Freewing FJ311 Bedienungsanleitung

www.sz-freewing.com

EN 1~15

中16~30

1/10 Scale Twin 80mm EDF JET

User Manual

Wingspan:1700mm(66.9")

Weight:4250g (w/o Battery)

Length:1551mm(61.1")

1A-10 Thunderbolt II

Item No.:FJ311

Thank you for purchasing our Freewing 80mm EDF jet A-10 thunderbolt II. The original A-10

thunderbolt II is a single-seat twin-engine attack plane, produced by the Fairchild. It is now the

only continuous service jet in US Air Force which provided the implement intensive support for

the ground forces.

Freewing 80mm EDF jet A-10 thunderbolt II, length is 1551mm (61.1”), wingspan is 1700mm

(66.9”). Main wing and horizontal tail take the hollow frame design, reduce the weight

effectively, and signiﬁcantly increase main wing’s strength. Three piece control boards installed

on the fuselage and main wing on both side. Through the ribbon wire connection, reduced its

install time, and increased the connection reliability. The model use screws to ﬁx, you can

assemble/disassemble it in short time and convenience for carry and ship.

A-10 thunderbolt II model plane used the grey color scheme and posted most decals in

factory. In package, we put three different set nose fuselage decals, please refer to the decal

instructions, choose one set to stick on the nose fuselage.

It used the newest 9-blade dual 80mm EDF with 3530-1900KV brushless out-runner motor

and 100A ESC. In ﬁght, one side continues current is about 85A. Use 2 set 5000mAh lipo

battery, its ﬂight time is about 3.5 ~ 4 minutes, the max ﬂight speed is about 180KPH / 110MPH.

Whether it is high speed ﬂight or low speed ﬂight, it has excellent ﬂight stability, easy to control.

Excellent short takeoff and landing performance, with the new 70mm nose wheel/85mm rear

wheel, you can ﬂy in kinds of ﬂight ground.

Wish you have a pleasant ﬂight!

Catalog

Introduction

Product basic information

Package list

PNP Install Insturctions

Traction steel wire use instruction

Install fuselage

Install Horizontal stabilizer / Vertical stabilizer

Install Engine compartment

Install Main wing

Install Missiles

Install scale accessories

Pushrod instructions

Control board connection diagram

Battery size

Center of gravity

Control direction test

Dual Rates and Flight Attention

Accessories Description

Servos Introductions

Parameter of motor

Install the Motor and 90mm EDF power system instruction

Install pushrod

Install nose landing gear

Install rear landing gear

Package list

Product basic information

1700mm(66.9")

1551mm(61.1")

Material: EPO

Aileron: Yes

Flap: Yes

Elevator: Yes

Rudder: Yes

Landing gear: Retract landing gear

Cabin door: nose gear electric cabin door

Scale LED lights

Scale Pilot ﬁgure

Wing loading: 124g/dm

Motor: 3530-1900KV

brushless outrunner motor

Ducted fan: 80mm 9-blade fan

ESC: 100A brushless UBEC 8A(2pcs)

Servo: 17g Digital MG servo (9pcs)

30g Digital MG servo (2pcs)

9g Digital MG servo (1pcs)

Weight: 4250g(without battery)

Thrust: 6600kg

Standard version

Other features

A-10 Thunderbolt II

Item No.:FJ311

PNP ARF Plus Airframe PNP ARF Plus Airframe

No. Name No.

Fuselage

Main wing

Horizontal tail

Vertical tail

Carbon tube

Engine compartment

Pre-installed all

electronic parts

Pre-installed all

electronic parts

Pre-installed all

electronic parts

Pre-installed all

electronic parts

Pre-installed all

electronic parts

Pre-installed

servo

Pre-installed

servo

Pre-installed

servo

Pre-installed

servo

No electronic

equipment

No electronic

equipment

No electronic

equipment

No electronic

equipment

No electronic

equipment

Linkage Set

Scale accessories

Stabilizer wing

Manual & Decals

Glue & Non-slip mat

Screw

Name

PNP lnstall instructions

Use glue to install the front/rear fuselage.

A-

B-

Carbon tube (Ø6x200mmmm)

Carbon square tube (8.5x8.5x800mm)

Step 4

Step 3

Battery compartment

Elevator/rudder servo cable

Traction steel wire

Step 1

As the photo shown:

1.Install the vertical stabilizer on the horizontal stabilizer and use

2pcs screws to fix the left/right vertical stabilizer.。

2.When install the vertical stabilizer, pull out the rudder servo

cable through the inside trough。

3.Use the traction metal wire to pull the elevator/rudder servo cable

to the battery compartment.

4.Install the horizontal stabilizer on

the rear of fuselage and use 4pcs

screws to fix it.

A- Screw (PA3x8 4pcs)

B- Vertical tail

C- Horizontal tail

D- Servos wire

E- Screw (PA3x8 4pcs)

Step 2

Traction steel wire use instruction

Through investigation, excessive servo extension line will increase the risk of poor contact joints, and lead to the

servo outages caused ﬂight accidents. Because of A-10 large and ﬂat trough interior space, we don't use the

servo extension wire in this jet. As the below photo shown, package includes a traction steel wire, we can use it to

pull the main wing/elevator/rudder servo cables to the battery compartment.

Install fuselage

A-10 Thunderbolt II

Item No.:FJ311

Install Horizontal stabilizer / Vertical stabilizer

Install Engine compartment

Step 2

EC5

1.Use the traction metal wire to pull ESC cable and throttle cable to the battery compartment.

2.Install the engine compartment to the rear of fuselage；

3.Use 6pcs screws to fix。Screw ( 6pcs)PA3x12

Step 1

AIL

FLAP

GEAR

LIGHT

Airleron

Flap(Two)

Landing gear

Wing tip lights

Flap(One)

Main wing trough port

Carbon tube A

(Ø12x570mm)

Carbon tube B

(Ø8x650mm)

Step 3

Ribbon wire

Control board

1.Insert the carbon tube A,B into the fuselage.

2.Insert the connection cable to the control

board, then install the left/right main wing

on the fuselage.

3.Use 4pcs screws to ﬁx the main wing.

Screw

(PWM4x8 4pcs)

ESC wire

Back of fuselage

Battery compartment

Traction steel wire

Throttle wire

ESC wire

PNP lnstall instructions

InstallMainwing

A-10 Thunderbolt II

Item No.:FJ311

Install Missiles

Step 1Step 2

Step 3Step 4

AIM-9 pylons

AIM-9 Missiles

AGM-65 Missiles

Mk-84

AGM-65 Missiles

LAU-131

AN/ALQ-131

Please according the pictures as below to install the weapons

PNP lnstall instructions

5A-10 Thunderbolt II

Item No.:FJ311

pylons 1

pylons 2

pylons 3

pylons 4

Step 1Step 2Step 3

Screw

(PM3x6 1pcs)

Radar

Screw

(PA3x8 2pcs)

Wing fence

34mm

63mm

(2-1/2")

48mm

(1-7/8")

76mm

(3")

63mm

(2-1/2")

63mm

(2-1/2")

PNP lnstall instructions

Antennalnstall

Pushrod instructions

Flap pushrod size(Out Side) Flap pushrod mounting hole(Out Side)

Flap pushrod size(In Side) Flap pushrod mounting hole(In Side)

Aileron pushrod size Aileron pushrod mounting hole

Rudder pushrod size

Rudder pushrod mounting hole

Elevator pushrod size Elevator pushrod mounting hole

Pushrod diameter Ø1.5mm

Install Radar, Wing-knife

A-10 Thunderbolt II

Item No.:FJ311

Stabilizer wing

PNP lnstall instructions

Servo lnput

Receiver

A-10 Thunderbolt II

ELE

T H R

RUD

GEAR

Nose Steering

GEARDOOR

Landing lights

FLAP

GEAR

RUD

ELE

AIL

T H R

AIL

FLAP

GEAR

LIGHT

Main wing control board(Right) Main wing control board(Left)

AIL

FLAP

GEAR

LIGHT

Landing lights

Landing gear door

Landing gear

Nose steering

Rudder

Throttle

Elevator

EC5

A-10model plane used the ribbon wire, in order to use more convenient. Please refer to the following photo, connect

the electronic equipment.

Control board connection diagram

Airleron

Flap(Two)

Landing gear

Wing tip lights

Flap(One)

Strobe light

Connect the aileron channel in the receiver

Connect the elevator channel in the receiver

Connect the throttle channel in the receiver

Connect the rudder channel in the receiver

Connect the landing gear channel in the receiver

Connect the ﬂap channel in the receiver

RECEIVER

7A-10 Thunderbolt II

Item No.:FJ311

Battery size

Before connect the battery and receiver, please

switch on the transmitter power and make sure

the throttle stick is in the lowest position.

Battery cabin size:

L=360 W=90 H=90(mm)

BatteryA

Battery B

Velcro A

Velcro B

Battery tray

Screw

(PA3x8 8pcs)

Pull the sticker back

and open the cockpit.

Battery install on the front ofBattery install on the front of

fuselage, and use magic tape to fix.fuselage, and use magic tape to fix.

Battery install on the front of

fuselage, and use magic tape to fix.

Cockpit

78mm

(3-1/16")

PNP lnstall instructions

The battery capacity and discharge rate we advise

is in the following:

6S 22.2V 4000mAh ~ 6S 22.2V 5200mAh (2pcs)

Discharge rate of C 30C

Center of gravity

A-10 Thunderbolt II

Item No.:FJ311

Control direction test

PNP lnstall instructions

9A-10 Thunderbolt II

Item No.:FJ311

Inhaltsverzeichnis

Andere Freewing Spielzeug Handbücher

Freewing

Freewing Flight Design CTLS Bedienungsanleitung

Freewing

Freewing F-15 Eagle FJ309 Bedienungsanleitung

Freewing

Freewing Li P.15 Diana Bedienungsanleitung

Freewing

Freewing Moray Bedienungsanleitung

Freewing

Freewing F-15 eagle Bedienungsanleitung

Freewing

Freewing T-45 Goshawk Bedienungsanleitung

Freewing

Freewing Focker-Wulf Fw 190 Wurger Bedienungsanleitung

Freewing

Freewing F/A-18E Super Hornet FJ1071 Bedienungsanleitung

Freewing

Freewing BAe HAWK T.1A Bedienungsanleitung

Freewing

Freewing F-5N Tiger II FJ208 Bedienungsanleitung

Freewing

Freewing FJ3021 Bedienungsanleitung

Freewing

Freewing F-35 V2 FJ2011 Bedienungsanleitung

Freewing

Freewing F-14 TOMCAT Bedienungsanleitung

Freewing

Freewing FJ2061 Mirage 2000 C Bedienungsanleitung

Freewing

Freewing FJ211 Bedienungsanleitung

Freewing

Freewing B-17 F2601 Bedienungsanleitung

Freewing

Freewing F/A-18C Hornet Bedienungsanleitung

Freewing

Freewing F-86 Sabre FJ2031 Bedienungsanleitung

Freewing

Freewing B-17 Flying Fortess Bedienungsanleitung

Freewing

Freewing FJ307 Bedienungsanleitung

Freewing

Freewing Me-262 Bedienungsanleitung

Freewing

Freewing F9F Panther Bedienungsanleitung

Freewing

Freewing A-10 Thunderbolt II Bedienungsanleitung

Freewing

Freewing F-104 Starfighter Bedienungsanleitung

Beliebte Spielzeug Handbücher anderer Marken

marklin

marklin 37321 Bedienungsanleitung

Canon

Canon PAPER CRAFT Bedienungsanleitung

GREAT PLANES

GREAT PLANES Pitts M-12S Bedienungsanleitung

NOCH

NOCH 14261 Bedienungsanleitung

Hausler

Hausler 450 SE V2 Bedienungsanleitung

Dynaflite

Dynaflite Daydream Bedienungsanleitung

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Handbuch

Kenner

Kenner Batman 63651 Bedienungsanleitung

LEGO

LEGO 8527 Bedienungsanleitung

iKarus

iKarus ECO 8 Bedienungsanleitung

Multiplex

Multiplex EasyStar II Bedienungsanleitung

Walkera

Walkera 38 Bedienungsanleitung

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Bedienungsanleitung

MD MXION SWD Bedienungsanleitung

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Bedienungsanleitung

marklin

marklin 39671 Bedienungsanleitung

Meccano

Meccano 15103 Bedienungsanleitung

LEGO

LEGO TECHNIC 8735 Bedienungsanleitung