ESCALADE F1120 Technisches Dokument
1
OWNERS ASSEMBLY MANUAL & OPERATING
INSTRUCTIONS
ESCALADE INT. LTD
PRODUCT CODE : F1120 BLK RACING BIKE
Escalade International Limited, Unit 1 Viking Way, Winch Wen Industrial Estate, Swansea.
SA1 7DA. Tel 01792 796893 Fax 01792 796627
Email: [email protected]
2
1 / IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTION BEFORE USING
1. This machine is intended for household use only. It is not designed for commercial use.
2. Read the OWNER’S OERATION MANUAL and all accompanying literature and follow it carefully before using
your machine.
3. Inspect your exercise machine prior to exercising to ensure that all nuts and bolts are fully tightened before
each use.
4. Most exercise equipment is not recommended for small children. Children should not use the machine unless
they are under adult supervision.
5. Exercise equipment has moving parts. In the interest of safety, keep other, especially children, at a safe
distance while exercising.
6. Warm up 5 to 10 minutes before each workout and cool down 5 to 10 minutes afterward. This allows your
heart rate to gradually increase and decrease and will help prevent straining muscles.
7. Never hold your breath while exercising. Breathing should remain at a normal rate in conjunction with the level
of exercise being performed.
8. Rest adequately between workouts. Muscles tone and develop during these rest periods. Beginners should
work out twice a week and increase gradually to 4 to 5 times per week.
9. Remove all jewelry, including rings, chains and pins before commencing exercise.
10. Always wear suitable clothing and footwear during exercise. Do not wear loose fitting clothing that could
become entangled with the moving parts of your exercise machine.
IMPORTANT!!! THE MAXIMUM RECOMMENDED WEIGHT CAPACITY FOR YOUR RACING
CYCLE IS 260 LBS ( 120 KGS) , PER USER
THIS OWNER’S MANUAL CONTAINS ASSEMBLY, OPERATION, MAINTENANCE AND
SAFETY INFORMATION. IN THE INTEREST OF SAFETY, PLEASE MAKE CERTAIN THAT
YOU READ AND UNDERSTAND ALL THE INFORMATION BELOW.
The Surgeon General
Has determined that lack of
Physical activity is
Detrimental to your health
WARNING: Before commencing with any exercise program, please consult your family physician.
If at any time during exercise you feel faint, dizzy or experience pain, stop and consult your family
physician. In the event any of the above mentioned warnings are breached by the consumer, the
manufacturer may use same as a defense to any claim for injuries, damage or loss. The above
warnings are in no way intended to limit or modify the consumer’s remedies for breach of
warranties pursuant to applicable Federal and State Laws of Regulations. They are being supplied
strictly to ensure the safety of the individuals using this product.
The Surgeon General
Has determined that lack of
Physical activity is
Detrimental to your health
WARNING: Before commencing with any exercise program, please consult your family physician.
If at any time during exercise you feel faint, dizzy or experience pain, stop and consult your family
physician. In the event any of the above mentioned warnings are breached by the consumer, the
manufacturer may use same as a defense to any claim for injuries, damage or loss. The above
warnings are in no way intended to limit or modify the consumer’s remedies for breach of
warranties pursuant to applicable Federal and State Laws of Regulations. They are being supplied
strictly to ensure the safety of the individuals using this product.
3
2 / Before you begin
IMPORTANT: Read all instructions carefully. Assemble the RACING BIKE in
accordance with the steps in the manual. Two wrenches are included for assembly.
Lay out all parts on the floor. Make sure that you have all the parts listed below before
beginning assembly. Incase of discrepancy, please call our Customer Service
Department at the numbers listed on front cover page of this owner’s Manual.
4
NO Parts Name QUANTITY
1COMPUTER 1PCS
2SENSOR WIRE 1PCS
3SCREW FOR COMPUTER 2PCS
4INNER COVER FOR HANDLEBAR 1PCS
5FLAT WASHER 2PCS
6SPRING WASHER 2PCS
7BUSHING FOR FIXING HANDLEBAR 1PCS
8HANDLEBAR POST 1PCS
9SCREW 4PCS
10 CURVED WASHER 8PCS
11 TENSION CABLE (UPPER) 1PCS
12 TENSION CABLE (LOWER) 1PCS
13 SENSOR WIRE 1PCS
14 FRONT STABILIZER 1PCS
15 CARRIAGE BOLT 4PCS
16 PEDAL (LEFT & RIGHT) 1SET
17 ACRON NUT 4PCS
18 REAR STABILIZER 1PCS
19 MAIN FRAME 1SET
20 TENSION CONTROLLER 1PCS
21 SEAT POST 1PCS
22 LOCKNUT 3PCS
23 WASHER 3PCS
24 SEAT 1PCS
25 T KNOB 1PCS
26 VHCOVER FOR HANDLEBAR 1PCS
27 ROUND HEX-SCREW 1PCS
28 HANDLEBAR 1PCS
29 SEAT BELLOW 1PCS
F1120 BLK SPARE PARTS
5
Spring Washer
7*2t(2)
Acorn Nut for
M8 Bolt (4)
Flat Washer
7* 12*1t(2)
Allen Bolt
M7*P1.0*30MM (1)
T knob
M7*55MM(1)
Bushing
12*25MM (1)
Carriage Bolt M8*P1.25*75MM (4)
VH COVER (1)
CurvedWasher
Screwdriver 1
SPANNER(1St.)
Allen Key
INNER (1)
PRE
-
ASSEMBLY DRAWING
–
HARDWARE PACK
6
2
11
8
10
13 12
14
15
3
4
5
6
7
16R
10
17
9
16L
18
19
20
21
22
23
24
25
26
27
28
29
52
13 UP
LO
EXPLODED-VIEW ASSEMBLY DRAWING
7
14 15
16R
16L 18
17 10
19
23
22
21
24
19
20
29
STEP 1
1. Connect the FRONT STABLIZER
BAR[ # 14 ]to the MAIN FRAME [ #
19 ] assemble using two CARRIAGE
BOLTS[#15 ], two CURVED
WASHERS [# 10 ] and twoACRON
NUTS [ #17 ]
2. Repeat the same procedure to connect
the REAR STABLIZER BAR [ #18 ]to
the FRAME ASSEMBLY. Firmly tighten
the four bolts byusing CARRIAGE
BOLT [#15] and two CURVED
WASHERS[#10].
3. The PEDALS [#16] are marked “L” and
“R”-Left and Right.
Connect them to their appropriate
Crank Arm [#47]. The right crank arm
is on the right hand side of the cycle as
you sit on it. Note that the Right pedal
should be threaded on clockwise and
the Left pedal on anti-clockwise.
STEP 2
1. Fix the SEAT [# 24] to the SEAT POST
[#21] by using three WASHER [#23]
and three LOCKNUT [#22] located
under the seat, and then insert the
SEAT BELLOW [#29].
2. Insert the SEAT POST [#21] into the
seat post housing and line up the holes
that give the correct seat height. (This
can be done after it has been
assembled.) Secure the SEAT in
position with SEAT-HEIGHT
ADJUSTER [#20]. User can set just
right position to adjust seat-height.
ASSEMBLY INSTRUCTION
8
19
2
8
10
9
11
UP
13 12
13
LO
STEP 3
1. Take the HANDLEBAR POST [#8] and
connect the upper SENSOR WIRE [#11]
and the lower SENSOR WIRE [#12]. Then
connect the bottom of the TENSION
CABLE [#13 UP]and [# 13 LO]
2. Then slide the HANDLEBARPOST[#8]
into the MAIN FRAME [#19] and tighten
by four CURVED WASHER [#10] and
SCREW [#9].
27 54
6
7
2625
8
28
STEP 4
Attach the HANDLEBAR [#28] to the
HANDLEBAR POST [#8] by using the INNER
COVER [#4] (as shown) fix with two FLAT
WASHER [#5] and SPRING WASHER [#6],
ROUND HEX-SCREW [#27], VH COVER
[#26], lastly use T KNOB[#25] tighten.
9
STEP 5
1. Remove the two SCREWS [3] from the back side
of the COMPUTER[#1]. Connect the COMPUTER
to the bracket at the end of the HANDLEBAR
POST [#8] using the two SCREWS. Firmly
tighten the screws
2. Connect the plug at the end of the SENSOR
WIRE[#2] into the back side of the
COMPUTER[#1] where is says ”SENSOR INPUT”
3. Note: You will need to install two “AA” batteries
into the computer before it will work.
.
FINISHED ASSEMBLED BIKE
10
【COMPUTER STYLE: ST7100-7 BLK 】
1. Install 2 x 1.5V or UM-3 batteries to power
the computer. At this moment, the word
"GAME" is flashing andthe word "
MANUAL" is fixed. Use "UP" ("+")and
"DOWN"("-") buttons to select one of
these 2 modes. Press the
"MODE/ENTER" button to fix your
selection Please ignore the flashing word
"LINK". Note, if computer is not in use for
one minute, it will automatically switch off
to save battery power
2. If you select the "GAME" mode, there are 3
games "A", "B" and "C" The letters "B" and
"C" will be flashing. Use "UP" "+") and
"DOWN"("-") buttons to select the games
type, then press the "MODE/ENTER" button
to fix your game selection
COMPUTER OPERATING INSTRUCTIONS
Inhaltsverzeichnis
Andere ESCALADE Heimtrainer Handbücher
Beliebte Heimtrainer Handbücher anderer Marken
Stamina
Stamina 1310 Bedienungsanleitung
American Fitness
American Fitness SPR-BK1072A Bedienungsanleitung
Cateye
Cateye CS-1000 (CYCLO SIMULATOR) Bedienungsanleitung
BH FITNESS
BH FITNESS H9158H Bedienerhandbuch
Body Sculpture
Body Sculpture BC-7220G Bedienungsanleitung
Cateye
Cateye EC-2300 Bedienungsanleitung
