2/20
888-24-367-G-00 rev. A • 05/17
WARNING
Impact Hazard!
Moving Parts can Crush and Cut.
Raise monitor to top of vertical
adjustment BEFORE removing.
Failure to heed this warning may
result in serious personal injury or
property damage!
TIPPING HAZARD
Lower cart before moving.
Failure to follow these instructions may
cause cart to tip resulting in equipment
damage and/or personal injury.
828-836-00
ENGLISH
WARNING
IMPACT HAZARD!
MOVING PARTS CAN CRUSH AND CUT.
Failure to heed this warning may result in serious personal
injury or property damage!
www.ergotron.com
Minimize LiftTension BEFORE:
Removing Mounted Equipment, Shipping Cart, Storing Cart.
826-501
14mm (9/16”)
AVERTISSEMENT
DANGER D’IMPACT!
LES PARTIES EN MOUVEMENT PEUVENT ÉCRASER ET COUPER.
Il existe un risque de blessure corporelle ou d’endommagement
matériel en cas de non respect de cet avertissement.
Minimisez la tension d’élévation AVANT:
de retirer l’équipement xé, d’expédier le chariot, de stocker le chariot
CAUTION: Close worksurface before opening drawers. Open only one drawer at a time. Do Not push
cart when drawers or worksurface are open. Failure to follow these instructions may cause the cart to
be unstable.
Features & Specications
Warning: To avoid the potential to pinch cables it is important to follow the cable routing instructions in this manual. Failure to
follow these instructions may result in equipment damage or personal injury.
Caution:
If combined LCD and CPU weight is greater than 27lbs (10.4kg) then the CPU must be mounted to the rear of the cart
using a CPU holder accessory (ordered separately).
Warning: When the height adjustment and assembly are at maximum height this creates a tipping
hazard. Lower work surface before moving cart. Failure to follow these instructions may result in
equipment damage or personal injury.
Important! You will need to adjust this product after installation is complete. Make sure all your
equipment is properly installed on the product before attempting adjustments. This product should
move smoothly and easily through the full range of motion and stay where you set it. If movements
are too easy or difficult or if product does not stay in desired positions, follow the adjustment
instructions to create smooth and easy movements. Depending on your product and the adjustment,
it may take many turns to notice a difference. Any time equipment is added or removed from this
product, resulting in a change in the weight of the mounted load, you should repeat these adjustment
steps to ensure safe and optimum operation.
