW GTX water block Handbuch

ekwb

ekwb EK-FB ASUS Maximus XI HERO Bedienungsanleitung

ekwb

ekwb EK-FB ASUS PRIME X299 RGB Monoblock Bedienungsanleitung

ekwb

ekwb Velocity Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

ekwb EK-FC1080 GTX JetStream Backplate Leitfaden

Beliebte Computerhardware Handbücher anderer Marken