FIKE CORPORATION PREFACE
U.L. S2203 Expanded Enclosures Installation Guide Page 1 of 23
F.M. 3009544 Manual P/N: 06-185 Revision No: 1, 11/01
1.0 PREFACE
1.1 ABOUT THIS MANUAL
This manual is intended to be a complete reference for the overview and installation of the Fike
Expanded Enclosures. For specific instructions regarding wiring, refer to the specific Control Panel
Manual. This manual is intended for the designer and installer.
Before you refer to any section in this manual, and before you attempt to install or use the Fike
electronic hardware, be sure to read the important User Information that follows this explanation.
1.2 PRODUCT SUPPORT
If you have a question or encounter a problem not covered in this manual, you should first try to
contact the sales outlet that sold the protection system. Fike has a worldwide distribution network.
Each sales outlet sells, installs, and services Fike equipment. Look on the inside door, left-side, there
should be a sticker with an indication of the sales outlet who sold the system. If you can not locate
the sales outlet, please call Fike Customer Service for locating your nearest sales outlet, or go to our
web-site at www.fike.com. If you are unable to contact your installing sales outlet or you simply do not
know who installed the system you can contact Fike Product Support at (816) 229-3405, Monday
through Friday, 8:00 a.m. to 5:00 p.m. CST.
1.3 REVISION HISTORY
Document Title: Fike Expanded Enclosure Installation Guide
Document Reorder Number: 06-185
Revision Section Date Reason for Change
0 All Sections 02 / 01 Initial Release
1 All Sections 09 / 01 Added Shark Information
1.4 TERMS USED IN THIS MANUAL
The following terminology is used frequently in this manual:
Term Description
Non-Power Limited A circuit designation given for wiring purposes. The amount of current
flowing through the circuit is unlimited vs. being limited, or power-limited.
Power Limited A circuit designation given for wiring purposes. The amount of current
flowing through the circuit is limited vs. being unlimited, or non-power limited.
Press Stud The backbox, door, and mounting plates all have 6-32 thread mounting studs
installed into the metal at appropriate mounting locations. This provides a
sturdy location for securing the equipment.
Stand-off An aluminum or metal extension piece to provide spacing between mounting
assemblies. Fike chooses a 6-32 thread for its stand-off spacers. The
pieces are typically referred to by the type of connection at each end of the
part:
Male (M) – extension spacer with threaded screw end for use with
connecting hex nut or female end of an additional standoff
Female (F) – extension spacer with threaded insert end for use with
connecting to press stud or male end of an additional spacer.
