FMT Wireless SmartDip Betriebsanleitung
Installation and Operation Guide
WIRELESS TANK LEVEL MONITORING | FREE ACCESS TO YOUR ONLINE PORTAL
Introduction
This manual serves as a comprehensive guide for the
installation, configuration, and operation of Wireless
SmartDip.
In this manual, you will find detailed instructions on in-
stalling Wireless SmartDip, configuring the system using
the web portal, and utilizing its features for real-time data
access.
Additionally, you will gain insights into the technical
specifications, such as accuracy, battery life, and operating
temperature ranges.
For support during the installation process or accessing
your tank data, please contact FMT.
For support, please contact:
Phone: +61 8 8240 5585
For Terms and Conditions, please visit:
https://fmtweb.com/terms-and-conditions/
General Information
Wireless SmartDip is a wireless tank gauging product, de-
signed to be installed in tanks that do not have a SmartFill
Fuel Management System installed.
Wireless SmartDip’s set-and-forget automatic gauging sys-
tem and lightweight design can be installed in less than five
minutes, without drilling holes, running wires, or draining
your fuel tank.
Internally, Wireless SmartDip is comprised of a solar panel,
PCB and battery. The Wireless SmartDip enclosure should
always be kept closed and tightly sealed, the o-ring seal
should be clean and free of debris, and the screws holding
the lid down should be adequately tight.
Access to your tank data is via cloud-based web portal,
FMTData.com This platform can be accessed by using a
web browser and no special software is needed.
Wireless SmartDip is subject to FMT’s standard 2 year war-
ranty period. For further information and exclusions, visit:
https://fmtweb.com/terms-and-conditions/
Installing the Wireless SmartDip
Lower the probe into the tank.
Ensure the probe does not rest in sludge or grime in the
bottom of the tank. This will cause major faults.
Secure the Wireless SmartDip unit to the tank by rotating
the unit clockwise until the thread is tight.
Open the Wireless SmartDip lid by removing 2 screws
using a phillips head screwdriver.
Installing the Wireless SmartDip
Installing the Wireless SmartDip
Slide the battery connector on to the pins, being careful not
to bend any pins.
Scan the QR code on the top of the
Wireless SmartDip unit to begin setting up.
Installing the Wireless SmartDip
Setting the Tank Dimensions
When the QR code is scanned, you will be taken to an au-
tomated setup wizard. This wizard is designed to help you
make sure the Wireless SmartDip is configured correctly
and working as intended.
The first page of the wizard is a welcome page.
The second page is a security check to ensure you are
authorised to setup the Wireless SmartDip.
The default PIN is 6789
Setting the Tank Dimensions
The third page is the tank information page.
This page is where you will enter the dimensions or
20-point dip for the tank.
Setting the Tank Dimensions
Inhaltsverzeichnis
Andere FMT Messgerät Handbücher
