Fitbill B613 Bedienungsanleitung
1
FITBILLTM BIKE B613
2
Dear Customer,
Please read this instruction very carefully before using this item.
You will find important information regarding safety of your
exercise bike.
Note the following precaution before assembling or
operating the machine.
1. Keep children and pets away from the bike at all times. DO NOT leave
unattended children in the same room with the machine.
2. Handicapped or disabled persons should not use the bike without the
presence of a qualified health professional or physician.
3. If the user experiences dizziness, nausea, chest pain, or any other
abnormal symptoms, STOP the workout at once. CONSULT A PHYSICIAN
IMMEDIATELY.
4. Before beginning training, remove all within a radius of 2 meters from
the machine. DO NOT place any sharp objects around the bike.
5. Position the bike on a clear, level surface away from water and
moisture. Place mat under the unit to help keep the machine stable and
to protect the floor.
6. Use the bike only for its intended use as described in this manual. DO
NOT use any other accessories not recommended by the manufacturer.
Assemble the machine exactly as the descriptions in the instruction
manual.
7. Check all bolts and other connections before using the machine for
the first time and ensure that the trainer is in the safe condition.
8. Hold a routine inspection of the equipment. Pay special attention to
components which are the most susceptible to wear off, i.e. connecting
3
points and wheels. The defective components should be replaced
immediately. The safety level of this equipment can only be maintained
by doing so. Please don't use the bike until it is repaired well.
9. NEVER operate the bike if it is not functioning properly.
10. This machine can be used for only one person’s training at a time.
11. Do not use abrasive cleaning articles to clean the machine. Remove
drops of sweat from the machine immediately after finishing training.
12. Always wear appropriate workout clothing when exercising. Running
or aerobic shoes are also required.
13. Before exercising, always do stretching first.
14. The power of the machine increases with increasing the speed, and
the reverse. The machine is equipped with adjustable knob, which can
adjust the resistance.
WARNING: BEFORE BEGINNING THIS OR ANY EXERCISE
PROGRAM, CONSULT YOUR PHYSICIAN FIRST. THIS IS
ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE
OF 35 OR PERSONS WITH PRE-EXISTING HEALTH
PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING THE
SPINNING BIKE. THANE ASSUMES NO RESPONSIBILITY
FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTA I N
E D BY OR THROUGH THE USE OF THIS PRODUCT.
4
EXPLODED-VIEW & PARTS LIST：
5
6
7
8
FIG.1
ASSEMBLY INSTRUCTION:
1.PREPARATION:
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the
above of this instruction sheet you will find an explosion drawing with all single
parts (marked with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTION:
FIG.2
FIG.2:
Put the Vertical Seat Post (pt.4) slip into
the seat post tube on the Main Frame.
You will have to slacken the Knob
(pt.22) and pull the knob back. Then
select the desired height. Release the
knob and re-tighten the knob. Then put
the Seat Post (pt.5) slip into the Vertical
Seat Post (pt.4), use the Knob (pt.30)
and the Flat Washer (pt.31) to lock.
Finally,the Seat (pt.8) fixed on the
Seat Post (pt.5) as shown, and lock
the nuts under the seat.
FIG.1:
Lock the Front Stabilizer (pt.3) to the
Main Frame (pt.1) with two sets of Ø8
Flat Washer (pt.19), M8 Domed Nut
(pt.18) and M8*42 Carriage Bolt (pt.14).
Lock the Rear Stabilizer (pt.2) to the
Main Frame (pt.1) with two sets of Ø8
Flat Washer (pt.19), M8 Domed Nut
(pt.18) and M8*42 Carriage Bolt (pt.14).
9
FIG.3
FIG.4
FIG.3:
Put the Handlebar Post (pt.6) slip into the handlebar post tube on the main frame. You will
have to slacken the Knob (pt.22) and pull the knob back. Then select the desired height.
Release the knob and retighten the knob.
Then the Handlebar (pt.7) and the Computer Holder (pt.75) fixed on the Handlebar Post
(pt.6) with four sets of Bolt (pt.28) and Spring Washer (pt.27).
The Mobile Phone Holder (pt.84) fixed on the handlebar with the Bolt (pt.85).The Sensing
Line (pt.76) and Bluetooth Transmitters/ESCONN (pt.83) connection,and the Bluetooth
Transmitters/ESCONN (pt.83) have magnetic can be fixed on the main frame.
ATTENTION: YOU SHOULD FIX THE HANDLEBAR TIGHTLY
FIG.4:
The Pedals (pt.9L & pt.9R) are marked
"L" and "R" - Left and Right.
Connect them to their appropriate crank
arms. The right crank arm is on the
right- hand side of the cycle as you sit
on it.
Note that the Right pedal should be
threaded on clockwise and the Left
pedal anticlockwise.
10
FIG.A
FIG.B
A.) Adjusting the Tension:
Increasing or decreasing the tension
allows you to add variety to your
workout sessions by adjusting
the resistance level of the bike.
To increase tension and increase
resistance (requiring more strength to
pedal), turn the Emergency Brake &
Tension Control Knob (pt.32) to the
right.
To decrease tension and increase
resistance (requiring less strength to
pedal), turn the Emergency Brake &
Tension Control Knob (pt.32) to the
left.
B.) Using the Emergency Brake
Function:
The same knob that allows you to
adjust the tension of the bike also
doubles as the Emergency
Brake. Use this safety feature in any
situation where you would need to get
off the bike and/or
stop the bike’s flywheel.
To use the Emergency Brake function
in any situation you would need it in,
firmly press down on the Emergency
Brake & Tension Control Knob (pt.32).
Inhaltsverzeichnis
Beliebte Heimtrainer Handbücher anderer Marken
Stamina
Stamina 1310 Bedienungsanleitung
American Fitness
American Fitness SPR-BK1072A Bedienungsanleitung
Cateye
Cateye CS-1000 (CYCLO SIMULATOR) Bedienungsanleitung
BH FITNESS
BH FITNESS H9158H Bedienerhandbuch
Body Sculpture
Body Sculpture BC-7220G Bedienungsanleitung
Cateye
Cateye EC-2300 Bedienungsanleitung
