Electro-Voice PC-12/FL Bedienungsanleitung

General Description:

PolarChoice Series:

PC-12/FL

PC-18/FL

Threaded/FlangeMountMiniature

Multi-PatternPodiumMicrophone

Key Features:

•Dual Capsule Design with four polar

patterns: Omnidirectional, Cardioid,

Supercardioid, and Hypercardioid.

•Thread or flange mount

•Cable can exit from the side or through

the bottom of the gooseneck

•Switchable high pass filter

•Consistent on-axis response.

•Available in 12 or 18 inch versions.

•Non-reflecting black finish

•Phantom powered back-electret

condenser

•Packaged with a two-piece shock mount

The PC-12/FL and PC-18/FL are multi-pattern miniature gooseneck podium microphones designed for sound

reinforcement systems where sound quality and gain-before-feedback is of major importance. The multi-pattern

versatility of the PolarChoice microphone makes it true “problem solver”. With three directional and one non-

directional polar pattern available, the PolarChoice™microphone is ideal for virtually any installation. Polar

patterns can be easily changed, using a small flat bladed screwdriver with the front mounted rotary control on

the external electronics module. The control switch has the following settings:

Altering the polar pattern does not change the on-axis sonic character of the

microphone; therefore changes in equalizer settings are unnecessary. The PC-

12/FL and PC-18/FL are acoustically designed for high-quality sound

reinforcement and broadcast applications. The frequency response is tailored

for wide-range sound reproduction with very natural sound pick-up for either

distant or close-up use.

The PC-12/FL and PC-18/FL microphones can be mounted in several different ways. They can be mounted on

any fixture that has a standard 5/8" X 27 microphone thread (such as a microphone stand), or they can be

mounted to any flat surface using the included threaded flange. Additionally, they can be mounted using the

included shock mount and adapter. The cable can be easily changed to exit from either the side, or through the

bottom of the microphone.

The small, dual diameter gooseneck has two supple joints and a rigid center tube. The rigid tube prevents

unsightly twisting of the gooseneck but permits the user to exactly position the microphone. The electronics

module is terminated with a male XLR-type 3-pin connector that allows the microphone to be plugged directly

into an existing panel-mount XLR receptacle. The electronics module can also be surface mounted using the

included mounting clips. The housing is machined brass for ruggedness and superior EMI/RFI attenuation. The

PC-12/FL and PC-18/FL are designed to be phantom-powered with a wide voltage range of 12-52V dc (DIN

Standard 45 596).

Switch Setting Polar Pattern

Applications:

PolarChoice Series PC-12/FL and PC-18/FL Microphones

Technical Specifications:

The PC-12/FL and PC-18/FL can be used on lecterns, podiums, desk and tabletops, or other applications that require a

threaded or flange mounted gooseneck microphone. To maximize gain-before-feedback the PolarChoice’s™three directional

polar patterns allow the user to pick the directional polar pattern for optimum effect. For those applications where gain-

before-feedback is not a problem, an omnidirectional pattern is included. Applications requiring speaking close to the

microphone at podiums, lecterns, or pulpits normally require a windscreen to control breath noise and P-popping or, in

some cases, wind noise from circulating air.

Generation Element:

Dual condenser, back electret

Frequency Response:

50 Hz to 20,000 Hz (see chart)

Polar Patterns: (see chart)

Omnidirectional

Cardioid

Supercardioid

Hypercardioid

Sensitivity,

Open Circuit Voltage, 1 kHz:

5.6mV/Pascal

Clipping Level (1% THD):

>135 dB SPL

Equivalent Noise:

<26 dB SPL “A” weighted

(0 dB=20 micropascals)

Dynamic Range:

>109 dB

Output Impedance, 1 kHz:

200 ohms

Power Requirements:

Phantom, 12 – 52 VDC

Current Consumption:

< 8 mA with P12 supply

Polarity: Pin 2 positive, referenced to pin 3, with positive pressure on

the diaphragm

Dimensions

Gooseneck Length:

PC-12/FL: 313.2 mm (12.3 in.)

PC-18/FL: 457.7 mm (18.0 in.)

Maximum Head Diameter: 14.6 mm (0.58 in.)

Gooseneck Diameter:

Lower section, 7.9 mm (0.31 In.)

Upper section, 6.4 mm (0.25 In.)

Electronics Module Diameter: 20 mm (0.79 in.)

Connector Diameter: 19 mm (0.75 in.)

Accessories Furnished:

Windscreen

Two-piece shock mount, with shock mount adaptor

Mounting clips for electronics module

Optional Accessories:

FMK flange-mount kit

WS-PC1 large windscreen

CPSM shock-mount kit

Color: Nonreflecting black

Environmental Conditions,

Relative Humidity 0-50%:

-29° to 74°C (-20° to 165°F)

Relative Humidity 0 to 95%:

-29° to 57°C (-20° to 135°F)

Net Weight:

PC-12/FL:

111 grams (3.9 oz), 252 grams (8.9 oz) with electronics

module

PC-18/FL:

119 grams (4.2 oz), 261 grams (9.2 oz) with electronics

module

Dimension Drawings:

EV Multi-Port Windscreen:

Engineering Data Sheet

Shock Mount Installation:

Changing the Cable from Side Exit to

Bottom Exit:

All PolarChoice microphones come with the exclusive EV

Multi-Port Windscreen. This unique one-piece ported design

offers greatly improved resistance to “P”-popping noise by

creating a two-stage filter that has an air space between the

stages. This makes the multi-port windscreen as effective as

much larger traditional designs.

Drill a 1-3/8 inch hole to mount the hard plastic flange into the

desk, table, or lectern top. Drill three holes to secure the

flange. The type of screws used to fasten the flange will

depend on the desktop material. To insert the flexible shock

mount:

1. First route the cable, as desired, either out the side of the

mic, or through the bottom.

2. Screw the included shock mount adaptor into the bottom

of the microphone.

3. Gently push the flexible shock mount onto the adaptor.

4. Insert the microphone and shock mount into the hard

plastic flange using a twisting action to seat the shock

mount.

1) Disconnect the cable from the electronics module

2) Unscrew the hexretainerfromthe bottom of the gooseneck.

3) Thread the cable throughthe knurledring and hex retainer.

4) Screw the hex retainer back on the bottom of the goose

neck and tighten securely.

5) Reconnect the cable to the electronics module, according to

thewiringdiagram.

Mounting the Electronics Module:

The external electronics module can either be plugged directly

into any standard 3-pin XLR input, or it can be surface mounted

in a location adjacent to the microphone using the provided

mounting clips. If required, the cable between the microphone

and the electronics module can be shortened. Simply cut the

cable to the desired length, and remove sufficient insulation from

the wires to allow the conductors to be inserted into the terminal

strip in the electronics module. Connect the wires to the module

as shown in the wiring guide on this page. For best results, the

conductors should first be tinned with solder.

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: 800/955-6831

Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265

Other International locations. For customer orders, contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 736-4212

For warranty repair or service information, contact the Service Repair department at:

800/392-3497

For technical assistance, contact Technical Support at: 866/78AUDIO

Specifications subject to change without notice.

12000 Portland Avenue South, Burnsville, MN 55337

Phone:952/884-4051,Fax:952/884-0043

www.electrovoice.com

Part Number 38110-226 Rev. B

Architectural & Engineering Specs:

Frequency Response: Polars:

PolarChoice™ Series PC-12/FL, PC-18/FL

The microphone shall be a back-electret condenser type with a frequency response of 50 Hz to 20 kHz. The

microphone shall have a nominal, balanced output impedance of 200 ohms. The microphone shall have four selectable

polar patterns: omnidirectional, cardioid, supercardioid, and hypercardioid. The microphone shall have an output level of

5.6 mV/Pascal, and outputs shall not be appreciably affected by the following temperature and humidity extremes: -29°

to 74° C (-20° to 165°F) when the relative humidity is 0-50%; -29° to 57°C (-20° to 135°F) when the relative humidity is

0-95%. Dimensions shall be 350.7 mm (13.8 in.) long (PC-12/FL), and 495.1 mm 19.5 in.) long, (PC-18/FL) with a

maximum head diameter of 14.6 mm (0.58 in). The PC-12/FL microphone shall include a 313.2 mm (12.3 in.)

gooseneck. The PC-18/FL microphone shall include a 457.7 mm (18.0 in.) gooseneck. The PC-12/FL and PC-18/FL

goosenecks microphones will include an external electronics module, which is terminated with a professional XLR-type

3-pin style connector. The electronics module will have a switchable high pass filter to roll off low frequencies. The

microphone shall be of metal construction. The microphone will include an external windscreen. The microphone shall

have a nonreflecting black finish. The Electro-Voice PolarChoice™ series PC-12/FL or PC-18/FL is specified.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Electro-Voice Mikrofon Handbücher

Electro-Voice

Electro-Voice PolarChoice PC Plus-12 Bedienungsanleitung

Electro-Voice

Electro-Voice N/D967 Bedienungsanleitung

Electro-Voice

Electro-Voice DS35 Bedienungsanleitung

Electro-Voice

Electro-Voice RE97-2Tx Bedienungsanleitung

Electro-Voice

Electro-Voice CO2 Bedienungsanleitung

Electro-Voice

Electro-Voice RE92TX Bedienungsanleitung

Electro-Voice

Electro-Voice 912 Bedienungsanleitung

Electro-Voice

Electro-Voice 630 Bedienungsanleitung

Electro-Voice

Electro-Voice RE20 Bedienungsanleitung

Electro-Voice

Electro-Voice PL76 Montageanleitung

Electro-Voice

Electro-Voice R300 Bedienungsanleitung

Electro-Voice

Electro-Voice N/D267 Bedienungsanleitung

Electro-Voice

Electro-Voice RE98 Bedienungsanleitung

Electro-Voice

Electro-Voice Sentry III Bedienungsanleitung

Electro-Voice

Electro-Voice CP212 Bedienungsanleitung

Electro-Voice

Electro-Voice Microphone Bedienungsanleitung

Electro-Voice

Electro-Voice N/D168 Bedienungsanleitung

Electro-Voice

Electro-Voice C015P Bedienungsanleitung

Electro-Voice

Electro-Voice TR420 Bedienungsanleitung

Electro-Voice

Electro-Voice 603TR Dimensionsleitfaden

Electro-Voice

Electro-Voice PC Desktop-5 Bedienungsanleitung

Electro-Voice

Electro-Voice PL92A Bedienungsanleitung

Electro-Voice

Electro-Voice ENG 618 Bedienungsanleitung

Electro-Voice

Electro-Voice CS11 Bedienungsanleitung

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

Sony

Sony C-48 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

Shure

Shure WH30TQG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

Shure

Shure KSM141 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

Shure

Shure MXA710 Series Bedienungsanleitung