Ekwb EK-FC1080 GTX Ti FTW3 Backplate Leitfaden

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 26th of June, 2017.

Installation and mounting manual for EK-FC1080 GTX Ti FTW3

Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of EVGA GeForce GTX 1080 Ti FTW3 graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC1080 GTX Ti FTW3 Backplate is very easy to install. First install EK-FC1080 GTX Ti FTW3 series water block according to its installation manual. If you

have it already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be removed. Please

remove the five (5) M2.5x4 AX1 screws and their PVC washers as well (marked with arrow).

STEP 3: APPLYING THE THERMAL PADS

EK-FC1080 GTX Ti FTW3 Backplate features passive cooling of the printed circuit board and its components therefore it is mandatory to install the

enclosed thermal pad. Please install enclosed 1mm thick thermal pad (Thermal Pad F –1,0mm (120x16) and (Thermal Pad G –1,0mm (120x24)

as shown on the picture below. You may need to trim the excess thermal pad.

Thermal PAD F - 1mm (120x16mm)

EK-FC1080 GTX Ti FTW3 Backplate

Thermal PAD G - 1mm (120x24mm)

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 26th of June, 2017.

STEP 4: ATTACHING EK-FC1080 GTX Ti FTW3 BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. Use five (5) M2.5x7 AX1 screws on top and one (1) M2.5x4 AX1 screw with PVC

Washer on the back. Tighten them using Philips head screwdriver.

HINT: Do not tighten screws until they are all positioned in their mounting holes. The backplate has milled in standoffs, so there is no fear of over tightening of

the screws. Nevertheless do not exaggerate with screwing force as there is no need for it.

By all means users must also consider that this product is intended to be used only with EK-FC1080 GTX Ti FTW3 series water blocks. No other 3rd party heat

sinks or coolers are officially supported! EK does not offer any assistance or support in the latter application.

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased;

(II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or

used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other

than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not

affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

Philips head screwdriver scissors

M2.5x7 AX1

M2.5x4 AX1

PVC Washer

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-FC7990 Handbuch

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Bedienungsanleitung

ekwb

ekwb EK-FB MSI X299 GAMING PRO CARBON RGB... Bedienungsanleitung

ekwb

ekwb EK-FC 5870 MSI Handbuch

ekwb

ekwb EK-FB GA AMD KIT Handbuch

ekwb

ekwb EK-FC WX9100 PRO BACKPLATE Bedienungsanleitung

ekwb

ekwb EK-FB GA Z87X-OC Force Leitfaden

ekwb

ekwb EK-FB ASRock X399 RGB Monoblock Bedienungsanleitung

ekwb

ekwb EK-MOSFET ASUS M6G Leitfaden

ekwb

ekwb EK-PRO GPU WB AMP/Trinity RTX 4090 - Ni +... Bedienungsanleitung

ekwb

ekwb EK-FC480 GTX Handbuch

ekwb

ekwb EK Bedienungsanleitung

ekwb

ekwb EK-FCW8100 Leitfaden

ekwb

ekwb Velocity - AMD Bedienungsanleitung

ekwb

ekwb R9-290X Series Leitfaden

ekwb

ekwb EK-FB MSI X399 GAMING RGB Monoblock Bedienungsanleitung

ekwb

ekwb EK-Pro AM5 Series Bedienungsanleitung

ekwb

ekwb EK-FC7970 Handbuch

ekwb

ekwb Velocity-AMD Bedienungsanleitung

ekwb

ekwb EK-Vardar X3M 120ER Bedienungsanleitung

ekwb

ekwb EK-FC1080 GTX FTW2 Bedienungsanleitung

ekwb

ekwb EK-Thermosphere Leitfaden

ekwb

ekwb 3831109831618 Leitfaden

ekwb

ekwb EK-FB KIT GA X58 (UD7) Handbuch

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

ekwb EK-FC1080 GTX Ti FTW3 Backplate Leitfaden

Beliebte Computerhardware Handbücher anderer Marken