EPOX 6WEA4I Bedienungsanleitung
TRADEMARK
All products and company names are trademarks or registered
trademarks of their respective holders.
These specifications are subjected to change without notice.
Manual Revision 1.0
November 23, 1999
A PA P
A PA P
A Pentiumentium
entiumentium
entium®®
®®
®II or PII or P
II or PII or P
II or Pentiumentium
entiumentium
entium®®
®®
®III Slot1III Slot1
III Slot1III Slot1
III Slot1
PrPr
PrPr
Processor basedocessor based
ocessor basedocessor based
ocessor based AAAAAGGP
GPGP
GP motherboard
(133/100/66MHz)(133/100/66MHz)
(133/100/66MHz)(133/100/66MHz)
(133/100/66MHz)
6WEA4I
Features6WEA4I
Page 2
FEATURES
6WEA4I Features:
• 6WEA4I is based on the Pentium®II or Pentium®III Processor operat-
ing at 350 ~ 733MHz (100/133MHz) on Slot 1. The board is configured
by a BIOS setting to match your CPU clock speed.
• Designed with Intel’s 810E chipset.
• Supports up to 512 MB of DRAM (minimum of 16 MB) on board, You
can use 168-pin DIMM x 2. It will run Synchronous DRAM memory
(SDRAM) at 100MHz.
• 64-bit system memory interface with optimized support for SDRAM at
100MHz.
• Integrated 2D & 3D Graphics Engine, H/W Motion Compensation Engine,
230MHz DAC and 4MB Display Cache.
• AC’97 2.1 Audio CODEC onboard for enables the software Audio.
• Supports (5) 32 bit PCI slots, provides (2) independent high performance
PCI IDE interfaces capable of supporting PIO Mode 3/4 and Ultra DMA
66 devices. The 6WEA4I supports (5) PCI Bus Master slots and a
jumperless PCI INT# control scheme which reduces configuration confu-
sion when plugging in PCI card(s).
• Supports ATAPI (e.g. CD-ROM) devices on both Primary and Secondary
IDE interfaces.
• Designed with Winbond W83627HF LPC (Low Pin Count) I/O: (1) floppy
port, (1) parallel port (EPP, ECP), and (2) serial ports (16550 Fast UART)
• Includes a PS/2 mouse connector.
• Allows use of a PS/2 keyboard.
• Features Award Plug & Play BIOS. With 4MB(FWH) Flash Memory you
can always upgrade to the current BIOS.
Features 6WEA4I
Page 3
• 6WEA4I utilizes a Lithium battery which provides environmental
protection and longer battery life.
• Supports the Universal Serial Bus (USB) connector. The onboard ICH
(82801AA) chip provides the means for connecting PC peripherals such
as; keyboards, joysticks, speaker, and mouse.
• Built-in ATX 20-pin power supply connector.
• Software power-down when using Windows®95/98.
• Supports ring-in feature (remote power-on through external modem, allow
system to be turned on remotely.
• Resume by Alarm - Allow your system to turn on at a preselected time.
• Supports CPU Hardware sleep and SMM (System Management Mode).
• Supports Hot key, Any key or password Keyboard power ON function
(KBPO).
• Supports the CPU, PWR and Chassis fan Auto stop in the sleep mode.
• Supports the System Power LED (PANEL) blinks in the sleep mode.
• Built-in WOL (Wake On Lan) Connector.
• Supports the AMR Connector for enables the software modem.
• Y2K Compliant.
• Advanced Configuration Power Interface (ACPI) ready.
• Supports USDM software to offer motherboard various status on Windows®
95/98.
• Supports the STR (Suspend To RAM) power management by ACPI’s S3.
• Supports the STR indicator red LED (D23) to avoid pluging or un-pluging
DIMM modules when in a STR mode or power on mode.
• Supports ISA Slot.
Installation 6WEA4I
Page 4
Figure 1
6WEA4I Detailed Layout
Installation6WEA4I
Page 5
Easy Installation Procedure
Easy Installation Procedure
The following must be completed before powering on your new system:
Configure Jumpers to match your hardware
System Memory Configuration
Device Connectors
Configure Jumpers
We design this motherboard with the a few jumpers to make your installation fast
and easy.
The following will describe all of the jumpers that you are required to set.
1
JP1 CMOS Clear
JP1 = 1-2 Normal (Default)
= 2-3 Clear CMOS
JP13 Keyboard Power-ON Function
JP13= 1-2 Enabled
= 2-3 Disabled (Default)
1
Installation 6WEA4I
Page 6
JP8 On Board AC’97 Codec Audio
JP8=1-2 Enabled (Default for 6WEA4I)
= 2-3 Disabled
1
AC’97/MR Configuration Table
8PJI4AEW6/4AEW6-PE
2-1 )yramirP(draobnO79'CA
)yradnoceS(CMroRM
3-279'CAdraobnOdelbasiD
)yramirP(CMAroCMroRM
* Audio Codec’97 (AC’97)
** Audio Codec (AC)
*** Modem Codec (MC)
**** Audio/Modem Codec (AMC)
***** Modem Riser Card (MR)
Note: In the BIOS setting, “AC97 Audio” of “Integrated Peripher-
als” must be changed from “Enabled” to “Disabled” as well to
come with JP8 setting (at “2-3” position). (refer to page 4-14).
Installation6WEA4I
Page 7
System Memory Configuration
Memory Layout
The 6WEA4I supports (2) 168-pin DIMMs (Dual In-line Memory Module).
The DIMMs can be either EDO (Extended Data Out) or SDRAM (Synchronized
DRAM).
• 100MHz system memory bus frequency. Even if the system host bus is
66MHz.
• 8MB to 256MB using 16MB/64MB technology (512MB using 128MB
technology).
• 256MB Support Registered synchronous DRAM Memory Modules.
• We recommend to installed the “PC/100MHz SDRAM Spec.”, using
DIMM SDRAM must be 125MHz (-8ns) bus speed. If used 100MHz
(-10ns) SDRAM may be critical timing for the motherboard.
• DIMM SDRAM may be 100MHz (-10ns) or 125MHz (-8ns) bus speed.
Figure 2 and Table 1 show several possible memory configurations using
* SDRAM only supports 16, 32, 64, 128, 256MB DIMM modules.
Table 1
yromeMlatoT 1MMID )1/0knaB( 2MMID )3/2knaB(
BM652= mumixaM
*MARDS ,BM46,BM23,BM61 1XBM652,BM821 enoN
BM215= mumixaM
*MARDS ,BM46,BM23,BM61 1XBM652,BM821
*MARDS ,BM46,BM23,BM61 1XBM652,BM821
DIMM 2
DIMM 1
Bank 2/3
Bank 0/1 -Synchronous
Figure 2
Installation6WEA4I
Page 8
Device Connectors
Please install the motherboard into the chassis.
Now that your motherboard is installed you are ready to connect all your connec-
tions (figure 7).
J2,J3: Chassis Panel Connector
• Keylock, Speaker, Reset, Sleep, Turbo LED and HDD LED
J4: CPU Fan Power
• A plug-in for the CPU Fan Power
J5: Power Supply Fan Monitoring
• A plug-in for the Power supply so that BIOS can monitor the RPM’s
J6: Chassis Fan Power
• A plug-in for the chassis Fan Power
J7: WOL (Wake On Lan) Connector
PW2: ATX Power Connector
• 20-pin power connector
IDE1: Primary IDE Connector
IDE2: Secondary IDE Connector
FDD1: Floppy Controller Connector
CD-IN: CD Audio_IN Connector
• Pin1(CD_IN_Left), Pin2/Pin3(GND), Pin4(CD_IN_Right)
AUX_IN: Auxiliary Line_IN Connector
• Pin1(Left Line_IN), Pin2/Pin3(GND), Pin4(Right Line-IN)
MODEM_IN: Telephony Connector
• Pin1(Audio_in), Pin2/Pin3(GND), Pin4(Mic-out to Modem)
Figure 7
PS/2 Mouse
PS/2
KEYBOARD
COM1 VGA1
parallel port
Speaker
Joystick/Midi
USB port
Line_in
MIC
Installation 6WEA4I
Page 9
Device Connectors (continued)
J2
Speaker - Connect to the system's speaker for beeping
1. Speaker 3. GND
2. N/C 4. GND
Reset - Closed to restart system.
KeyLock - Keyboard lock switch & Power LED connector
1. Power LED(+) 4. KeyLock
2. N/C 5. GND
3. GND
1
1
1
(This is connected to the power button on the case. Using the Soft-
Off by Pwr-BTTN feature, you can choose either Instant Off (turns
system off immediately), or 4 sec delay (you need to hold the button
down for 4 seconds before the system turns off). When the system is
in 4 sec delay mode, there is a special feature to make the system to
go into suspend mode when the button is pressed momentarily.)
Turbo LED indicator - LED ON when higher speed is selected
IDE LED indicator - LED ON when Onboard PCI IDE Hard disks
is activate
J3 1
+
+
IR Connector
1. VCC 4. GND
2. NC 5. IRTX
3. IRRX
1
Power On/Off
* The power LED lights when the
system is powered on and blinks in
SLEEP MODE (Suspend mode).
Inhaltsverzeichnis
Andere EPOX Hauptplatine Handbücher
EPOX
EPOX V370A Bedienungsanleitung
EPOX
EPOX EP-3VBA Bedienungsanleitung
EPOX
EPOX GXA486SPM Bedienungsanleitung
EPOX
EPOX ADE-9040 Bedienungsanleitung
EPOX
EPOX EP-MVP3C Bedienungsanleitung
EPOX
EPOX SiS 661FX Bedienungsanleitung
EPOX
EPOX KP6-LS Bedienungsanleitung
EPOX
EPOX AMD Socket et A Processor based AGP (8X)... Bedienungsanleitung
EPOX
EPOX EP-3VCA2 Bedienungsanleitung
EPOX
EPOX P55-KV Bedienungsanleitung
EPOX
EPOX EP-BX5C Bedienungsanleitung
EPOX
EPOX KP6-LS Bedienungsanleitung
EPOX
EPOX MVP3E Bedienungsanleitung
EPOX
EPOX BX6 Bedienungsanleitung
EPOX
EPOX BXA-M Bedienungsanleitung
EPOX
EPOX EP-6ZXM Bedienungsanleitung
EPOX
EPOX 6VBA-E Bedienungsanleitung
EPOX
EPOX EP-8kem Bedienungsanleitung
EPOX
EPOX MU-8KHA0010 Bedienungsanleitung
EPOX
EPOX IP-4PCI2E Series Bedienungsanleitung
Beliebte Hauptplatine Handbücher anderer Marken
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Bedienungsanleitung
Gigabyte
Gigabyte GA-9IVDT Bedienungsanleitung
Texas Instruments
Texas Instruments ADS8372EVM Bedienungsanleitung
Commell
Commell MS-C73 Bedienungsanleitung
IBT Technologies
IBT Technologies MB860 Bedienungsanleitung
Nvidia
Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung
