Electro-Harmonix Nano Q-Tron Bedienungsanleitung

Congratulations on your purchase of the Nano Q-Tron envelope-controlled

lter! An envelope-controlled lter modulates an instrument’s tone based

on the musician’s dynamics and playing style. The loudness of your instru-

ment’s signal forms a volume envelope that directly sweeps the cutoff or

center frequency of the lter. In the Nano Q-Tron, three different lter

types are available: Lowpass, Bandpass and Highpass, all controllable with

variable Q and sensitivity knobs; yielding a wide range of tonal options.

Nano Envelope Filter

Operating Instructions

Connect your guitar to the INPUT jack on the Nano Q-Tron and the AMP

jack to your amp’s input. Apply power if needed; your Nano Q-Tron might

already have a 9V battery installed. Press the footswitch to ensure the

STATUS LED is lit, now your Nano Q-Tron is ready to go.

The Nano Q-Tron’s effect is controlled by the musician’s playing dynamics.

A stronger attack or louder note will yield a more dramatic effect, while

softer playing will produce more subtle effects. Use the full range of control

settings in combination with different playing techniques to obtain several

different and unique effects combinations.

TIP: You might nd that the DRIVE and Q controls work best when they are

in the middle of their range rather than maximized.

TIP: When you play a note into the Nano Q-Tron, its lter jumps up to a

high frequency and then the frequency slowly descends according to the

volume envelope of the notes you play. The louder your note, the higher

in frequency the lter jumps.

Controls and Connections

1. DRIVE Knob Sets the envelope sensitivity gain, which in turn controls

how wide the lter sweeps. The higher the DRIVE setting, the more the

lter reacts to your playing and the higher in frequency the lter will jump

when you play a note. Turn DRIVE clockwise for a wider lter sweep or

counterclockwise to reduce the sweep range. If you turn DRIVE up too far,

the lter sweep will max out at its highest frequency (approximately 3.5kHz)

and remain at the highest frequency until the note has fully decayed.

Louder instruments will typically use lower DRIVE settings while quieter

instruments require higher settings. When learning the Nano Q-Tron,

start with DRIVE at 12 o’clock.

- 2 -

- 3 -

2. MODE Rotary Switch (LP / BP / HP) Determines the frequency range

that the lter allows to pass through. LP (Lowpass) mode emphasizes low

frequencies, BP (Bandpass) middle frequencies and HP (Highpass) high

frequencies.

3. Q Knob Sets the bandwidth of the lter. As Q is turned clockwise, the

lter sounds more resonant or peakier, making the envelope effect more

dramatic. Low settings of Q yield a less intense lter curve. Start with Q

set to about 2 o’clock for a middle-of-the-road lter intensity.

4. VOL Knob Adjusts the overall volume at the OUTPUT jack. As VOL is

turned clockwise, the output level increases. Use VOL to match the effect

volume to your bypass volume or give the effect a volume boost.

5. FOOTSWITCH and STATUS LED The footswitch engages or bypasses the

effect. The Status LED lights when the effect is engaged. The LED is off in

bypass mode. The Nano Q-Tron employs True Bypass.

6. INPUT Jack Audio input to the Nano Q-Tron.

7. AMP Jack Audio output from the Nano Q-Tron. In bypass mode, the AMP

jack is directly connected to the INPUT jack.

8. 9V Power Jack An optional 9VDC, center-negative power supply can be

connected to the power jack to provide power without a battery. The Nano

Q-Tron requires 10mA at 9VDC on a center-negative plug. Do not exceed

12VDC at the power jack.

When using a 9V battery, plugging into the INPUT jack activates power.

The input cable should be removed when the unit is not in use to avoid

running down the battery.

To change the 9-volt battery, you must remove the 4 screws on the bottom

of the Nano Q-Tron. Once the screws are removed, you can take off the

bottom plate and change the battery. Please do not touch the circuit board

or adjust the trim pot while the bottom plate is off or you may damage a

component or set the lter sweep range to a non-ideal setting.

Notes and Specications

t Audio input impedance at INPUT jack: 330kΩ

t Audio output impedance at OUTPUT jack: 300Ω

t Current draw: 10mA

t Maximum input signal level: +5.2dBu

WARRANTY INFORMATION

Please register online at www.ehx.com/product-registration or complete and

return the enclosed warranty card within 10 days of purchase. Electro-Harmonix

will repair or replace, at its discretion, a product that fails to operate due to

defects in materials or workmanship for a period of one year from date of pur-

chase. This applies only to original purchasers who have bought their product

from an authorized Electro-Harmonix retailer. Repaired or replaced units will

then be warranted for the unexpired portion of the original warranty term.

If you should need to return your unit for service within the warranty period,

please contact the appropriate ofce listed below. Customers outside the re-

gions listed below, please contact EHX Customer Service for information on

warranty repairs at [email protected]om or +1-718-937-8300. USA and Canadian cus-

tomers: please obtain a Return Authorization Number (RA#) from EHX Cus-

tomer Service before returning your product. With your returned unit, include

a written description of the problem as well as your name, address, telephone

number, e-mail address, RA# and a copy of your receipt clearly showing the

purchase date.

United States & Canada

EHX Customer Service

Electro-Harmonix

co New Sensor Corp.

47-50 33rd Street

Long Island City, NY 11101

Tel: 718-937-8300

Email: [email protected]om

Europe

John Williams

Electro-Harmonix UK

13 Cwmdonkin Terrace

Swansea SA2 0RQ

United Kingdom

Tel: +44 179 247 3258

Email: electr[email protected]om

This warranty gives a purchaser specic legal rights. A purchaser may have even greater rights depending upon

the laws of the jurisdiction within which the product was purchased.

The CE logo indicates that this product has been tested and shown to conform with all applicable

European Conformity directives.

The WEEE or “trashcan” logo indicates that this product is made up of electronic components that should not

be trashed alongside household waste but instead should be recycled by a proper electrical waste facility.

Inhaltsverzeichnis

Andere Electro-Harmonix Musikpedal Handbücher

Electro-Harmonix

Electro-Harmonix Octavix Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix OPERATION OVERLORD Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix HOLY STAIN Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix GREEN RUSSIAN BIG MUFF Pi Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix MEL9 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix NANO LOOPER 360 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix SPRUCE GOOSE OVERDRIVE Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Bassballs Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Pitch Fork Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix NANO BIG MUFF PI Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Epitome Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Silencer Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix C9 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix TONE TATTOO Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix MOD 11 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix XO HOLY GRAIL PLUS Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix NEO MISTRESS Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Black Finger Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Deluxe Electric Mistress Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix NANO POG Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix MOD REX Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix Superego+ Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix MICRO Q-TRON Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix KEY9 Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung