Ekwb EK-FC980 GTX Leitfaden

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.1. Released on 24th of January, 2015.

Installation and mounting manual for EK-FC980 GTX

Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of nVidia GeForce 980 GTX graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC980 GTX Backplate is very easy to install. First install EK-FC980 GTX series water block according to its installation manual. If you have it

already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be removed. Screws

with marked with red arrow need to be remove and replace with four (4) M2.5x4 DIN7985. Please remove the seven (7) screws marked with white

arrow screws.

STEP 3: APPLYING THE THERMAL PADS

EK-FC980 GTX Backplate features passive cooling of the printed circuit board and its components therefore it is mandatory to install the enclosed

thermal pad. Please install enclosed 1mm thick thermal pad (Thermal Pad A –1,0mm (100x16)) as shown on the picture below. You may need to

trim the excess thermal pad. Trim 1mm Thermal Pad to fit hole.

Thermal PAD A 1,0mm

EK-FC980 GTX

Backplate

M2.5x4 DIN 7991 screw

PVC WASHER

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.1. Released on 24th of January, 2015.

STEP 4: ATTACHING EK-FC980 GTX BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below (some screws are in block mounting). EKWB recommends users to start

with six (6) M2.5x6 DIN 7985 (HINT: do not tighten screws until they are all positioned in their mounting holes) in the middle of the card and then

continue outwards. The backplate has milled in standoffs, so there is no fear of over tightening of the screws. Nevertheless do not exaggerate with

screwing force as there is no need for it.

(By all means users must also consider that this product is intended to be used only with EK-FC980 GTX series wat er blocks. No other 3rd party

heat sinks or coolers are supported!)

EKWB short top versions: ACETAL, CSQ TOP-s:

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was

purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled

carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer

rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and

does not affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper

liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

Philips head screwdriver scissors

M2.5X6 DIN 7985 screw

M2.5x8 DIN 7985 screw

PVC WASHER

M2.5 NUT

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-Pro CPU Water Block SP5 Bedienungsanleitung

ekwb

ekwb EK-FB ASUS PRIME X299 Monoblock Bedienungsanleitung

ekwb

ekwb Classic D-RGB S240 Bedienungsanleitung

ekwb

ekwb EK-TIM Indigo Extreme Bedienungsanleitung

ekwb

ekwb EK-FC Bedienungsanleitung

ekwb

ekwb EK-FC1070 GTX Bedienungsanleitung

ekwb

ekwb EK-FC790 Leitfaden

ekwb

ekwb EK-FB MSI X370 XPower Monoblock Bedienungsanleitung

ekwb

ekwb EK-FC7970 Lightning Handbuch

ekwb

ekwb EK-FC980 Handbuch

ekwb

ekwb EK-FC285 GTX Classified Handbuch

ekwb

ekwb EK-Quantum Reflection PC-O11D XL D5 PWM... Bedienungsanleitung

ekwb

ekwb EK-FB GA AX370 Gaming RGB Monoblock Bedienungsanleitung

ekwb

ekwb EK-FC WX9100 PRO BACKPLATE Bedienungsanleitung

ekwb

ekwb EK-FB ASUS Z270E Strix Monoblock Series Bedienungsanleitung

ekwb

ekwb EK-XLC PREDATOR 240 Bedienungsanleitung

ekwb

ekwb EK-FC580 DCII Handbuch

ekwb

ekwb EK-FC1080 GTX JetStream Backplate Leitfaden

ekwb

ekwb EK-FC Radeon Vega Strix Backplate Handbuch

ekwb

ekwb EK-Vector Radeon RX5700 + XT Backplate Bedienungsanleitung

ekwb

ekwb EK-FC1080 GTX FTW Leitfaden

ekwb

ekwb EK-Classic GPU Water BlockRTX 2080Ti D-RGB Bedienungsanleitung

ekwb

ekwb EK-Loop Fan FPT 120 FAN Bedienungsanleitung

ekwb

ekwb EK-Quantum Momentum Aorus Z490 Master D-RGB Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

ekwb EK-FC980 GTX Leitfaden

Beliebte Computerhardware Handbücher anderer Marken