AXX 9100 CONNECT R1.2 Quick Reference Guide
3/1531-ZAP 701 14/1 Uen A 2006-10-16
6
Caution!
When installing in an environment where compliance to safety
standard ETS/EN 60950 is required, consider the following:
If not all interconnections can be classified as SELV, the
equipment shelf must only be installed in Restricted Area
Location (RAL) and be permanent connected to safety-ground
via rack or separate ground.
An additionally national requirement apply for Norway, Sweden
and Finland; this equipment must only be installed in Restricted
Area Location (RAL) and be permanent connected to
equipotential bonding.
All interconnected equipment and shielded cabling must be
connected to the same ground potential.
The interfaces cables (especially E1 interfaces) must not run in
the same pipes as the power cables
Plan rack and unit installation based on the following
considerations:
• Install the lowest unit in a rack first. (Recommended clearance
between two units is 50 mm.)
• Determine wire size based on cable length and local engineering
standards and practices.
• Plan the power cable from the power distribution panel (PDP) to
units, proceeding down along the right side of the equipment
rack.
• Plan grounding cable runs from the ground window down along
the right side of the rack to the units.
• Plan to route the electrical cables to and from the units along the
right side of the rack to the overhead cable transport tray.
• Plan to route the optical cables to and from the units along the left
side of the rack to the overhead cable transport tray.
1.4.2.1 Recommended items
To install an AXX 9100 CONNECT system, customary installation
and electrical tools are required. The following items are also
recommended:
