Fluke TS22 Bedienungsanleitung

PN 2322420

October 2005

TS®22/TS®22A Test Set Users Card

Key Function

STO Stores the last number dialed in memory.

(18 digits maximum; 9 locations).

PSE Places a 4-second pause between numbers being

entered into memory. The pause occurs when the

stored numbers are redialed, and is used to access

second dial tone when dialing through a PBX.

RCL Recalls a number stored in memory.

LNR Redials the last number called. This feature works in

Tone or Pulse modes.

Replacing the Monitor Speaker Battery

A 9 V alkaline battery powers the Amplified Speaker or

Speakerphone. If the battery is low, the test set will not

enable the TALK (off-hook) mode. Replace the battery if

the test set does any of the following:

• Fails to operate

• Operates intermittently

• Sounds distorted

To replace the battery

1Remove the three screws from the battery cover.

2Remove the battery cover.

3Lift out the battery retainer.

4Remove the battery from the battery boot and install

a new alkaline or lithium 9 V battery.

5Replace the battery boot, retainer, cover, and screws.

Strain relief ring must be inside the case as shown.

Avoid pinching the battery wires.

Replacing the Belt Clip

Basic Operation

1Select the dial signaling required (touch tone or pulse)

with the TONE/PULSE switch.

2Set the TALK/MONITOR switch to Mand connect the

test set to the line. Listen to verify the line is idle. The

test set's high impedance prevents disruption of data

traffic when connected to a line in monitor mode.

3Set the TALK/MONITOR switch to T, and verify that

dial tone is received.

4Dial the number to be called. To terminate the call

during or after dialing, set the TALK/MONITOR switch

to M.

Last Number Redialed

In Tone or Pulse mode, the last number dialed can be

redialed by pressing the LNR key after going on-hook

(MONITOR) and then back off-hook (TALK).

Note: When dialing out through a PBX, you may use the

PSE key to insert a pause before initially dialing the

number.

Storing Numbers In Memory (Auto Dialer)

1Press STO (STORE).

2Press the number for the desired memory location

(1-9).

3Enter the number to be stored (18 numbers

maximum).

Note: If a pause is needed (as for a PBX), press the PSE key

where a pause is necessary.

4Press STO (STORE).

5Press the number for the desired memory location

(1-9).

Storing a Number You Are Calling

1Connect the test set to the line and receive dial tone.

2Dial the number.

3Press STO (STORE).

4Press the number for the desired memory location

(1-9).

Note: In Pulse mode, pressing STO (STORE) stops any

further digits from being outpulsed, although all digits

will be stored. Therefore, wait until all digits have been

outpulsed before pressing STO.

TS22 Amplified Speaker Mode

1Connect the test set to the line, put the test set in

TALK (T) mode, and receive dial tone.

2Press the SPEAKER button once for Amplified Speaker

mode at low volume. The transmitter and receiver

automatically turn off when the speaker is on to

prevent acoustic feedback.

3Press the SPEAKER button a second and third time for

medium and high volumes.

4Press the SPEAKER button a fourth time to turn the

speaker off and return to TALK mode.

Note: When the speaker is on, the polarity LEDs are off.

They turn back on when the speaker timer elapses or is

turned off with the SPEAKER button.

TS22A Speakerphone Mode

1Connect the test set to the line, put the test set in

TALK (T) mode, and receive dial tone.

2Press the SPEAKER button once for Speakerphone

mode at low volume.

3Press the SPEAKER button a second and third time for

medium and high volumes.

4Press the SPEAKER button a fourth time to turn the

speakerphone off and return to TALK mode.

Notes: (1) Pressing the MUTE button while in

Speakerphone mode mutes the transmit microphone for

privacy. (2) When using Speakerphone mode in noisy

environments, it may be helpful to temporarily lock the

MUTE button while listening; then unlock it to talk.

To prolong battery life, the TS22A shuts off the

speakerphone after about 5 minutes when there has been

no signal greater than -30 dBm. Speakerphone mode

must be reactivated every 5 minutes if no signal greater

than -30 dBm is detected.

Andere Handbücher für TS22

Dieses Handbuch passt für folgende Modelle

Andere Fluke Prüfgeräte Handbücher

Fluke

Fluke 154 Bedienungsanleitung

Fluke

Fluke 3130-G2M Bedienungsanleitung

Fluke

Fluke 190-502/AM Bedienungsanleitung

Fluke

Fluke 715 Bedienungsanleitung

Fluke

Fluke Versiv Series Gebrauchs- und Pflegehandbuch

Fluke

Fluke 9009 Bedienungsanleitung

Fluke

Fluke 709 Bedienungsanleitung

Fluke

Fluke 975 AirMeter Montage- und Bedienungsanleitung

Fluke

Fluke MicroScanner Series Bedienungsanleitung

Fluke

Fluke T3 Gebrauchs- und Pflegehandbuch

Fluke

Fluke T5-600 Bedienungs- und Montageanleitung

Fluke

Fluke VoltAlert 2AC Bedienungsanleitung

Fluke

Fluke 1507 Bedienungsanleitung

Fluke

Fluke DTX-MFM Bedienungsanleitung

Fluke

Fluke 990DSL Bedienungsanleitung

Fluke

Fluke i6000s Flex-24 Bedienungsanleitung

Fluke

Fluke NETWORK SERVICE MODULE DTX-NSM Bedienungsanleitung

Fluke

Fluke 714 Bedienungsanleitung

Fluke

Fluke 5623B Bedienungsanleitung

Fluke

Fluke 9100S Bedienungsanleitung

Fluke

Fluke CertiFiber Pro Bedienungsanleitung

Fluke

Fluke 730G Bedienungsanleitung

Fluke

Fluke 1625-2 Bedienungsanleitung

Fluke

Fluke FEV300 Originalbetriebsanleitung

Beliebte Prüfgeräte Handbücher anderer Marken

SMART

SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung

Agilent Technologies

Agilent Technologies BERT Serial Bedienungsanleitung

Agilent Technologies

Agilent Technologies N3280A Bedienungsanleitung

Vernier

Vernier Go Direct Voltage Bedienungsanleitung

Lifeloc

Lifeloc R.A.D.A.R. Bedienungsanleitung

Mercury

Mercury TSL01 Bedienungsanleitung

MAHA

MAHA MBT Series Bedienungsanleitung

Fuji Electric

Fuji Electric P-61 Bedienungsanleitung

ETC

ETC SealerAtor Bedienungsanleitung

Skyfine

Skyfine ETHYWAY V2 Bedienungsanleitung

Appion

Appion G5 Twin Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 8159-0112A Bedienungsanleitung

BW Technologies

BW Technologies MicroDock II Bedienungsanleitung

Sun Nuclear

Sun Nuclear 1027 Bedienungsanleitung

Biomark

Biomark HPR LITE READER Bedienungsanleitung

Hioki

Hioki 3169-20 Bedienungsanleitung

Ashcroft

Ashcroft ATE-100 Bedienungsanleitung

Rohde & Schwarz

Rohde & Schwarz RTA4000 Bedienungsanleitung