Fenix LD32 UVC Bedienungsanleitung

Fenix LD32 UVC user manual

LD32 UVC Size:

Length: 4.76” (121mm)

Head: 1.0” (25.4mm)

Body: 0.90” (23mm)

LD32 UVC Weight:

2.54 oz. (72g) excluding battery

LD32 UVC Battery:

One 18650 rechargeable Li-ion battery (included) or two CR123A batteries

Included:

ARB-L18-3500U Li-ion battery, micro USB charging cable, body clip, lanyard, holster, 2 x

spare O-rings

1200 lumens maximum output; 170 meters maximum beam distance.

Uses Cree XHP 35 white LED, with a lifespan of 50,000 hours.

Included Fenix ARB-L18-3500U Li-ion battery, two CR123A Lithium batteries can be

used as well.

Toughened ultra-clear glass lens effectively reduces light loss.

Utilizes high-efficiency Liteon LED; 10mW UVC light for disinfection.

Triple safe designs of protective switch cover, dual switch and timed force off.

Battery level indication for instant checking of remaining battery level.

Made of durable A6061-T6 aluminum.

Premium type HAIII hard-anodized anti-abrasive finish.

Switches

The round is for on/off, output selection; the side switches are for UVC light on/off.

On/off

Press and hold the round switch for 0.5 seconds to turn on/off the light.

Output Selection

With the light switched on, single click the round switch to cycle through

Low→Med→High→Turbo.

Strobe

With the light switched on, press and hold the round switch for 1.2 seconds to enter Strobe, single

click again to turn back to the previously used output level.

With the light switched off, press and hold the round switch for 1.2 seconds to enter Strobe, single

click to exit.

Lock/Unlock

Lock: with the light unlocked and switched off, double click the round switch to lock the light in

0.5 seconds, the light will blink twice on Low to indicate locked status.

Unlock: with the light locked and switched off, double click the round switch in 0.5 seconds, the

light will be unlocked and activated on Low.

In locked status, clicking or pressing the switch will activate 2 one-second blinks on Low to

indicate locked status.

UVC Light

With the light switched off, unscrew the protective cover to reveal the UVC light; and aim the

object to be disinfected at a distance of about 2 cm. Simultaneously press the side switches to

activate the disinfection function.

Operation Cautions:

1. A disinfection cycle remains up to 30 seconds, after working for this time or releasing any

UV switch, the UVC light will go out. Release the side switches and simultaneously press

again for the reselection of the UVC light.

2. An extra blue indicator will be lit to indicate the effective disinfection range since the

UVC light is invisible while working.

3. The UVC light is quite dangerous to human and animal cells. It is strictly prohibited to

shine the UVC light into the eyes, human body and animal. This flashlight should be

placed beyond the reach of children.

4. The intensity of UVC light will attenuate along with distance. Therefore the light should

not be kept too far away from the surface of the disinfected object to avoid a poor

disinfection effect. When disinfecting a large area, divide it into areas and disinfect them

one by one.

5. After the protective cover is unscrewed, it can be screwed to the light tail to avoid loss.

After using, the protective cover should be replaced to maintain the protective

performance of the flashlight and avoid potential safety hazards caused by accidentally

activating the UVC light.

Intelligent Memory Circuit

The light memorizes the last selected output of general mode. When turned on again the

previously used output of general mode will be recalled.

Battery Specifications

Type Dimensio

Nominal

voltage

Usability

Fenix ARB-L18 Series 18650 3.6 V / 3.7V Recommended√√

Non-rechargeable Battery

(Lithium)

CR123A 3V Usable √

Rechargeable Battery (LiFePO4) 16340 3.2V Usable √

Rechargeable Battery (LiFePO4) 18650 3.2V Usable √

Rechargeable Battery (Li-ion) 18650 3.6 V / 3.7V Caution* ！

Rechargeable Battery (Li-ion) 16340 3.6 V / 3.7V Banned ×

Warning: *18650 Li-ion batteries are powerful cells designed for commercial applications and

must be treated with caution and handled with care. Only use quality batteries with circuit

protection will reduce the potential for combustion or explosion; but cell damage or short

circuiting are potential risks the user assumes.

Battery Replacement

Unscrew the light head to insert the battery with the anode side (+) towards the light head, then

screw the light head back on.

Battery Level Indication

With the light switched off, single click the side switch to check the battery status, the indicator

will last for 3 seconds.

Green light on: saturated 100% – 85%

Green light flashes: sufficient 85% – 50%

Red light on: poor 50% – 25%

Red light flashes: critical 25% – 1%

Note: This only works with Fenix ARB-L18 Series 18650 rechargeable Li-ion battery.

Intelligent Overheat Protection

The light will accumulate a lot of heat when used on Turbo output level for extended periods.

When the light reaches a temperature of 60°C or above, the light will automatically step down a

few lumens to reduce the temperature. When the temperature drops below 60°C, it will then allow

the user for the reselection of Turbo mode.

Low-voltage Warning

When the voltage level drops below the preset level, the flashlight is programmed to downshift to

a lower brightness level until Low output is reached. When this happens in Low output mode, the

battery level indicator blinks red to remind you to timely recharge or replace the battery.

Note: This only works with Fenix ARB-L18 18650 Li-ion battery.

Usage and Maintenance

Disassembling the sealed head can cause damage to the light and will void the warranty.

Fenix recommends using an excellent quality battery.

If the light will not be used for an extended period, remove the battery, or the light could

be damaged by electrolyte leakage or battery explosion.

Lock the light or remove the battery to prevent accidental activation during storage or

transportation.

Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring

with an approved spare．

Periodic cleaning of the battery contacts improves the lamp’s performance as dirty

contacts may cause the lamp to flicker, shine intermittently or even fail to illuminate for

the following reasons:

A: The battery needs replacing.

Solution: Replace battery pack / battery (Ensure battery is inserted according to the

manufacturer’s specifications).

B: The threads, PCB board contact or other contacts are dirty.

Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.

If the above methods don’t work, please contact your authorized distributor.

Warning

This flashlight is a high-intensity lighting device capable of causing eye damage to the

user or others. Avoid shining the flashlight directly into anyone’s eyes.

This flashlight will accumulate a lot of heat when used for extended periods, resulting in

high temperature of the flashlight shell. Pay attention to safe use to avoid scalding.

The UVC light is quite dangerous to human and animal cells. It is strictly prohibited to

shine the UVC light into the eyes, human body and animal. This flashlight should be

placed beyond the reach of children.

All information provided in this manual is subject to change without prior notice.

Inhaltsverzeichnis

Andere Fenix Taschenlampe Handbücher

Fenix

Fenix HL30 Bedienungsanleitung

Fenix

Fenix LD41 Bedienungsanleitung

Fenix

Fenix RC10 Bedienungsanleitung

Fenix

Fenix PD35TAC Bedienungsanleitung

Fenix

Fenix LD02 V2.0 Bedienungsanleitung

Fenix

Fenix C7 Bedienungsanleitung

Fenix

Fenix LD15R Bedienungsanleitung

Fenix

Fenix TK16 V2.0 Bedienungsanleitung

Fenix

Fenix TK32 Bedienungsanleitung

Fenix

Fenix ARB-L21 Series Bedienungsanleitung

Fenix

Fenix TK65R Bedienungsanleitung

Fenix

Fenix TK25 Bedienungsanleitung

Fenix

Fenix RC10 Bedienungsanleitung

Fenix

Fenix TK70 Bedienungsanleitung

Fenix

Fenix E-CP Bedienungsanleitung

Fenix

Fenix TK22UE Bedienungsanleitung

Fenix

Fenix TK26R Bedienungsanleitung

Fenix

Fenix E LITE Bedienungsanleitung

Fenix

Fenix TK35 Bedienungsanleitung

Fenix

Fenix TK20R Bedienungsanleitung

Fenix

Fenix TK15UE Bedienungsanleitung

Fenix

Fenix TK40 Bedienungsanleitung

Fenix

Fenix LD12 Bedienungsanleitung

Fenix

Fenix E-SPARK Bedienungsanleitung

Beliebte Taschenlampe Handbücher anderer Marken

StreamLight

StreamLight PROPOLYMER 2AA Bedienungsanleitung

StreamLight

StreamLight Stinger Bedienungsanleitung

Silverline

Silverline 994024 Bedienungsanleitung

Gama Sonic

Gama Sonic 23i60065 Bedienungsanleitung

Ryobi

Ryobi RFL180M Bedienungsanleitung

RIB

RIB SPARK ACG7061 Bedienungsanleitung

Abicor Binzel

Abicor Binzel MB EVO PRO Series Bedienungsanleitung

PELI

PELI 7610 Bedienungsanleitung

Black & Decker

Black & Decker FSL18 Bedienungsanleitung

Black & Decker

Black & Decker 9506 Bedienungsanleitung

Berner

Berner 341709 Bedienungsanleitung

PELI

PELI 3415 Zone 0 Bedienungsanleitung

ADC

ADC Adlite Pro Wartungshandbuch

Fervi

Fervi 0338 Bedienungsanleitung

Milwaukee

Milwaukee M18 IL Bedienungsanleitung

Spectronics

Spectronics Spectroline LeakTracker SPI-LT Bedienungsanleitung

Larson Electronics

Larson Electronics SLEDB-110V-M Bedienungsanleitung

vulta

vulta hurricane 262 lumen fg-e15 Bedienungsanleitung