Input program lock: The adjusted settings in the B - Box can not be changed if this cable is connected to
ground. You should connect it to ground if all settings are ready made. However, you can change it at any time if
you open this connection.
Output ignition: This output is wired to the 12 Volt input of the ignition.
Output start relay: This output is wired to the starter relay and can supply max. 10 Ampere to the starter relay. on
´t wire the starter direct to this output!
Output brake light: This is the 12 Volt output to the brake light.
Output low beam: This output is wired to the low beam. The head light is switched off in the moment when you
start your bike
Output high beam: This output is wired to the high beam part of the head light.
Output horn: This is the switched output to the horn. Please note that the B-Box can supply maximum 3 Ampere for
this output. Some old horns have a higher current consumption what can destroy this output. A new horn usually
need about 2,5 Ampere and cost below 10,-.
Outputs for the flashers left an right: These switched outputs are connected to the direction indicators.
The flasher frequency is – of course constant, no matter if you use traditional bulbs or modern led lights.
Programming of the box:
You can change the functions of the box at any time if the „Program lock“ input is open. Press and hold the „Horn“
button and switch on the ignition. The box is in the „programming“ mode when you release the „Horn“ button. The
number of flashes of the direction indicators show you the row number in the table. The first row is the setting for the
side stand and neutral switch. You can activate the switches by pressing the „Left“ button or disable the switches by
pressing the „Right“ button. The box change to the next option after a press on a direction button. The box will store
the settings after 8 presses on the irection buttons.The following options are possible:
Number
Mo e
Left flasher button Right flasher button
Describtion
of
flashes
Neutral / sidestand
Safety control of ignition and start
1 x
switches enabled or
Active
isabled
function active or not.
disabled
The flasher switches off after 50
2 x
Flasher auto off
Off On
times.
Engine stop switch The ignition is on in switch mode if
3 x
or pushbutton for Engine stop switch
Push button
the contact is closed to ground or it
ignition on
switch on / off in button mode.
The ignition is controlled via
4 x
RFI antenna installed
not installed traditional switch or RFI chip.
Brake light and rear The brake light is complete off
5 x
Brake light mode Only brake light light combination when not in use or dim to 40 %
The starter and ignition is controlled
6 x
Start / Ignition One button
Two buttons
by 1 or 2 buttons
The head light is controlled by a
7 x
Head light control Switch
Push button
switch or a button
The direction indicators are
8 x
Indicator control
switch
button
controlled by a switch or 2 buttons.
The settings are stored in the B-Box after 8 presses on a direction button.
2 / 3
