Electro-Voice R300 Bedienungsanleitung

R300 UHF Wireless MicropHone

USER GUIDE

EZsync ClearScan

Electro-Voice

300

SET

SYNC

TAB LE oF contents

1. Quick System Setup

 •Receiver.................................................................................................................4

 •Transmitter.............................................................................................................5

 •SystemsOperation..............................................................................................6

2.DetailedComponentDescriptions

 •Receiver.......................................................................................................... 7-14

 •HandheldTransmitter .................................................................................15-16

 •BodypackTransmitter................................................................................. 17-19

3.GuidelinesForBestPerformance.............................................................................20-21

4.TroubleshootingGuide................................................................................................22-23

5.Specications ...............................................................................................................24-25

6.Certications....................................................................................................................... 26

7. ServiceandWarranty ........................................................................................................ 27

8.ComponentsandAccessories........................................................................................ 28

9.AppendixACompatibleChannelGroups...............................................................29-31

01QUICK SETUP: receiver

1.Donotconnectthereceivertoanyotherequipmentyet!

2.ConnectthetwoAntennastothereceiver.

3.Installthebladesintothepowersupply,plugitintothebackofthereceiver,

andintoanoutlet.

4.PressthePOWERswitch.Displaywilllightup.

5.Pressandholdthe buttonuntilCLEARSCANscrollsacrossthescreen.

6.WhenCLEARSCANstops,thereceiverwillbesettotheclearestchannel.

7.Turnthereceiveroffandconnectthemixerorotheraudiosystemtothereceiver

XLRConnectororthe¼inchLineLevelJack.

8.Settheaudiomixerorothersysteminputleveltominimum.

9.PressthePowerswitchbuttoninagain.

Receiver “Quick Set-up” is complete.

QUICK SETUP: transMitter

1.WiththePowerswitchonthetransmitterOFF,installtwofreshAAbatteriesintothetransmitter.

2.PressthetransmitterPowerSwitchuntilthedisplaycomeson.

3.HoldthetransmitterwiththeEZsyncPortfacingthereceiver,aboutafoot(30cm)away.

4.PresstheSYNCButtononthereceiver,SYNCwillshowinthedisplay.

5.Oncethechannelissetinthetransmitter,thedisplaywillswitchtothemain

displayandshowRFandAudioLevels.

Transmitter “Quick Set-up” is complete.

R300

EZsync Clear

SYNC

EZsync

R300 ClearScan

SET

QUICK SETUP: systeMs operation

1.Setthemixer/ampgain.

2.Talkorsingintothemicrophoneorplaytheguitaratanormalvolume.You

shouldhearaudiocomingoutofthesystem.

3.Youmayhavetoadjustthegain(viathecontrolnexttotheconnectoronthe

receiverbackpanel)toprovidethebestinputvolumeforyourmixer/amp.

“Quick Set-up” is now complete. Please enjoy your R300 system.

SYNC

R300

EZsync Clear

SET

EZsync ClearScan

Electro-Voice

300

ANTENNA B ANTENNA A12V .500mA

MIN MAX

VOLUME

LEVEL

-10dB 0dB

BALANCED OUT UNBALANCED OUT

DETAILED coMponent descriptions

2.1 |R300 Receiver

RECEIVER CONTROLS, CONNECTORS

1.PowerON/OFF

2.SYNCDataTransferButton

3.InfraredEZsyncWindow

4.GraphicalDisplay

 a.ChannelorFrequencyDisplay

 b.DiversityIndicator

 c.RFStrengthMeter

 d.AudioLevelMeter

 e.LockIndicator

 f.SquelchLevelIndicator

5.ScrollDownandUp( and )ControlButtons

6.SETControlButton

7.ClearScanControl(pressandhold button)

8.TNCAntennaInputConnectors(2)

9.BalancedOutputVolumeControl

10.XLRBalancedOutputConnector

11.¼InchUnbalancedLineLevelAudioOutputConnector

12.UnbalancedOutputLevelSwitch(-10dBor0dB)

13.DCPowerConnector(12VDC,500mA)

14.PowerCordRetainer

8 89 10 11 12 13 14

DETAILED coMponent descriptions

2.1 |Receiver Setup & Operation

1.Placethereceiverandantennaswherethereisaclearlineofsighttotheareawherethetransmitter

willbeused.Rotatetheantennastoseparatethemby90degrees.

2. Install the appropriate power connection blades into the power supply and connect the

power supplycordtothereceiver.PlugthepowersupplyintoanACoutlet.Pushthepower

buttontoturnthereceiveronandconrmthatitisonbycheckingthemaindisplayscreen.

3. Manual Channel Change

  a.The and buttonsallowyoutoscrollthroughtheChannels.WhentheChannel

youdesireisdisplayed,stopscrolling.

  b.After2secondsthedisplayedchannelnumberwillstarttoash.

  c.Thenumberwillstopashingandthenewchannelisinstalled.

  d.TurnonthetransmitterandholdtheEZsyncportfacingthereceiverEZSyncport,

aboutafoot(50cm)away.

ANTENNA B ANTENNA A12V .500mA

MIN MAX

VOLUME

LEVEL

-10dB 0dB

BALANCED OUT UNBALANCED OUT

e.PresstheSYNCbuttononthereceivertotransferthechannelinformation.

f.ThereceiverwilldisplaySYNCuntilthedataistransferred,thenreturntothemainscreen.

g.Thetransmitterdisplayscreenwillnowshowthenewchannelandfrequency.

h.Ifthechanneldatawasnottransferredtothetransmitterafter5seconds,thereceiver

willdisplayERROR.BecertainthatthetransmitterisOnandtheEZsyncportisfacingthereceiver

andtryagain.

i.Ifthedatastilldoesnottransfer,trynewbatteries,ormovetheunittoashadedareaawayfrom

directsunlightbeforetryingagain.

R300

EZsync Clear

SYNC

EZsync

R300 ClearScan

SET

R300

EZsync Clear

SYNC

EZsync

R300 ClearScan

SET

DETAILED coMponent descriptions

4. ClearScan: Thisfeatureautomatestheprocessofndingaclearchannel.

  a.Toscanfortheclearestchannelinagroup,pressandhold untilCLEARSCAN

appearsinthedisplay,thenreleasethebutton.

  b.Whenthescaniscomplete,thedisplaywillshowtheclearestavailablechannel.

  c.UsetheSYNCbuttontotransferthenewchannelasinstep3.

5.DuringsetupmakesurethemixeroramplierinputusedfortheR300ismutedor

turneddowntoaminimumlevel.

6.Pluganaudiocable(notsupplied)intothe3pinXLRor¼inchoutputoftheR300.

Note:TheXLRconnectoristhepreferredconnectionsincetheoutputisbalancedandwillbe

moreimmunetonoiseforlongerrunsofcablealthougheithercanbeusedwithgoodresults.

Setthebalancedoutputlevelonthebackpanelto12o’clock(midwayintherange)tostartand

adjustlaterifnecessary.Ifthe¼inchunbalancedoutputisused,startwithadjustmentswitchin

the-10dBsetting.

Andere Handbücher für R300

Inhaltsverzeichnis

Andere Electro-Voice Mikrofon Handbücher

Electro-Voice

Electro-Voice RE510 Bedienungsanleitung

Electro-Voice

Electro-Voice PC Boundary Bedienungsanleitung

Electro-Voice

Electro-Voice R300-L Bedienungsanleitung

Electro-Voice

Electro-Voice RE90P-12 Bedienungsanleitung

Electro-Voice

Electro-Voice 630 Bedienungsanleitung

Electro-Voice

Electro-Voice RE200 Bedienungsanleitung

Electro-Voice

Electro-Voice PL70-N/D Bedienungsanleitung

Electro-Voice

Electro-Voice 672A Bedienungsanleitung

Electro-Voice

Electro-Voice 927 Bedienungsanleitung

Electro-Voice

Electro-Voice CP212 Bedienungsanleitung

Electro-Voice

Electro-Voice 625TRSKK Dimensionsleitfaden

Electro-Voice

Electro-Voice Cobalt Co7 Bedienungsanleitung

Electro-Voice

Electro-Voice R300HDC Bedienungsanleitung

Electro-Voice

Electro-Voice RE50 Bedienungsanleitung

Electro-Voice

Electro-Voice RE98 Bedienungsanleitung

Electro-Voice

Electro-Voice N/D 257B Bedienungsanleitung

Electro-Voice

Electro-Voice RE97TX Bedienungsanleitung

Electro-Voice

Electro-Voice N/D767a Bedienungsanleitung

Electro-Voice

Electro-Voice N868 Bedienungsanleitung

Electro-Voice

Electro-Voice RE92L Bedienungsanleitung

Electro-Voice

Electro-Voice N/D478 Bedienungsanleitung

Electro-Voice

Electro-Voice PC SAT-12 Bedienungsanleitung

Electro-Voice

Electro-Voice PL4 Bedienungsanleitung

Electro-Voice

Electro-Voice PL92A Bedienungsanleitung

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

Sony

Sony C-48 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

Shure

Shure WH30TQG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

Shure

Shure KSM141 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

Shure

Shure MXA710 Series Bedienungsanleitung