5│ Installing the Forest Shuttle S / L / M Receiver
Configure the FOREST SHUTTLE® S / L / M Receiver
Bottom view of the Shuttle® Use a pin to change settings in the configuration menu.
Choose the setting you want to change (table below) and press
the button that many times (corresponding with setting).
LED1 LED2 LED3 LED4
configuration button Confirm the desired setting by pressing the button for 4 seconds
until the led blinks 3 times and goes OFF. These settings can also
be done when finishing the installation.
Speed (1 & 2):
Standard speed is 14cm/s. For faster speed, 17cm/s, press 2x button. To confirm, press and hold once more for 4 seconds until
the led blinks 3 times and goes OFF.
Programming RF remote channel (3):
To programming a RF remote to a Shuttle®, press configuration button 3 times. LED3 is ON. Press and hold once more for 4
seconds, LED will start blinking for 10 seconds. In these 10 seconds press OPEN button on remote to program the channel to the
Shuttle®. Same procedure, but press CLOSE instead of OPEN, will erase the programmed channel.
Adding another channel, or another remote, can be done by pressing the P button 2 times, switch to new channel/remote and
press the OPEN button once. Now the new channel/remote will also control the Shuttle®.
Reset end limits (4):
For resetting only the end limits: press button 4x. To confirm, press and hold once more for 4 seconds until the led blinks 3 times
and goes OFF. When a Forest remote is programmed to the Shuttle®, the end limits can also be reset by pressing 5 times the P
button and 5 times the STOP button on the remote. End limits of all Shuttles® in range on this channel will reset end limits.
Dry contact inputs (5, 6 & 7):
Standard input is pulse contact. To set to continuous or single switch, press button 6 or 7 times respectively. To confirm, press
and hold once more for 4 seconds until the led blinks 3 times and goes OFF. Please see page 6 for detailed explanation. Make
sure the contact is free of potential.
Touch Impulse (8, 9 & 10):
The Shuttle® recognizes when the curtain is pulled by hand to open or close. The Shuttle® will then open or close the curtain all
the way. Default setting is high sensitive. Touch Impulse can be set to less sensitive or off, with 9 or 10 presses respectively. To
confirm, press and hold once more for 4 seconds until the led blinks 3 times and goes OFF.
IR channel setting (11, 12, 13, 14 & 15):
For Infra Red control an IR remote and an IR receiver is required, connected to port 1. Place the eye of the receiver cord in view
of the IR remote. Standard the Shuttle® is set to channel 1 and ‘ALL’. To change to channel 2, 3 4 or 5, press resp. 12x, 13x, 14x
or 15x button. Press and hold once more for 4 seconds until the led blinks 3 times and goes OFF.
Factory default (16)
To reset all settings, press button 16x. To confirm, press and hold once more for 4 seconds until the led blinks 3 times and goes
OFF.
