Elkay Swirlflo EDFPB114FP Bedienungsanleitung

Page 1 98008C (Rev. C - 10/17)

EDFPB114FP

SERVICE STOP

(NOT FURNISHED)

BUILDING WATER

INLET

3/8" O.D. UNPLATED COPPER

TUBE CONNECT COLD

WATER SUPPLY

1/4" O.D TUBE

WATER INLET

TO COOLER

NOTE: WATER FLOW

DIRECTION

Installation Manual

EDFPB114FPC

Swirlo®Freeze Resistant Fountain

IMPORTANT! INSTALLER PLEASE NOTE.

THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO

WATER LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY

OCCUR AWAY FROM THE BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO

A FOUNTAIN, CREATING AN ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE

IN THE METAL CONTENT OF THE WATER. THIS CONDITION IS AVOIDABLE BY USING THE PROPER

MATERIALS AS INDICATED. ANY DRAIN FITTINGS PROVIDED BY THE INSTALLER SHOULD BE MADE

OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN FROM THE BUILDING PLUMBING SYSTEM.

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

FIG. 1

TUBE IS

SECURED

IN POSITION

SIMPLY PUSH IN

TUBE TO ATTACH

PUSH IN COLLET

TO RELEASE TUBE

PUSHING TUBE IN BEFORE

PULLING IT OUT HELPS TO

RELEASE TUBE

FIG. 2

OPERATION OF QUICK CONNECT FITTINGS

To assure you install this model easily and correctly, PLEASE READ THESE SIMPLE

INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR

INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL AND OTHER

APPLICABLE CODES. After installation, leave these instructions with the building owner

for future reference. This Freeze Resistant Fountain is shipped in two separate cartons.

The second carton contains the Freeze Resistant Package LKFRB1 that is installed on an

interior heated wall. Refer to the Freeze Resistant Package for the rough-in dimensions

for installation.

INSTALLER

Page 2

EDFPB114FP

98008C (Rev. C - 10/17)

16"

406mm

33 15/16"

863mm

1 5/8"

41mm

127mm

152mm

25 3/8"

645mm

1/2"

13mm

28 3/4"

730mm

30 1/4"

768mm

203mm

1/2"

13mm

FINISHED FLOOR

18 3/8"

467mm

3/8" (10mm) DIA HOLES (4)

FOR SECURING MOUNTING

PLATE TO STUDS

27"

686mm

ADA

REQUIREMENT

13 3/8"

339mm

2 5/8"

66mm

3 5/8"

91mm

12"

305mm

MAX. WALL

THICKNESS 14 3/8"

364mm

17 7/8"

453mm

28 15/16"

735mm

1/2"

13mm

FIG. 3

EDFPB114FPC ROUGH-IN

LEGEND:

A = 7/8" (22mm) DIA. HOLE FOR WATER SUPPLY TUBE

B = 1-3/4" (44mm) DIA. HOLE FOR WASTE LINE

C = 7/8" (22mm) DIA. HOLE FOR OPERATING CABLE

*Note: All dimensions are taken from the nished oor on the side of the wall

that the fountain is installed on.

7 1/4"

184mm

12 1/8"

307mm

12"

305mm

MAX. WALL

THICKNESS

Page 3 98008C (Rev. C - 10/17)

EDFPB114FP

FIG. 4

CABLE SHEATH ADJUSTMENT

To Increase Free Play

To Reduce Free Play

12, 13

INSTALLATION INSTRUCTIONS

1. Wall should already be framed for the fountain using the positioning dimensions shown in Fig. 3. Shown dimensions pertain

to installation location (framing must support up to 300 lbs. weight). These dimensions are required for compliance with

ANSI Standard A117.1/ADA requirements.

2. The freeze resistant package must be mounted on an interior wall in a heated area. The room temperature of the interior heated

area must be 50° F (10° C) or higher. The freeze resistant package may be surface or recessed mounted. If recess mounted the

 surfaceofthecovermustbeushwiththeinteriorwallsurface.Thepackageisfurnishedwithscrewsformountingthecoverto

the box. If the box is recess mounted, do not fasten the top and bottom of the cover to the box. Use the holes on the front only.

3. To assemble the operating cable to the sleeve inside the fountain arm you will need to remove cap screw (Item 2, See Fig. 6)

and then remove Push Button and Pin (Items 12 & 13, See Fig. 4). Remove screw (Item 4, See Fig. 4) and you will now be

able to remove the Sleeve (Item 7, See Fig. 4) to get access to the adjustment nuts for additional adjustability. (Fountain should

be mounted to exterior wall). The adjustment nuts should be at the base of the threaded area on the operating cable. See Fig. 4.

Create a loop in the cable and thread the free end of the cable through the wall into the freeze resistant box.

4. Connect free end of operating cable to the valve-operating bracket in the freeze resistant box.

5. Remove cable free play by adjusting the jam nuts on the ends of the operating cable. See Fig. 4.

6.Connectwaterlinefromfountainbubblerintofreezeresistantbox.Theconnectiontotheboxusesaquickconnectwatertting.

Position the water line, in the fountain, to drain back into interior mounted box. Any water left standing, in the exterior line, can

freeze. To insure positive draining of the bubbler supply tube, excess length should be trimmed off and discarded.

7. Connect drain and water supply lines to the freeze resistant fountain. Inline strainer must be used on the inlet water line. See

Figure 1.

START UP

1. Turn on building water supply and check all connections for leaks. Repair as required.

2. Stream height is factory set at 35 PSI. If stream height needs to be changed adjust the regulator in the freeze resistant package.

Clockwise adjustment raises stream height, counter clockwise adjustment will lower stream.

3. Adjust operating cable as required. Cable system should have a minimal amount of free play to allow for proper valve operation.

 Ifthesystemistootightthevalvewillstayintheonpositioncreatingconstantwaterow.Toomuchfreeplaywillresultinnon-

operation of the valve with the push-buttons.

4. Note: Water from the drain back tube in the freeze resistant package will continue to run while the valve is actuated.

5.Aftercablesystemisadjustedproperly,stuffexibleinsulationintoanyopeningsbetweentheoutsidewallandtheinteriorbox.

6. Recheck all connections. If all connections are leak free replace cover(s) on the freeze resistant box(es) and fountain(s).

Page 4

EDFPB114FP

98008C (Rev. C - 10/17)

FIG. 6

NOTE:

When installing replacement bubbler and

pedestal, tighten locknut only to hold parts

snug in position. Do Not Overtighten.

SEE FIG. 5

FIG. 5

PARTS LIST

ITEM NO. PART NO. DESCRIPTION

56073C

75669C

56092C

111008343890

70817C

15027C

15025C

28708C

28473C

45767C

28343C

45848C

45821C

56163C

0000000930

45768C

70432C

75560C

Bubbler Assy

Cap Screw - #6-32 x 1.25"

Poly Tubing (Cut To Length)

Screw - #10-24 x .62 HHSM

Fttng - Elbow 1/4 x 1/4

Brkt-Swirlow

Assy-Sleeve/ButtonSwirlo

Basin-Swirlow(Polished)

Lower Shell

Fountain Body

Cover Plate

Button-PushSwirlo

Pin-PushButtonSwirloFP

Gasket - Drain

Assy - Drain/Tailpipe

Drain - Plug 1-1/2

Screw - #8-32 x .38 THTC

Screw - 5/16-18 x 1.00 HHMS

3, 5 15

13 2

LOCKNUT

BASIN

REPAIR SERVICE INFORMATION TOLL FREE NUMBER 1.800.260.6640

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.834.4816

ELKAY MANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 • 630.574.8484 • www.elkay.com

PRINTED IN U.S.A.

NS = NOT SHOWN

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Elkay Freiluftbrunnen Handbücher

Elkay

Elkay SWIRLFLO Series Installationshandbuch

Elkay

Elkay EZWS-EDFPBM117K Gebrauchsanweisung

Elkay

Elkay EFRP8C Installationshandbuch

Elkay

Elkay ERO28C*C Installationshandbuch

Elkay

Elkay LVRCTL8 1D Series Installationshandbuch

Elkay

Elkay EHW214FP Series Installationshandbuch

Elkay

Elkay SwirlFlo ERPA8C Installationshandbuch

Elkay

Elkay 4400FR Series Bedienungsanleitung

Elkay

Elkay VRCTL8S2JOC Installationshandbuch

Elkay

Elkay SWIRLFLO ENOB2-8RAC Gebrauchsanweisung

Elkay

Elkay Soft Sides ERO8C-C Installationshandbuch

Elkay

Elkay 4420BF1UDB Series Bedienungsanleitung

Elkay

Elkay LZO8WSS2KWN Bedienungsanleitung

Elkay

Elkay SOFT SIDES EDFPBM117WS Installationshandbuch

Elkay

Elkay FLEXI-GUARD EFW16 1E Series Installationshandbuch

Elkay

Elkay EDFPVR217RC Installationshandbuch

Elkay

Elkay FGDF710-10-1H-MDN Installationshandbuch

Elkay

Elkay 4420BF1UDBFR Bedienungsanleitung

Elkay

Elkay 4420FR FTN A Series Bedienungsanleitung

Elkay

Elkay EDFPB114C Gebrauchsanweisung

Elkay

Elkay 4400FR Series Bedienungsanleitung

Elkay

Elkay EFRC8CDC-A Installationshandbuch

Elkay

Elkay 4405BFFR Bedienungsanleitung

Elkay

Elkay SWIRLFLO EZWS-EDFPBM114K Installationshandbuch

Beliebte Freiluftbrunnen Handbücher anderer Marken

Sunnydaze Decor

Sunnydaze Decor XSS-578 Bedienungsanleitung

Campania International

Campania International Bibendum FT-400 Bedienungsanleitung

S.R.Smith

S.R.Smith Color Light Stream 2CLSLBK Bedienungsanleitung

Hozelock Cyprio

Hozelock Cyprio Cascade 1500 Bedienungsanleitung

Campania International

Campania International Juliet Fountain Bedienungsanleitung

YARDART

YARDART FT-155 Bedienungsanleitung

Alpine

Alpine WIN732 Bedienungsanleitung

Campania

Campania Valencia Bedienungsanleitung

Campania International

Campania International FT-320 Bedienungsanleitung

GardenWize

GardenWize SWGSL230 Bedienungsanleitung

Kelkay

Kelkay Easy Fountain Rustic Windmill Bedienungsanleitung

Alpine

Alpine WIN258 Bedienungsanleitung

Bond

Bond Signature Series Bedienungsanleitung

Kenroy Home

Kenroy Home 51112COPBL Installationsanleitung

EasyPro

EasyPro Tranquil Décor HBB39 Bedienungsanleitung

Angelo Decor

Angelo Decor Castillo Bedienungsanleitung

Campania International

Campania International Girona FT-102A Bedienungsanleitung

Campania International

Campania International FT-271 Bedienungsanleitung