Pan & tilt head connection
Connections are shown on the fold-out drawing.
Do not use other heads than specified in the Compatibility section. The actual pan & tilt
head type is set using the S111SX Node Manager.
Cables should be kept as short as possible and should not exceed 5 meters. When installed
in areas where interference may be present, such as close to high-voltage cables,
transformers, heavy duty motors, electrical trains, radar or radio transmitters, including GSM,
GPRS, cell phone, DECT or similar digital mobile phone base antennas, shielded cable should
be used. Cable shield should be connected to the X5-5 terminal.
In general it is recommended to run the feed-back potentiometer wires, i.e. the wires
connected to X5 in a separate shielded cable, for optimum preset performance.
Motorised lens connection
Connections are shown on the fold-out drawing.
Any motorised lens with two individual wires per function driven by 6 to12 VDC can be
used, however, to ease installation and for optimum Privacy Zone performance the use of the
Ernitec motorised zoom lenses Series Q is highly recommended. Lens drive voltage is set
using the S111SX Node Manager.
Cables should be kept as short as possible and should not exceed 5 meters.
When installed in areas where interference may be present, such as close to high-voltage
cables, transformers, heavy duty motors, electrical trains, radar or radio transmitters, including
GSM, GPRS, cell phone, DECT or similar digital mobile phone base antennas, shielded cable
should be used. Cable shield should be connected to the X3-5 terminal.
AUX-connection
Six auxiliary functions can by operated via the AUX1 to AUX6 relays located on relay board.
The relay contacts are potential free and may be loaded with maximum 230 V, 5 A.
Note, that the relay contacts are un-fused. High voltage wires must be secured with cable
ties to the Cable Anchoring Fingers located on the edge of the board. Cable ties are not
included.
Camera power supply
A fully regulated 12 VDC output with a maximum load of 800 mA for driving e.g. a camera
is available. Connections are shown on the fold-out drawing. The output is over-load
protected.
Other connections
An optional video transmission module for twisted pair or fiber optical cable may be fitted in
the R131VX. Refer to the manual supplied with the module for installation instructions.
Connections X6-1 & 2 and connector J2 are reserved for internal use within Ernitec only.
All jumpers/pin-headers are factory set and should not be altered.
Warning: Do not make any connections to X6-1 or X6-2 and J2. All jumpers/pin-headers
are factory set and must not be altered.
2852-00001 Page 7
