Electrolux KELVINATOR KSV53HRA Bedienungsanleitung

ELECTROLUX HOME PRODUCTS PTY LTD

ABN 51 004 762 341

KELVINATOR

SPLIT SYSTEM

AIR-CONDITIONER

MODELS:

KSV53HRA

KSV62HRA

KSV70HRA

Issue: 7

Technical Publication Nº KSSSI90 Date: 12/15

DIAGNOSTIC MANUAL

Indoor Unit & PCB test board Error Display.

DISPLAY LED STATUS PAGE

Not Operating

No operation by use of remote control

3 to 6

EEPROM parameter error

Indoor / outdoor units communication protection

8 to 17

Indoor Unit Fan Stall

30 & 31

Open or short circuit of outdoor condenser pipe & compressor temperature sensors

18 & 19

E52

Open or short circuit of outdoor ambient temperature sensor

18 & 19

Open or short circuit of room or evaporator temperature sensor

L2 & PA

High-temperature protection of condenser

21 & 22

Module protection

23 & 24

Over voltage or too low voltage protection

Temperature protection of compressor top - low refrigerant charge

26 & 27

Inverter compressor drive error

28& 29

LO & P91

Evaporator high-frequency low-temperature limit

30 & 32

Page 2KSSSI90

Not Operating:

# While the unit is in “stand by” mode, check if the green stand by light is flashing at 1 Hertz?

# Try operating the unit by the forced operations button: By pressing the button once, the unit should

activate in Auto mode. By pressing this button twice, within five seconds, the unit should activate in

Cooling mode.

If the unit can be operated by the forced operations button & the green stand by light was flashing on the

display PCB assembly, prior to pressing forced operation button, check the remote controller.

If the unit can be operated by the forced operations button & the green stand by light was off on the

display PCB, replace the display PCB assembly.

Stand by indicator on Display PCB assembly.

Button located on top right hand side of

indoor unit behind filter cover.

Page 3KSSSI90

# If the frequency light is flashing & the unit can only be operated by the forced operations button.

The “Memory Module PCB” could be faulty. Refer attached photo’s

Note: There is no real way of isolating this Memory Module PCB & testing it, apart from replacing the

indoor control box assembly. As this component is not available as a induvial component.

Location of Memory Module PCB

(Indoor control box assembly)

Page 4KSSSI90

# If the unit cannot be operated by the use of the remote control or the forced operation button, proceed

as follows:

# Check the wiring configuration from the indoor unit to the outdoor unit. Is it wired up correctly in

accordance to the wiring diagram provided on the underside of the plastic outdoor terminal cover?

#Check the supply voltage to the outdoor terminal block.

# Check the supply voltage from the outdoor terminal block to the indoor terminal block.

Active & Neutral wires from mains supply.

Active, Neutral & Communication wires

connecting from outdoor terminal block to

indoor terminal block.

Active, Neutral & Communication wires from

outdoor terminal block.

Page 5KSSSI90

# Check the supply voltage from the indoor PCB to the transformer.

If there is 240 Volts AC from this connection point on the indoor PCB, replace the transformer.

If there is no supply voltage from this point, replace the indoor main PCB.

Transformer AC voltage connection points.

Page 6KSSSI90

E0 error:

#The E0 error indicates there is a software issue/program chip fault on the main indoor PCB assembly.

# Replace the main indoor PCB assembly.

If any one of the program chips fail, as highlighted by

the red arrows, this could cause an E0 error.

Page 7KSSSI90

E1 error:

(Indoor / outdoor units communication protection) error diagnosis and solution).

# Check for DC voltage at the following points:

•While in “standby mode”, disconnect the Signal Wire off the outdoor terminal block.

•With a multimeter, test the DC output from the signal wire connecting to the indoor unit &

earth.

•Then by using the same method, test the output signal on the terminal block from the outdoor

PCB & earth.

•If the meter reads a pulsing voltage in the 20's to the 40's (this can vary) the relevant PCB

should be okay.

•If the meter reads a 0 DC volts or a low stable voltage, this would indicate the PCB in

question is faulty.

Note: If both indoor & outdoor PCB’s appear okay, continue to the following page.

Page 8KSSSI90

E1 error (Indoor Unit)

#Disconnect the main power supply to the outdoor unit by means of the isolation switch. After

approximately one minute, turn the power supply back on & attempt to operate the unit on heating or

cooling mode by the use of the remote control.

If E1 fault has not cleared:

# Check the continuity of the (3uF) indoor fan capacitor mounted vertically inside the indoor control box

assembly.

# Measure the resistance of the Blue & Black wires that connect from the 3uF capacitor to the indoor fan

motor. The resistance reading should be approximately “322 Ohms”, at an ambient temperature of 22ºC.

3uF capacitor mounted inside the indoor

control box assembly.

3uF indoor fan capacitor.

Ohms reading of indoor fan motor.

Page 9KSSSI90

E1 error (Outdoor Unit)

If E1 fault has not cleared:

Check the continuity of the “Bridge Rectifier” as illustrated below.

Turn off the power & let the inverter electrolytic capacitors completely discharge.

Identify the diodes individual ‘Plus’ and ‘Minus’ connections so as to test each diode's forward and

reverse resistance values. The diagrams listed below illustrate the method of achieving this.

Relevant test points on the main outdoor PCB.

Set the multimeter to a DC Mega Ohms setting.

Place the Positive probe on the ~pin of the rectifier & the Negative probe on the +pin of the rectifier.

Place the Positive probe on the Opin of the rectifier & the Negative probe on the +pin of the rectifier.

Place the Positive probe on the -pin of the rectifier & the Negative probe on the ~pin of the rectifier.

Place the Positive probe on the -pin of the rectifier & the Negative probe on the Opin of the rectifier.

Note: Insure the multimeter probes are placed in their correct orientation as specified above.

Note: If any of the above tests indicate a “Short Circuit” replace the main PCB assembly.

All of the above tests should read several Mega Ohms.

Page 10 KSSSI90

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Electrolux Klimaanlage Handbücher

Electrolux

Electrolux Kelvinator KSV26HRB Bedienungsanleitung

Electrolux

Electrolux EPE 800 Bedienungsanleitung

Electrolux

Electrolux KSV26HRC Bedienungsanleitung

Electrolux

Electrolux EXP26U338CW Bedienungsanleitung

Electrolux

Electrolux EAW05E3AJW Bedienungsanleitung

Electrolux

Electrolux FAH08EN1 Bedienungsanleitung

Electrolux

Electrolux EPF18V1O8 Bedienungsanleitung

Electrolux

Electrolux ESV09CRS-B2 Bedienungsanleitung

Electrolux

Electrolux EACS/I-HVI/N8 21Y EEC Bedienungsanleitung

Electrolux

Electrolux WP71-265WT Bedienungsanleitung

Electrolux

Electrolux ESV09CRU-A1 Bedienungsanleitung

Electrolux

Electrolux EASE09P5AHLW Bedienungsanleitung

Electrolux

Electrolux EFT5540OW Bedienungsanleitung

Electrolux

Electrolux ESV123C1AA Bedienungsanleitung

Electrolux

Electrolux EPM-800 Bedienungsanleitung

Electrolux

Electrolux KSV26HRC Bedienungsanleitung

Electrolux

Electrolux Frigidaire GHWQ083WC1 Betriebsanleitung

Electrolux

Electrolux ESD24HRA Bedienungsanleitung

Electrolux

Electrolux EXH09HV1W Bedienungsanleitung

Electrolux

Electrolux FAH146Q2 Handbuch

Electrolux

Electrolux EXP26V578HW Bedienungsanleitung

Electrolux

Electrolux EXl09HL1W Bedienungsanleitung

Electrolux

Electrolux EXI09HD1W Bedienungsanleitung

Electrolux

Electrolux EXP08CN1W6 Bedienungsanleitung

Beliebte Klimaanlage Handbücher anderer Marken

Panasonic

Panasonic CS-E12HKEW Bedienungsanleitung

nedis

nedis ACMB1WT7 Bedienungsanleitung

Daikin

Daikin FCFV50A Bedienungsanleitung

Fujitsu

Fujitsu Inverter ASBA30JFC Bedienungsanleitung

Toshiba

Toshiba RAS-M10SMUV-E Bedienungsanleitung

Daikin

Daikin FXLQ20MAVE Bedienungsanleitung

CIAT

CIAT Magister 2 Series Leitfaden

Bestron

Bestron AAC6000 Bedienungsanleitung

Frigidaire

Frigidaire FFRE0533S1E0 Bedienungsanleitung

Samsung

Samsung AS09HM3N Bedienungsanleitung

Frigidaire

Frigidaire CRA073PU11 Betriebsanleitung

Soleus Air

Soleus Air GB-PAC-08E4 Bedienungsanleitung

McQuay

McQuay MCK020A Bedienungsanleitung

Webasto

Webasto Frigo Top 25 DS Bedienungsanleitung

Frigidaire

Frigidaire FAZ12ES2A Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric MSC-GE20VB Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric PLA-M100EA Bedienungsanleitung

Daikin

Daikin Split Sensira R32 Bedienungsanleitung