Eneo IPD-62M2713MAA Bedienungsanleitung
EN
User Manual
1/2.8” Network Dome, Fix,
1920x1080, Day&Night, DOL-WDR,
2.7-13,5mm, Infrared, IP66
IPD-62M2713MAA
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
To prevent electric shocks and risk of fire hazards, do NOT use other than
specific power source.
Warning :
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Caution :
Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Mains power quality should be that of a typical commercial environment. If the user
of the model requires continued operation during power mains interruptions, it is
recommended that the model be powered from an uninterruptible power supply
(UPS) or a battery.
The symbol is intended to alert the user to the presence of important
operating and maintenance(servicing) instructions in the literature
accompanying the unit.
The symbol is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
Safety Precaution
03
MEGA-PIXEL NETWORK CAMERA
Safety Precaution
04
MEGA-PIXEL NETWORK CAMERA
NOTICE
• The image used in this instruction manual are processed to help comprehension
and may differ from actual video of the camera.
• Avoid installing areas where has shock or vibration which results in the problems.
• Pay attention to safety when laying the connection cable and observe that the cable
is not subjected to heavy loads, kinks or damage and no moisture can get in.
• Never open the device such as boards or lens.
The warranty becomes void if repairs are undertaken by unauthorized persons.
• Maintenance and repair have to be carried out only by authorized service centers.
• Use only a mild detergent to clean the housing body.
• The camera should never be operated beyond the technical specifications.
This can lead to destruction.
• The camera should never be operated in water.
Contents
05
MEGA-PIXEL NETWORK CAMERA
Safety Precaution . . . . . . . . . . . . . . . . . . . . 03~04p
Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 05p
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 06p
Composition . . . . . . . . . . . . . . . . . . . . . . . . . . . 07p
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 07p
Part Names . . . . . . . . . . . . . . . . . . . . . . . . . . . . 08p
Installation Instructions . . . . . . . . . . . . . . . . 09~10p
Operating Instructions . . . . . . . . . . . . . . . . . 13~16p
. . . . . . . . . . . . . . . . . . . . . . . . . 11~12p
Specifications
2-1. Information
2-2. Video & Image
2-3. Event
2-4. System
1. LIVE VIEW
2. SETUP
Full Menu Setup . . . . . . . . . . . . . . . . . . . . . 17~60p
........................................................ 17p
............................................... 19p
......................................... 19p
Troubleshooting . . . . . . . . . . . . . . . . . . . . . 61~62p
.............................................................. 19p
........................................................ 35p
...................................................... 47p
3. 4 EYES PRINCIPLE ................................. 58~60p
Features
06
MEGA-PIXEL NETWORK CAMERA
• Full-HD 2.16Mega Pixel, NETWORK CAMERA, 1920x1080(30/25p)
• The best low light performance with SONY’s STARVIS sensor
• ONVIF Conformance
• ONVIF Event Mapping
• Zero configuration
• Cross Web Browsing (IE, Edge, Safari, Firefox, Chrome)
• Adaptive web resizing depending on layout & resolution of
display device by RESPONSIVE WEB
• Increased usability for all PC, tablet and mobile
• Simultaneously H.264, H.264+ (Smart Stream),
H.265, H.265+ (Smart Stream), MJPEG (Multi streaming)
• f=2.7~13.5mm, Motorized vari-focal lens
• Motorized Zoom & Focus Adjustment
• True Day&Night by ICR
• DOL HDR (Digital Overlap High Dynamic Range)
• D-WDR (Digital Wide Dynamic Range)
• Improved noise figure with the enhanced 3DNR
• LDC(Lens Distortion Compensation)
• Smart Video Stream, ROI(Region of Interest)
- Enables to process video data smartly according
to users demand.
- Lowering overall bandwidth and reduce the storage burden
• Privacy Mask, Motion Detection, HLC/ BLC,
Digital Zoom(~x8), Mirror/Flip, Contrast, Brightness, Hue,
Saturation, Sharpness
• Circuit protection against faulty connection in power polarity
• 3-Axis Gimbal
• Built-in 4pcs High power SMD LEDs
• PoE(IEEE Std. 802.3af) & DC12V
• Cooling Fan & Optimized Heat sink System
• Double side Anti-scratch Hard coated bubble dome
• IP66 / IK10
Composition
07
Dimensions
MEGA-PIXEL NETWORK CAMERA
(unit : mm)
Network Camera
Mounting Template
Operating Instruction
Mounting Screw:
4 x 25mm (4pcs)
Plastic Anchor:
6 x 30mm (4pcs)
L-Wrench (1pc)
Ø144
Ø100
109
60
Part Names
08
MEGA-PIXEL NETWORK CAMERA
Dome Cover
Safety wire ring
Hook
3-Axis Gimbal
Dome Base
Power Cable
3-Axis Gimbal back
: pressing for 5~8 secondsresets
all parameters to original
factory settings.
IP Reset (Default)
Installation Instructions
09
MEGA-PIXEL NETWORK CAMERA
• Extreme care should be taken NOT to scratch the lens and the bubble dome
surface while the camera installing or adjusting.
• Care should be taken the cable is NOT to be damaged, kinked or exposed in
the hazardous area.
• Do not expose the camera directly to a strong light source such as the sun or
spot light.
CAUTION
(Insert the safety wire ring on a hook.
-> Fold the hook not to slip off.)
1. Drill four holes for mounting on the ceiling or wall.
2. Place the dome base at the pre-drilled installation position and fix it by using
mounting screws.
3. Route the power & ethernet cable to the connecting place.
4. Adjust the camera’s viewing angle (Pan, Tilt, Rotation)
5. Hanging a Dome Cover.
6. Assemble the dome cover to the dome base unit.
Mounting Screw
(4x25mm)
Plastic Anchor
(6x30mm)
Installation Instructions
10
MEGA-PIXEL NETWORK CAMERA
Limit of Pan & Tilt
Installation and commissioning Instructions
• Make sure the power is removed before the installation.
• After all connections are finished properly, follow the order for applying power.
a) Plug the network cable into RJ-45 Ethernet Port.
If PoE is the unique power, there will be no need to connect Power jack.
b) When DC12V Local power is necessary, connect the low voltage
(DC12V) first, then plug the DC adapter to DC outlets to avoid an
improper reset from power jitter and a damage from the surge voltage when
no load.
Power Supply Connections
Camera can work with either DC12V or PoE(IEEE Std. 802.3af).
Primary and secondary grounds are completely isolated to avoid the possible
ground loop problems.
► When PoE and Local DC power are connected at the same time,
Local power has priority.
1) Pan limit:
Adjusts the first pan angle by turning
the gimbal 360˚.
2) Tilt limit:
Tilt is limited to 25°min ~ 90°max. with
reference to the ceiling when the
inclination of camera module is 0°, that
is, the image is aligned horizontally.
3) Rotation limit
(Horizontal image alignment):
Adjust the rotation angle by turning
the upper gimbal 360°.
Pan
Tilt
Rotation
• Be careful with the cable twisting
during pan or tilt adjustments.
CAUTION
25º
90º
Andere Handbücher für IPD-62M2713MAA
1
Inhaltsverzeichnis
Andere Eneo Sicherheitskamera Handbücher
Eneo
Eneo EDC-3371 Bedienungsanleitung
Eneo
Eneo VKCD-1311FM/VF Bedienungsanleitung
Eneo
Eneo VKCD-1327ASFM Bedienungsanleitung
Eneo
Eneo NXP-880F Series Bedienungsanleitung
Eneo
Eneo VKC-1361/IR-4.0 Bedienungsanleitung
Eneo
Eneo IPD-78M3611M5A Bedienungsanleitung
Eneo
Eneo IPP-62A0020M0B Bedienungsanleitung
Eneo
Eneo 62M2712M5A Bedienungsanleitung
Eneo
Eneo IPD-72A0003M0A Bedienungsanleitung
Eneo
Eneo 227052 Bedienungsanleitung
Eneo
Eneo 219547 Bedienungsanleitung
Eneo
Eneo IPB-75M3610M0A Bedienungsanleitung
Eneo
Eneo VKC-12140F2810IR Bedienungsanleitung
Eneo
Eneo ICB-62M2712M5A Bedienungsanleitung
Eneo
Eneo IPD-62M2812P0A Bedienungsanleitung
Eneo
Eneo IED-63M2812P0A Bedienungsanleitung
Eneo
Eneo IPD-42M2713PAA Bedienungsanleitung
Eneo
Eneo VKCD-1327WFM/MF Bedienungsanleitung
Eneo
Eneo IEB-74M2812MAA Bedienungsanleitung
Eneo
Eneo 213541 Bedienungsanleitung
