Fenix TK72R Bedienungsanleitung

Fenix TK72R Flashlight

Technical Parameters

Notice: The abovementioned parameters (lab-tested by using Fenix ARB-L 5-1 000 rechargeable

Li-ion battery pack) may vary between environments and flashlights.

Due to the protective downshifting setup of intelligent overheat, refer to the runtime graph to

check actual runtime.

Uses 3 Cree XHP70 LED with lifespan of 50,000 hours - max 9000 lumens

Included 7.2V/7000mAh Li-ion battery pack

156mm Length x 59mm Head diameter x 50mm Body diameter

12 grams (excluding battery)

OLED digital screen displays: output, runtime, battery status

Micro USB charging, USB discharging

Inner waterproofing treatment of USB&Micro USB port

Three switches in the neck - easy and fast operation

Three output modes: Low, High and Memory

Instant Turbo

ANSI/PLATO FL1

General Mode Flash Mode

Highest Lowest Strobe

Output

9000 Lumens 100 Lumens 000 Lumens

Runtime

50min 50h /

Distance

286m 31m /

Intensity

20,500cd 2 0cd /

Impact

Resistance

aterproof

IP68, underwater 2m

Lockout function

Low-voltage warning function

Digitally regulated output maintains constant brightness

Intelligent overheat protection protects from high surface temperature

Reverse polarity protection to protect from improper battery insertion

Made of durable high-strength and oxidation-resistance aluminum

Premium type HAIII hard-anodized anti-abrasive finish

Toughened ultra-clear glass lens with an anti-reflective coating

Operation Instructions

With the light off, press and hold the switch for 0.5 seconds to turn on the light with the last

used brightness.

With the light off, press and hold the switch for 0.5 seconds to turn on the light with 200-

lumen output.

With the light off, press and hold the switch for 0.5 seconds to turn on the light with 5000-

lumen output.

OFF

With the light on, press and hold the switch for 0.5 seconds to turn off the light.

Output Selection

With the light turned on:

(1) Output ranges from 100 lumens to 9000 lumens

(2) Single click the switch , for each single clicking, the output will increase 100 lumens. Press

switch over 0.5 seconds, then the output will increase 1000 lumens for each pressing.

(3) Single click the switch , for each single clicking, the output will decrease 100 lumens. Press

switch over 0.5 seconds, then the output will decrease 1000 lumens for each pressing.

Strobe

In any status, press and hold the switch over 1.2 seconds to enter strobe, click once again to

return to the last used brightness.

Instant Turbo

With the light switched on, single click the switch to enter Turbo, click once again to return

to the last used brightness.

Lockout Function

Lock: With the light switched off and unlocked, continuously click the switch twice within

0.5 seconds, the OLED screen will display locking icon, indicating the light enters locked status.

Unlock: With the light switched off and locked, continuously click the switch twice within

0.5 seconds, the light will be unlocked and activated on last used brightness.

In locked status, clicking or pressing any switch, the light will be unresponsive to indicate locked

status.

Battery Level Indication

With the light switched off, single click the switch , the OLED screen will display the battery

status percentage, and then goes out in 5 seconds.

Charging and Power Bank Function

Charging: Plug the USB side of the charging cable into the any USB power supply, uncover the

anti-dust cap of the light. And plug the Micro USB side of the charging cable into the charging

port of the light. When charging the OLED screen will display charging icon, and current battery

level will be displayed. The normal charging time is about 6 hours.

Power bank function: Plug the USB side of any digital device into the USB side of the light. Then

the light will display discharging icon when discharging begins. The max discharging current is 2A.

Note:

1. The light can be turned on when it is in charging and discharging status, but only 100 lumens

output can be reached.

2. Once charging is completed, be sure to remove the charging cable and replace the anti-dust

cap to protect from dust and foreign objects.

3. Recharge a stored light every four months to maintain optimum performance of the battery.

Intelligent Memory Circuit

The light memorizes the last selected brightness level on General mode. When turned on again

the previously used brightness level will be recalled.

Intelligent Overheat Protection

The light will accumulate a lot of heat when it is working at high output levels. When the light is

overheated up to 65 or above, the output will be automatically downshifted by the step of℃

1000 lumens until 2500 lumens is reached to reduce the temperature. High output levels can be

reselected by pressing switch when the temperature is lowered than 65 ℃.

Low-voltage arning

When the voltage level drops below the preset level, the flashlight is programmed to downshift

by the step of 1000 lumens until 100 lumens is reached. Until the battery protection circuit

activates to turn off the flashlight.

Battery Specifications

The standardly configured battery is ARB-L 5-1 000 (7.2V/7000mAh), Fenix batteries with the

same type can be used.

Battery Replacement

Unscrew the tail cap to insert the included battery which features reverse polarity protection,

so the anode can be neglected, then screw the tail cap back on.

Included

1 x TK72R flashlight, 1 x ARB-L 5-1 000 battery, 1 x Lanyard, 1 x Holster, 2 x Spare O-rings, 1 x

Micro USB charging cable, 1 x Adaptor, 1 x User manual, 1 x Warranty card

Usage and Maintenance

Disassembling the sealed head can cause damage to the light and will void the warranty.

Unscrew the tail cap half a turn or take out the battery to prevent accidental activation

during storage or transportation.

Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring

with an approved spare．

Periodic cleaning of the battery contacts improves the lamp's performance as dirty contacts

may cause the lamp to flicker, shine intermittently or even fail to illuminate for the following

reasons:

A: The battery needs replacing.

Solution: Replace battery (Ensure battery is inserted according to the manufacturer’s

specifications).

B: The threads, PCB board contact or other contacts are dirty.

Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.

If the above methods don't work, please contact your authorized distributor.

arning

This flashlight is a high-intensity lighting device capable of causing eye damage to the user or

others. Avoid shining the flashlight directly into anyone’s eyes.

Inhaltsverzeichnis

Andere Fenix Taschenlampe Handbücher

Fenix

Fenix LD32 UVC Bedienungsanleitung

Fenix

Fenix LD12 Bedienungsanleitung

Fenix

Fenix TK22UE Bedienungsanleitung

Fenix

Fenix LD05 Bedienungsanleitung

Fenix

Fenix LD02 V2.0 Bedienungsanleitung

Fenix

Fenix LD15R Bedienungsanleitung

Fenix

Fenix RC10 Bedienungsanleitung

Fenix

Fenix ARB-L21 Series Bedienungsanleitung

Fenix

Fenix TK22 TAC Bedienungsanleitung

Fenix

Fenix LD10 Bedienungsanleitung

Fenix

Fenix E-SPARK Bedienungsanleitung

Fenix

Fenix TK28 TAC Bedienungsanleitung

Fenix

Fenix LD41 Bedienungsanleitung

Fenix

Fenix PD35TAC Bedienungsanleitung

Fenix

Fenix TK45 Bedienungsanleitung

Fenix

Fenix E05R Bedienungsanleitung

Fenix

Fenix UC52 Bedienungsanleitung

Fenix

Fenix E LITE Bedienungsanleitung

Fenix

Fenix PD32 Technisches Handbuch

Fenix

Fenix UC30 2017 Bedienungsanleitung

Fenix

Fenix E25 Bedienungsanleitung

Fenix

Fenix TK35 Bedienungsanleitung

Fenix

Fenix TK32 Bedienungsanleitung

Fenix

Fenix TK15UE Bedienungsanleitung

Beliebte Taschenlampe Handbücher anderer Marken

StreamLight

StreamLight PROPOLYMER 2AA Bedienungsanleitung

StreamLight

StreamLight Stinger Bedienungsanleitung

Silverline

Silverline 994024 Bedienungsanleitung

Gama Sonic

Gama Sonic 23i60065 Bedienungsanleitung

Ryobi

Ryobi RFL180M Bedienungsanleitung

RIB

RIB SPARK ACG7061 Bedienungsanleitung

Abicor Binzel

Abicor Binzel MB EVO PRO Series Bedienungsanleitung

PELI

PELI 7610 Bedienungsanleitung

Black & Decker

Black & Decker FSL18 Bedienungsanleitung

Black & Decker

Black & Decker 9506 Bedienungsanleitung

Berner

Berner 341709 Bedienungsanleitung

PELI

PELI 3415 Zone 0 Bedienungsanleitung

ADC

ADC Adlite Pro Wartungshandbuch

Fervi

Fervi 0338 Bedienungsanleitung

Milwaukee

Milwaukee M18 IL Bedienungsanleitung

Spectronics

Spectronics Spectroline LeakTracker SPI-LT Bedienungsanleitung

Larson Electronics

Larson Electronics SLEDB-110V-M Bedienungsanleitung

vulta

vulta hurricane 262 lumen fg-e15 Bedienungsanleitung