Extron electronics SW USB Pro Series Bedienungsanleitung

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

speciﬁcations before connecting the

product to the power source.

SW USB Pro Series • Setup Guide

The SW USB Pro Series switchers make it possible for two or four host computers to share and switch among up to four

peripheral USB devices, such as USB storage devices, USB cameras, keyboards, and mice. The switchers support USB 3.2,

2.0, and 1.x host and peripheral devices, with data rates up to 10 Gbps. They are compatible with all major computer operating

systems.

The SW USB Pro Series provide control via front panel buttons, USB, Extron Product Control Software (PCS), Ethernet, RS‑232,

and auto‑switching for integration with any control system. Front panel LED indicators provide immediate visual conrmation of

signal presence for each input and output.

MODEL80

FLATPA NEL

SW2 USB PRO

POWER

--A MAX

12V

HOSTSDEVICESREMOTE

SS 10GSS 10GUSB HID

900 mA

100 mA

USB-C

1.5A

USB-C

RS-232

Tx Rx G

LAN

USBCHARGER

POWER STANDBY

Extron

Cable Cubby 100

Cable Access Enclosure

Extron

SW2 USB Pro

SuperSpeed

USB Switcher

Mouse

USB Mic

USB

Camera

ptop

HDMI

USB

USBUSB

Display

Keyboard

Figure 1. Application Diagram

This guide provides instructions for an experienced installer to set up and operate these switchers.

For full installation,

conguration, and operation details, see the SW USB Pro Series User Guide, available at www.extron.com.

SW USB Pro Series • Setup Guide (Continued)

Rear Panel Features and Connections

AAA

SW2 USB PRO

POWER

1.6A MAX

12V

HOSTS DEVICESREMOTE

SS 10G SS 10G USB HID

900 mA

100 mA

USB-C

1.5A

USB-C

RS-232

Tx Rx G

LAN

DDD

BBBEEEFFFGGGHHHIII

Figure 2. Rear Panel — SW2 USB Pro

SW4 USB PRO

POWER

1.6A MAX

12V

HOSTSDEVICESREMOTE

SS 10G SS 10G USB HID

900 mA

100 mA

USB-C

1.5A

USB-C

RS-232

Tx Rx G

LAN

AAADDD

BBBEEEFFFGGGHHHIII

CCC

Figure 3. Rear Panel — SW4 USB Pro

A 2-pole DC Power connector F Outputs 3 and 4 — USB Type A connectors

for USB 2.0 and 1.x

B USB-C host connectors

C USB Type B host connectors (SW4 USB Pro only) GRemote RS-232 port

D Device 1 — USB-C connector for USB 3.2, 2.0, and 1.xHLAN (Ethernet) connector

E Device 2 — USB Type A connector for USB 3.2, 2.0, and 1.xIReset (R) button and LED

Installation Steps

1. (Optional) Mount the switcher to a rack shelf or furniture.

2. Connect host PCs to the SW USB Pro USB‑C input connectors (see gure 2 or 3, B). The USB‑C host connectors do not

provide power to the connected host PCs.

3. Connect one or more peripheral USB devices (for example, keyboards, mice, or USB cameras) to the SW USB Pro output

device ports (Dthrough F).

If host emulation will be used, attach a standard keyboard or mouse to USB host port 3 or 4 (C). If host emulation is not

used, connect devices to any desired port.

4. (Optional) Connect an RS‑232 cable between the SW USB Pro RS‑232 port (G) and a host computer or control system, or

connect the SW USB Pro Ethernet port (H) to the network via a standard Ethernet cable (see the SW USB Pro Series User

Guide, available at www.extron.com).

Default LAN settings:

• Rear panel LAN IP address — 192.168.254.254

• Front Panel USB-C port IP address — 203.0.113.22 at port 22023

• Subnet mask: 255.255.255.0

• Gateway: 0.0.0.0

• DNS: 0.0.0.0

• Username: admin

• Password: The product unit serial number. If an absolute system reset is performed, all passwords on this device are

reset to extron.

NOTES:

• The computer used for RS‑232 control should not be one of the host devices connected to any of the input ports.

• The LAN IP address can be changed, however, the USB‑C port IP address is fixed at 203.0.113.22 and cannot be

changed.

5. Connect the included power supply to the switcher power connector (see ﬁgures 2 and 4, A).

6. (Optional) Congure the switcher using PCS as necessary for functions such as autoswitching, front panel lock mode, and

emulation (see the SW USB Pro Help File within PCS, available at www.extron.com).

7. Power on the host devices. The switcher is now ready for operation.

Front Panel Features

SW2 USB PRO

USB SWITCHER

EXEC

MODE

AUTO

SWITCH

CONFIG

INPUTS

1 2

STATUS

HOSTS

DEVICES

1234

Figure 4. Front Panel — SW2 USB Pro

SW4 USB PRO

USB SWITCHER

EXEC

MODE

AUTO

SWITCH

CONFIG

INPUTS

STATUS

HOSTS

DEVICES

1234

2 3 4

Figure 5. Front Panel — SW4 USB Pro

A Exec Mode LED D Input selection buttons and LEDs

B Auto Switch LED E Host LEDs

C USB Config port F Device LEDs

A Exec Mode LED — Lights when front panel lock mode has been enabled. This can be configured via PCS or SIS

commands.

B Auto Switch LED — Lights when auto‑switching is enabled. This can be configured via PCS or SIS commands.

C USB Config port — Connect a USB cable (USB Type A to USB‑C) between a computer or control system and this female

USB‑C port to configure the switcher via SIS commands or PCS, and to update the firmware. This USB‑C port uses IP over

USB communication. The port IP address is 203.0.113.22 at port 22023.

D Input selection buttons and LEDs — Press one of these buttons to select an input to switch to the output. The LED at the

right of each button lights when the corresponding input is selected.

If auto‑switching is in effect, these input selection buttons are disabled, but the LEDs continue to light to indicate the

selected input. The input buttons are also used to initiate a system reset and to enable and disable front panel lockout (see

the SW USB Pro Series User Guide for more information).

EHost status LEDs — Light if a host is connected to the corresponding host port, whether or not the input is currently

selected.

FDevice status LEDs — Light when a peripheral device is connected to the corresponding device port and has been

enabled by the selected host.

SW USB Pro Series • Setup Guide (Continued)

68-3537-50 Rev. A

12 21

For information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see the

Extron Safety and Regulatory Compliance Guide on the Extron website.

All trademarks mentioned are the property of their respective owners.

Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876

Andere Handbücher für SW USB Pro Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Extron electronics Schalten Handbücher

Extron electronics

Extron electronics IN1804 Series Bedienungsanleitung

Extron electronics

Extron electronics PVS 405D Bedienungsanleitung

Extron electronics

Extron electronics ISM 824 Bedienungsanleitung

Extron electronics

Extron electronics MMX 62 AV RCA Bedienungsanleitung

Extron electronics

Extron electronics SW2 MTP T 15HD A Bedienungsanleitung

Extron electronics

Extron electronics USB HUB4 Series Bedienungsanleitung

Extron electronics

Extron electronics MediaLink Controllers MLC 104 Series Bedienungsanleitung

Extron electronics

Extron electronics System 5 IP Series Bedienungsanleitung

Extron electronics

Extron electronics VGA MATRIX SWITCHERS MVX PLUS 128 Bedienungsanleitung

Extron electronics

Extron electronics MPS 602 Bedienungsanleitung

Extron electronics

Extron electronics MPS 112 Bedienungsanleitung

Extron electronics

Extron electronics DTP2 CrossPoint 82 Bedienungsanleitung

Extron electronics

Extron electronics SW2 VGA DA2 A Bedienungsanleitung

Extron electronics

Extron electronics FOX 4G SW8 Bedienungsanleitung

Extron electronics

Extron electronics DXP DVI Pro Bedienungsanleitung

Extron electronics

Extron electronics PVT Series Bedienungsanleitung

Extron electronics

Extron electronics System 5cr Plus Bedienungsanleitung

Extron electronics

Extron electronics Converter CVC 200 Bedienungsanleitung

Extron electronics

Extron electronics USB HUB4 Series Bedienungsanleitung

Extron electronics

Extron electronics System 8 Plus Bedienungsanleitung

Extron electronics

Extron electronics DXP HD 4K Series Bedienungsanleitung

Extron electronics

Extron electronics SW MTP T 15HD A Bedienungsanleitung

Extron electronics

Extron electronics YCS SW2 A Bedienungsanleitung

Extron electronics

Extron electronics YCS SW2 A Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung