Fender Downtown Express Bedienungsanleitung

DOWNTOWN EXPRESS

2220191817

13 14121110

1 2 3 4

1. Mute Footswitch & LED

2. Equalizer Footswitch & LED

3. Overdrive Footswitch & LED

4. Compressor Footswitch & LED

5. Master

6. Bass (Equalizer)

7. Middle (Equalizer)

8. Treble(Equalizer)

9. OD/Comp Switch

10. Level (Overdrive)

11. Tone (Overdrive)

12. Drive (Overdrive)

13. Blend (Compressor)

14. Gain (Compressor)

15. Gain Reduction LED

16. Threshold(Compressor)

17. Input Jack

18. Tuner Output Jack

19. Outut Jack

20. XLR Output

21. Ground Lift

22. Signal Path Switch

23. DC Power Connector

24. LED Kill Switch

2423

DOWNTOWN EXPRESS

LEVEL

EQUALIZERMUTE OVERDRIVE COMPRESSOR

BASS TREBLEMIDDLE

DRIVE

EQUALIZER

G.R.

TONE

OVERDRIVE

BLEND THRESHOLD

MASTER

GAIN

COMPRESSOR

OD COMP

COMP OD

SIGNAL PATHXLR OUTPUTINPUT TUNER

OUTPUT

GROUND

LIFT

9V DC

INPUT

LEDs

Thanks for purchasing the Downtown Express—

Your one-stop shop for bass tone-shaping. The

Downtown Express bass multi-effect puts

everything you need for killer bass tone right at

your feet. All the bass essentials are there—

compressor, 3-band EQ and overdrive—each

switchable on its own, or you can use the Mute

switch to kill the signal for silent tuning. The Direct

Output makes it easy to integrate this pedal into

any performance situation—stage or studio. We

recognize that a truly powerful signal chain

needs to be ﬂexible, so we included a switch that

lets you reorder the compressor and overdrive

circuits to taste.

DOWNTOWN EXPRESS

DESIGNED IN CALIFORNIA, U.S.A.

Mute Footswitch & LED

This footswitch mutes your bass’ signal from passing through the

outputs. The LED is illuminated when the Downtown Express is muted.

Equalizer Footswitch & LED

This footswitch bypasses the Equalizer section on the Downtown

Express. The LED is illuminated when the effect is active.

Overdrive Footswitch & LED

This footswitch bypasses the Overdrive section of the Downtown

Express. The LED is illuminated when the effect is active.

Compressor Footswitch & LED

This footswitch bypasses the Compressor section of the Downtown

Express. The LED is illuminated when the effect is active.

Master

This control adjusts the overall volume level.

Bass (Equalizer)

This controls the pedal’s low-frequency response when the Equalizer is

active.

Middle (Equalizer)

This controls the pedal’s midrange response when the Equalizer is

active.

Treble (Equalizer)

This controls the pedal’s high-frequency response when the Equalizer

is active.

OD/Comp Switch

This switch allows you to change the signal path of the Downtown

Express. OD COMP places the Overdrive before the Compressor.

COMP OD places the Compressor before the Overdrive.

Level (Overdrive)

This control adjusts the output volume of the Overdrive section of the

Downtown Express.

Tone (Overdrive)

This control affects the amount of high-frequency (treble) content in

your instrument’s signal. Counter-clockwise sounds are darker, while

the clockwise sounds are brighter.

Drive (Overdrive)

The Drive control adjusts the saturation added to your instrument’s

signal. The overdrive is voiced with Speaker Simulation to create warm,

amp-like drive even when using the XLR Output directly into a console

or playing through a speaker cabinet with a horn.

Blend (Compressor)

The Blend control changes what the player hears when the compressor

section is active. In fully counter-clockwise position, it provides the

original unaffected signal. In fully clockwise position, it provides the

output of the compressor section only.

Gain & Gain Reduction LED (Compressor)

The Gain control affects how much of your bass’ signal is fed into the

compressor circuit. The Gain Reduction LED indicator will change when

gain reduction or compression is occurring.

Threshold (Compressor)

The Threshold control adjusts when the compressor starts to affect the

signal.

Input Jack

This is a high-impedance input ideal for basses, but also suitable for

electric guitars, acoustic guitars with pickup systems, keyboards and

other instruments.

Tuner Output Jack

The Tuner Output Jack lets you keep your tuner active without

interrupting your signal path.

Output Jack

This is a low-impedance output jack that connects to the amp or to the

next effect pedal in a mono signal chain.

XLR Output

This is a balanced output that connects to mixing boards, recording

consoles, or recording interfaces.

Ground Lift

The Ground Lift button lifts the ground in the XLR output to remove any

hum that may be created by unwanted ground loops.

DI Signal Path Switch

This switch lets you decide when your instrument’s signal reaches the

XLR output.

Product speciﬁcations subject to change without notice

Speciﬁcations

IMPEDANCES:

POWER SUPPLY:

POWER REQUIREMENTS:

DIMENSIONS:

WEIGHT:

INPUT: 1MΩ OUTPUT LOAD: >10kΩ

9VDC regulated adapter,

5.5 x 2.1 mm barrel connector, center negative

400mA @ 9VDC

7.4” x 4.9” x 2.5” (187.9mm x 124.5mm x 63.5mm)

1.2lbs (.54kg)

THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO

THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL

INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,

INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

A PRODUCT OF:

FENDER MUSICAL INSTRUMENTS CORPORATION

CORONA, CALIFORNIA, USA

Fender® is a registered trademark of FMIC.

P/N 7715387000 - REV A

Important Safety Instructions

•WARNING: To prevent damage, ﬁre or shock hazard, do not expose the unit or its AC

power to rain or moisture.

•Do not alter the AC plug of the connected power adapter

•Do not drip or splash liquids on the unit.

•No user serviceable parts inside, refer servicing to qualiﬁed personnel only.

• WARNING: The unit must only be connected to a safety agency certiﬁed, regulated,

power source (adapter), approved for use and compliant with applicable local and

national regulatory safety requirements.

• Unplug the AC power adapter before cleaning the unit exterior. Use only a damp cloth

for cleaning and then wait until the unit is completely dry before reconnecting it to power.

• Ampliﬁers and loudspeaker systems, and ear/headphones (if equipped) are capable

of producing very high sound pressure levels which may cause temporary or permanent

hearing damage. Use care when setting and adjusting volume levels during use.

Additional Languages

Manual available in additional languages at:

www.fender.com/support

NOTES:

Inhaltsverzeichnis

Andere Fender Musikpedal Handbücher

Fender

Fender HAMMERTONE DISTORTION Bedienungsanleitung

Fender

Fender MIRROR IMAGE DELAY Bedienungsanleitung

Fender

Fender TREAD-LIGHT 0234555000 Bedienungsanleitung

Fender

Fender HAMMERTONE FLANGER Bedienungsanleitung

Fender

Fender Pinwheel Bedienungsanleitung

Fender

Fender ACOUSTIC PREVERB Bedienungsanleitung

Fender

Fender TRAPPER BASS DISTORTION Bedienungsanleitung

Fender

Fender Smolder Acoustic Overdrive Bedienungsanleitung

Fender

Fender Blender Custom Bedienungsanleitung

Fender

Fender Reflecting Pool Bedienungsanleitung

Fender

Fender MTG: LA Bedienungsanleitung

Fender

Fender Lost Highway Phaser Bedienungsanleitung

Fender

Fender TREAD-LIGHT VOL/EXP PEDAL Bedienungsanleitung

Fender

Fender Pugilist Distortion Bedienungsanleitung

Fender

Fender MUSTANG FLOOR Bedienungsanleitung

Fender

Fender MUSTANG FLOOR Bedienungsanleitung

Fender

Fender Bubbler Chorus Bedienungsanleitung

Fender

Fender LEVEL SET BUFFER Bedienungsanleitung

Fender

Fender HAMMERTONE CHORUS Bedienungsanleitung

Fender

Fender FULL MOON DISTORTION Bedienungsanleitung

Fender

Fender HAMMERTONE METAL Bedienungsanleitung

Fender

Fender TRE-VERB Bedienungsanleitung

Fender

Fender COMPUGILIST Bedienungsanleitung

Fender

Fender MTG Bedienungsanleitung

Beliebte Musikpedal Handbücher anderer Marken

Behringer

Behringer ULTRA WAH UW300 Bedienungsanleitung

Whirlwind

Whirlwind oc-bass Bedienungsanleitung

Strymon

Strymon Lex-rotary Bedienungsanleitung

Behringer

Behringer PB600 Bedienungsanleitung

Lexicon

Lexicon MX200 Bedienungsanleitung

Dunlop

Dunlop Hendrix 68 Shrine Octavio Fuzz Series Bedienungsanleitung

Matthews Effects

Matthews Effects Whaler V2 Bedienungsanleitung

Grid 1

Grid 1 Pedal Jeanie Bedienungsanleitung

Amptweaker

Amptweaker tightboost Bedienungsanleitung

Ibanez

Ibanez TS-808 Tube Screamer Overdrive Pro Bedienungsanleitung

Dimavery

Dimavery EPVP-50 Bedienungsanleitung

Tefi Vintage Lab

Tefi Vintage Lab GEGÈ Bedienungsanleitung

Pro-MIDI

Pro-MIDI G25 Bedienungsanleitung

DW 7000 Bedienungsanleitung

FAMC

FAMC Liquid-Foot Jr. Series Bedienungsanleitung

Dimavery

Dimavery EPOD-50 Overdrive Bedienungsanleitung

TREX

TREX ToneBug Totenschläger Bedienungsanleitung

BBE

BBE ORANGE SQUASH Bedienungsanleitung