Electro-Voice R300-L Bedienungsanleitung

R300 UHF Wireless MicropHone

USER GUIDE

EZsync ClearScan

Electro-Voice

300

SET

SYNC

TAB LE oF contents

1. Quick System Setup

 •Receiver.................................................................................................................4

 •Transmitter.............................................................................................................5

 •SystemsOperation..............................................................................................6

2.DetailedComponentDescriptions

 •Receiver.......................................................................................................... 7-14

 •HandheldTransmitter .................................................................................15-16

 •BodypackTransmitter................................................................................. 17-19

3.GuidelinesForBestPerformance.............................................................................20-21

4.TroubleshootingGuide................................................................................................22-23

5.Specications ...............................................................................................................24-25

6.Certications....................................................................................................................... 26

7. ServiceandWarranty ........................................................................................................ 27

8.ComponentsandAccessories........................................................................................ 28

9.AppendixACompatibleChannelGroups...............................................................29-31

01QUICK SETUP: receiver

1.Donotconnectthereceivertoanyotherequipmentyet!

2.ConnectthetwoAntennastothereceiver.

3.Installthebladesintothepowersupply,plugitintothebackofthereceiver,

andintoanoutlet.

4.PressthePOWERswitch.Displaywilllightup.

5.Pressandholdthe buttonuntilCLEARSCANscrollsacrossthescreen.

6.WhenCLEARSCANstops,thereceiverwillbesettotheclearestchannel.

7.Turnthereceiveroffandconnectthemixerorotheraudiosystemtothereceiver

XLRConnectororthe¼inchLineLevelJack.

8.Settheaudiomixerorothersysteminputleveltominimum.

9.PressthePowerswitchbuttoninagain.

Receiver “Quick Set-up” is complete.

QUICK SETUP: transMitter

1.WiththePowerswitchonthetransmitterOFF,installtwofreshAAbatteriesintothetransmitter.

2.PressthetransmitterPowerSwitchuntilthedisplaycomeson.

3.HoldthetransmitterwiththeEZsyncPortfacingthereceiver,aboutafoot(30cm)away.

4.PresstheSYNCButtononthereceiver,SYNCwillshowinthedisplay.

5.Oncethechannelissetinthetransmitter,thedisplaywillswitchtothemain

displayandshowRFandAudioLevels.

Transmitter “Quick Set-up” is complete.

R300

EZsync Clear

SYNC

EZsync

R300 ClearScan

SET

QUICK SETUP: systeMs operation

1.Setthemixer/ampgain.

2.Talkorsingintothemicrophoneorplaytheguitaratanormalvolume.You

shouldhearaudiocomingoutofthesystem.

3.Youmayhavetoadjustthegain(viathecontrolnexttotheconnectoronthe

receiverbackpanel)toprovidethebestinputvolumeforyourmixer/amp.

“Quick Set-up” is now complete. Please enjoy your R300 system.

SYNC

R300

EZsync Clear

SET

EZsync ClearScan

Electro-Voice

300

ANTENNA B ANTENNA A12V .500mA

MIN MAX

VOLUME

LEVEL

-10dB 0dB

BALANCED OUT UNBALANCED OUT

DETAILED coMponent descriptions

2.1 |R300 Receiver

RECEIVER CONTROLS, CONNECTORS

1.PowerON/OFF

2.SYNCDataTransferButton

3.InfraredEZsyncWindow

4.GraphicalDisplay

 a.ChannelorFrequencyDisplay

 b.DiversityIndicator

 c.RFStrengthMeter

 d.AudioLevelMeter

 e.LockIndicator

 f.SquelchLevelIndicator

5.ScrollDownandUp( and )ControlButtons

6.SETControlButton

7.ClearScanControl(pressandhold button)

8.TNCAntennaInputConnectors(2)

9.BalancedOutputVolumeControl

10.XLRBalancedOutputConnector

11.¼InchUnbalancedLineLevelAudioOutputConnector

12.UnbalancedOutputLevelSwitch(-10dBor0dB)

13.DCPowerConnector(12VDC,500mA)

14.PowerCordRetainer

8 89 10 11 12 13 14

DETAILED coMponent descriptions

2.1 |Receiver Setup & Operation

1.Placethereceiverandantennaswherethereisaclearlineofsighttotheareawherethetransmitter

willbeused.Rotatetheantennastoseparatethemby90degrees.

2. Install the appropriate power connection blades into the power supply and connect the

power supplycordtothereceiver.PlugthepowersupplyintoanACoutlet.Pushthepower

buttontoturnthereceiveronandconrmthatitisonbycheckingthemaindisplayscreen.

3. Manual Channel Change

  a.The and buttonsallowyoutoscrollthroughtheChannels.WhentheChannel

youdesireisdisplayed,stopscrolling.

  b.After2secondsthedisplayedchannelnumberwillstarttoash.

  c.Thenumberwillstopashingandthenewchannelisinstalled.

  d.TurnonthetransmitterandholdtheEZsyncportfacingthereceiverEZSyncport,

aboutafoot(50cm)away.

ANTENNA B ANTENNA A12V .500mA

MIN MAX

VOLUME

LEVEL

-10dB 0dB

BALANCED OUT UNBALANCED OUT

e.PresstheSYNCbuttononthereceivertotransferthechannelinformation.

f.ThereceiverwilldisplaySYNCuntilthedataistransferred,thenreturntothemainscreen.

g.Thetransmitterdisplayscreenwillnowshowthenewchannelandfrequency.

h.Ifthechanneldatawasnottransferredtothetransmitterafter5seconds,thereceiver

willdisplayERROR.BecertainthatthetransmitterisOnandtheEZsyncportisfacingthereceiver

andtryagain.

i.Ifthedatastilldoesnottransfer,trynewbatteries,ormovetheunittoashadedareaawayfrom

directsunlightbeforetryingagain.

R300

EZsync Clear

SYNC

EZsync

R300 ClearScan

SET

R300

EZsync Clear

SYNC

EZsync

R300 ClearScan

SET

DETAILED coMponent descriptions

4. ClearScan: Thisfeatureautomatestheprocessofndingaclearchannel.

  a.Toscanfortheclearestchannelinagroup,pressandhold untilCLEARSCAN

appearsinthedisplay,thenreleasethebutton.

  b.Whenthescaniscomplete,thedisplaywillshowtheclearestavailablechannel.

  c.UsetheSYNCbuttontotransferthenewchannelasinstep3.

5.DuringsetupmakesurethemixeroramplierinputusedfortheR300ismutedor

turneddowntoaminimumlevel.

6.Pluganaudiocable(notsupplied)intothe3pinXLRor¼inchoutputoftheR300.

Note:TheXLRconnectoristhepreferredconnectionsincetheoutputisbalancedandwillbe

moreimmunetonoiseforlongerrunsofcablealthougheithercanbeusedwithgoodresults.

Setthebalancedoutputlevelonthebackpanelto12o’clock(midwayintherange)tostartand

adjustlaterifnecessary.Ifthe¼inchunbalancedoutputisused,startwithadjustmentswitchin

the-10dBsetting.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Electro-Voice Mikrofon Handbücher

Electro-Voice

Electro-Voice 671A Bedienungsanleitung

Electro-Voice

Electro-Voice 607 Bedienungsanleitung

Electro-Voice

Electro-Voice C090 Bedienungsanleitung

Electro-Voice

Electro-Voice N/D167 Bedienungsanleitung

Electro-Voice

Electro-Voice Press-to-talk 619 Bedienungsanleitung

Electro-Voice

Electro-Voice PL77A Bedienungsanleitung

Electro-Voice

Electro-Voice C05 Bedienungsanleitung

Electro-Voice

Electro-Voice 915 Bedienungsanleitung

Electro-Voice

Electro-Voice N/D767a Bedienungsanleitung

Electro-Voice

Electro-Voice PL4 Bedienungsanleitung

Electro-Voice

Electro-Voice PL95 Bedienungsanleitung

Electro-Voice

Electro-Voice RE92H Bedienungsanleitung

Electro-Voice

Electro-Voice MC100 Bedienungsanleitung

Electro-Voice

Electro-Voice HM1 Bedienungsanleitung

Electro-Voice

Electro-Voice PL80a Bedienungsanleitung

Electro-Voice

Electro-Voice RE34 Bedienungsanleitung

Electro-Voice

Electro-Voice PC Boundary Bedienungsanleitung

Electro-Voice

Electro-Voice US690 Bedienungsanleitung

Electro-Voice

Electro-Voice N/D357A Bedienungsanleitung

Electro-Voice

Electro-Voice RE20 Bedienungsanleitung

Electro-Voice

Electro-Voice 645TR Bedienungsanleitung

Electro-Voice

Electro-Voice ULM-21 Bedienungsanleitung

Electro-Voice

Electro-Voice PolarChoice Desktop Series Bedienungsanleitung

Electro-Voice

Electro-Voice PL76 Montageanleitung

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

Sony

Sony C-48 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

Shure

Shure WH30TQG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

Shure

Shure KSM141 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

Shure

Shure MXA710 Series Bedienungsanleitung