Emerson Rosemount 3408 Bedienungsanleitung

Quick Start Guide

00825-0200-4418, Rev AA

October 2022

Rosemount™ 3408 Level Transmitter

Replacement of Electronic Deposit Box

1 About this guide

This guide provides instructions for replacing the Electronic Deposit Box

(EDB) on the Rosemount 3408 Level Transmitter. Refer to the Rosemount

3408 Reference Manual for more instructions.

1.1 Safety messages

WARNING

Failure to follow safe installation and servicing guidelines could result in

death or serious injury.

Ensure the transmitter is installed by qualified personnel and in accordance

with applicable code of practice.

For installations in hazardous locations, the transmitter must be installed

according to the Rosemount 3408 Product Certifications document and

System Control Drawing.

WARNING

Explosions could result in death or serious injury.

Before connecting a handheld communicator in an explosive atmosphere,

ensure the instruments are installed in accordance with intrinsically safe or

non-incendive field wiring practices.

In Explosion-proof/Flameproof and Non-Incendive/Type Ex ec installations,

do not remove the transmitter cover when power is applied to the unit.

The transmitter cover must be fully engaged to meet Explosion-proof/

Flameproof requirements.

WARNING

Electrical shock could cause death or serious injury.

Ensure the mains power to the transmitter is off and the lines to any other

external power source are disconnected or not powered while wiring the

transmitter.

WARNING

Process leaks could result in death or serious injury.

Ensure that the transmitter is handled carefully. If the process seal is

damaged, gas might escape from the tank.

Quick Start Guide October 2022

2 Emerson.com/Rosemount

WARNING

Physical access

Unauthorized personnel may potentially cause significant damage to and/or

misconfiguration of end users’ equipment. This could be intentional or

unintentional and needs to be protected against.

Physical security is an important part of any security program and

fundamental to protecting your system. Restrict physical access by

unauthorized personnel to protect end users’ assets. This is true for all

systems used within the facility.

CAUTION

Hot surfaces

The flange and process seal may be hot at high process temperatures. Allow

to cool before servicing.

1.2 Product recycling/disposal

Recycling of equipment and packaging should be taken into consideration

and disposed of in accordance with local and national legislation or

regulations.

October 2022 Quick Start Guide

Quick Start Guide 3

2 Check the model code

Procedure

Check that the model code on the Electronic Deposit Box (EDB) is correct for

the application.

Figure 2-1: EDB Main Label

A. Model code

Quick Start Guide October 2022

4 Emerson.com/Rosemount

3 Replace the Electronic Deposit Box (EDB)

Prerequisites

Make sure that the device is not exposed to moisture or dust.

Procedure

1. Disconnect the power supply.

2. Turn the jam screw clockwise until it is completely threaded into the

housing.

H2.5 mm

3. Remove the cover.

4. Remove the LCD display (if fitted).

October 2022 Quick Start Guide

Quick Start Guide 5

5. Make note of the cable routing and disconnect the cables from the

EDB.

Use a small screwdriver to press down and hold the terminal

connection open.

6. Loosen the three screws on the EDB, and then remove the EDB.

T20

Quick Start Guide October 2022

6 Emerson.com/Rosemount

7. Gently insert the new EDB until it stops, and then firmly push it all the

way in.

8. Tighten the three screws, starting with the screw at position 1.

Torque 20 in-lb (2 N-m)

T20

October 2022 Quick Start Guide

Quick Start Guide 7

9. Connect the cable wires.

Note

When connecting a flexible (stranded) conductor, use a small

screwdriver to press down and hold the terminal connection open.

10. Snap the LCD display into place.

11. Attach and tighten the cover.

Quick Start Guide October 2022

8 Emerson.com/Rosemount

a) Verify the cover jam screw is completely threaded into the

housing.

H2.5 mm

b) Attach and tighten the cover.

Note

Make sure the cover is fully engaged. There should be no gap

between the cover and the housing.

October 2022 Quick Start Guide

Quick Start Guide 9

c) Turn the jam screw counterclockwise until it contacts the

cover.

Note

Required for explosion-proof/flameproof installations only.

H2.5 mm

d) Turn the jam screw an additional ½ turn counterclockwise to

secure the cover.

12. Connect the power supply.

Postrequisites

Re-configure the device.

Quick Start Guide October 2022

10 Emerson.com/Rosemount

Andere Handbücher für Rosemount 3408

Inhaltsverzeichnis

Andere Emerson Sender Handbücher

Emerson

Emerson Rosemount 644h Bedienungsanleitung

Emerson

Emerson Rosemount 3051S Series Konfigurationshandbuch

Emerson

Emerson Rosemount 644 HART Bedienungsanleitung

Emerson

Emerson Rosemount FCL-01 Bedienungsanleitung

Emerson

Emerson Rosemount 5408 Bedienungsanleitung

Emerson

Emerson Rosemount 5081-T Bedienungsanleitung

Emerson

Emerson Rosemount 8750W Bedienungsanleitung

Emerson

Emerson Rosemount 2051HT Bedienungsanleitung

Emerson

Emerson Rosemount 848T Bedienungsanleitung

Emerson

Emerson Rosemount 3051S Series Bedienungsanleitung

Emerson

Emerson Rosemount 1056 Bedienungsanleitung

Emerson

Emerson Rosemount 848T Bedienungsanleitung

Emerson

Emerson Rosemount 648 Bedienungsanleitung

Emerson

Emerson Rosemount 5408 Bedienungsanleitung

Emerson

Emerson Rosemount 1408A Bedienungsanleitung

Emerson

Emerson Rosemount 3051 Series Bedienungsanleitung

Emerson

Emerson Rosemount 3051HT Bedienungsanleitung

Emerson

Emerson Rosemount 3051HT Bedienungsanleitung

Emerson

Emerson Rosemount 3051S Series Bedienungsanleitung

Emerson

Emerson Rosemount 6888A Bedienungsanleitung

Emerson

Emerson Rosemount FCL-01 Bedienungsanleitung

Emerson

Emerson Rosemount 1153 Series B Bedienungsanleitung

Emerson

Emerson Rosemount 702 Bedienungsanleitung

Emerson

Emerson Rosemount 702 Bedienungsanleitung

Beliebte Sender Handbücher anderer Marken

NIVELCO

NIVELCO EasyTREK SCA-300 Series Betriebsanleitung

Honeywell

Honeywell 5816WMBR Bedienungsanleitung

Kamstrup

Kamstrup READy MTU Betriebsanleitung

Omega

Omega ZW Series Bedienungsanleitung

ABB

ABB Field 264H Leitfaden

Alinco

Alinco DJ-V17T Bedienungsanleitung

Dejero

Dejero EnGo 3x Bedienungsanleitung

Rosemount

Rosemount 4600 Bedienungsanleitung

Speaka Professional

Speaka Professional 2342740 Bedienungsanleitung

trubomat

trubomat GAB 1000 Bedienungsanleitung

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Bedienungsanleitung

Rondish

Rondish UT-11 Bedienungsanleitung

MG 10JRE Bedienungsanleitung

Burkert

Burkert 8177 Bedienungsanleitung

Firetide

Firetide HotPort 3203 Handbuch

Tele Radio

Tele Radio T9-02 Bedienungsanleitung

Rotronic

Rotronic HygroFlex HF3 Series Bedienungsanleitung

Jamara

Jamara FCX6 Pro Tel Bedienungsanleitung