Flying Gadgets 35008 Bedienungsanleitung
LI-Po Batteries
Screwdrivers
Transmitter
3 x Propellors
Lower fusealge
motor unit
Install the battery with the correct polarity, when the red LED lights
up on the aeroplane then close the battery cover.
Connect the red & blue push rods magnetic connectors between the
upper fuselage and lower fuselage motor unit.Then connect the
fuselage magnetic connectors.
Frequency indicator light
Press the Throttle stick, then turn on the
transmitter. The buzzer will ring 3 times,
that means the transmitter is selecting a
frequency. During this time the blue LED on
the controller will be on as it searches for
the reciever.
Install the aeroplane battery in the lower fuselage motor unit. Once the
transmitter binds with the aeroplane the red LED light on the reciever will
flash. The blue LED light on the transmitter will turn off.
When connecting the aeroplane and transmitter, remember to switch on
the transmitter first and then the aeroplane battery.
To stop interference when connecting more than one aeroplane make
sure you only connect one at a time.
The connection of the aeroplane and the transmitter should take only 5
second. If it takes longer than 10 seconds retstart the process.
CHARGING THE AEROPLANE USING THE TRANSMITTER
Connect the Li-Po battery in the aeroplane to the charging socket on the
transmitter making sure it is connected using the correct polarity. Turn the
charging switch “on” on the transmitter. The green LED light will come on,
when it turns off charging is finished. Normal charging time will be around
35-45 minutes.
CHARGING THE AEROPLANE USING THE TRANSMITTER
The transmitter will beep when the batteries in it are low, replace
them ASAP.
Depending on the model you
are flying, make sure that the
servo switch is in the correct
position.
Everytime you connect the upper fuselage and lower fuselage motor
unit you need to check the elevator. The elevator should be aligned
with he horizontal stabilizer. If not you can adjust the elevator by
using the trimmer buttons on the left of the transmitter (See Pic).
Every time you connect the upper and lower fuselages together you
need to check the rudder and elavons. The rudder should be in line
with the vertical stabilizer. The elavons should be in line with the
trailing edge of the wing and parallel to the horizontal stabilizer.
Andere Flying Gadgets Spielzeug Handbücher
Flying Gadgets
Flying Gadgets F-Series Bedienungsanleitung
Flying Gadgets
Flying Gadgets T41 Bedienungsanleitung
Flying Gadgets
Flying Gadgets Flight 2 Channel Series Bedienungsanleitung
Flying Gadgets
Flying Gadgets F-Series 2.4G Bedienungsanleitung
Flying Gadgets
Flying Gadgets F-series 2.4G Bedienungsanleitung
