ETS SM1 Series Bedienungsanleitung

ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





LINELevelMicrophoneshavebuiltinpreampsandrequirepowertooperateasshowninFigure1.In

somecasesit’seasiertouseaninterfacebox(SMEA‐1,SMA1‐LPEA,SM2,etc.)topoweraSM1

microphoneandconnecttoIPCameraorDVR.

Figure1ashowdifferenttypesof3.5mmjacksandaRCAjackthatareusedtoconnecttoIPCameras.

TheAvigilonConnectionsshowsthe3.5mmTRRSjackwhichmeansTip,Ring1,Ring2andSleeve.Ifjust

usingamicrophonethenTipisusedforAudioINandRing2isusedforground.With2wayAudiouse

samemicrophoneconnectionsanduseSleeveforAudioOutandRing2forground.Note:groundsare

sharedbetweenaudioinandaudiooutthroughRing2.



Figure2isanexampleofdifferenttypesoflabelsonterminalblockconnectionsonIPCamerasfor

microphoneLineINandMICINinputs.The“someexamples”aresomeofthetypesoflabelweseenon

IPCameraswithterminalblocks.



AMICLevelMicrophonehasnopreampandispoweredbytheIPCamera.Inmostcases,MICLevel

Microphoneshaveastereo3.5mmmaleconnectorwiththeaudiosignalonTIPandRINGwhicharetied

togetherandSLEEVEisground.SomeIPCamerashavemonojacksformonauralMICInputs.CheckIP

camerasspecificationsheetoruser’smanualtoverifyinputismonauralinput.

Figure3showshowtoconnectanETSML1seriesmicrophonetoanIPCamera.

ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





Problem: No audio from microphone or speaker with ETS interface box and IP camera



Possible cause: If your camera utilizes a 3.5mm MONO audio input or audio output the

provided STEREO 3.3mm patch cords cause the audio signal to be shorted. To

correct it, you must cut a wire inside the SMEA-1 or SMA1-LP-XX interface box. The

photos below show how the 3.5MM jacks are wired inside the interface. Remove the

four screws and cover of the interface. Then, locate the jack(s) and cut wire as shown

on the 3.5mm jack(s) below and your system should work. If you have any further

issues or questions, please call technical support at 505-888-3923

M-F 9:50 Mountain time.



3.5mm jack wire uncut 3.5mm jack wire cut



Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

Sony

Sony C-48 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

Shure

Shure WH30TQG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

Shure

Shure KSM141 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

Shure

Shure MXA710 Series Bedienungsanleitung