Garmin Nuvi 800 series Gebrauchsanweisung

quick start manual

nüvi®800 series

personal travel assistant

June 2008 190-00847-01 Rev. C Printed in Taiwan

Your nüvi Unit

WARNING: See the Important Safety and Product Information guide in the product box for product warnings and other

important information.

Microphone External

antenna

connector

GPS antenna

Serial number

under battery

Battery cover

new

Speakers

Mini-USB

connector

MicroSD

card slot

Headphone/

audio out

jack

Microphone

Power key:

slide to the left to turn the unit on/off;

slide to the right to lock the screen

WARNING: This product contains a user-replaceable,

lithium-ion battery. See the Important Safety and Product

Information guide in the product box for important battery

safety information.

Check your state and local trafc laws before mounting.

Currently, some state laws prohibit drivers from using

suction mounts or other devices on their windshields that

could obstruct the driver’s vision while operating motor

vehicles. Other Garmin dashboard or friction mounting

options should be used. See the Important Safety and

Product Information guide for more details.

Garmin®and nüvi®are trademarks of Garmin Ltd. or its

subsidiaries, registered in the USA and other countries.

Garmin Lock™is a trademark of Garmin Ltd. or its

subsidiaries. These trademarks may not be used without the

express permission of Garmin. The Bluetooth®word mark

and logos are owned by the Bluetooth SIG, Inc., and any use

of such name by Garmin is under license.

Step 1: Install the nüvi

Battery

1. Locate the rectangular lithium-ion battery

that came in the product box.

2. Slide the battery cover off the back of the

nüvi.

3. Locate the metal contacts on the end of

the lithium-ion battery.

4. Insert the battery so the metal contacts

on the battery match up with the metal

contacts inside the battery compartment.

5. Press the battery down into place.

6. Slide the battery cover back on until it

clicks into place.

Ways to Charge Your nüvi

Use the vehicle power cable.

Use the USB cable.

Use an optional AC adapter cable.

•

Step 2: Mount the nüvi

1. Plug the vehicle power cable into the

power connector on the right side of the

cradle.

Power

cable

Cradle

Microphone

jack

2. Snap the cradle

onto the suction

cup arm.

3. Clean and dry

your windshield

and the suction

cup with a lint-free cloth. Remove the

clear plastic from the suction cup. Place

the suction cup on the windshield.

4. Flip the lever back, toward the

windshield.

5. Fit the bottom of your

nüvi into the cradle.

6. Tilt the nüvi back until it

snaps into place.

Suction cup

mount

Suction cup

mount

7. Plug the other end of the vehicle power

cable into a power outlet in your vehicle.

Your unit should turn on automatically if it

is plugged in and the vehicle is running.

8. Ifyouareusingatrafcreceiverin

Europe,securethetrafcreceiver’s

antenna to the windshield using the

suctioncups.(Thetrafcreceiveris

included in the nüvi 860 package.)

Step 3: Activate and Mount

the Speech Recognition

Remote Control

Pull the clear tab out of the remote control to

activate it.

Mount the remote control in a convenient

location in your vehicle, such as on your

steering wheel. Use the strap to secure the

remote control in place.

Step 4: Congure the nüvi

To turn on your nüvi, slide the Power

key to the left and let go after one second.

Follow the on-screen instructions.

Step 5: Acquire Satellites

Go outdoors to an open area, out of garages,

and away from tall buildings. Stop your

vehicle, and turn on the nüvi. Acquiring

satellite signals may take a few minutes.

The bars indicate GPS satellite

strength. When one bar is green, the nüvi

has acquired satellite signals. Now you can

select a destination and navigate to it. For

more information about GPS, visit

www.garmin.com/aboutGPS.

Understanding the Menu

Page

➊➋ ➌ ➍

➎ ➏

➐ ➑ ➒

➊

GPS satellite strength

➋

Bluetooth

technology status

(Bluetooth technology is not available

on the nüvi 850.)

➌

Battery status

➍

Current time. Touch to change time

settings.

➎

Select to nd a destination.

➏

Select to view the map.

➐

Select to make a call when connected to

a compatible mobile phone.

➑

Select to adjust the volume.

➒

Select to use the tools such as media

players, settings, and Help.

Finding an Address

1. Select Where to? > Address.

2. Select Change State/Province, if

necessary.

3. Select Search All.

Select Spell City, enter the city/postal

code, and select Done. Select the

city/postal code in the list. (Not all

locations can be found using postal code

searching.)

4. Enter the number of the address, and

select Done.

5. Enter the street name, and select Done.

Select the correct street in the list, if

necessary.

6. Select the address, if necessary.

NOTE: Depending on the version of the

maps loaded on your nüvi, the button

names can change and some steps could be

ordered differently.

Viewing the Main Pages

Select View map to open the Map page. The vehicle icon shows your current

location. Touch and drag the map to view a different area of the map.

After you touch Go, the Map page opens. Your route is marked with a magenta line. As you

travel, your nüvi guides you to your destination with voice prompts, arrows on the map, and

directions at the top of the Map page. A checkered ag marks your destination. If you depart

from the original route, your nüvi recalculates the route and provides new directions.

Map Page while Navigating a Route

Turn List Page Next Turn PageTrip Computer Page

Select Arrival or

Speed to open the Trip

Computer page.

Select Turn In to open

the Next Turn page.

Touch the text bar to open the Turn List page.

Touch to zoom out. Touch to zoom in.

Select Menu to return

to the Menu page.

To save your current

location, touch the

vehicle icon.

TIP: A speed limit icon may appear as you travel on major roadways.

Taking a Detour

1. With a route active, select Menu.

2. Select Detour.

If the current route is the only reasonable

option, the nüvi might not calculate a detour.

You can also select specic detours while

navigating a route by using the Prompted

Detour feature. Select Tools > Settings >

Navigation > Prompted Detour. While

navigating a route, touch Detour on the

Menu page, and select a detour.

Adding a Stop (Via Point) to

Your Route

1. With a route active, select Menu >

Where to?.

2. Search for the extra stop (via point).

3. Select Go!.

4. Select Add as Via Point to add this stop

before your destination. Select Set as

new Destination to make this your new

naldestination.

TIP: To add more than one stop, edit the

current route. Select Where to? > Routes.

Walking to a Destination

If you are walking to your destination, use

Pedestrian mode to optimize your route for

walking. Select Tools > Settings > System

> Usage Mode > Pedestrian > OK.

Securing Your nüvi

1. Select Tools > Settings > Security.

2. Select Garmin Lock.

3. Enter a 4-digit PIN and drive to a security

location.

NOTE: If you forget your PIN and your

security location, you must send your nüvi

to Garmin to get it unlocked. You must

also send a valid product registration or

proof of purchase.

Resetting the nüvi

If the nüvi screen stops functioning, turn the

nüvi off and on again. If this does not help,

slide the Power key to the left and hold it

there for a minimum of 8 seconds. The nüvi

should operate normally.

You can also remove the battery, and then

reinstall it.

Using Speech Recognition

Use the speech recognition feature to speak

to your nüvi to nd destinations, select

options, and perform other functions. The

speech recognition feature does not work for

all languages in all areas. See the owner’s

manual at www.garmin.com for more

information.

Using the Remote Control

Use the remote control to start or stop a

speech recognition session.

Start speech

recognition

Stop speech

recognition

Voice Commands

1. Press the large button on the remote.

2. Wait for the green speak icon to

appear.

3. Speak a command.

Using Speech Recognition

Speech recognition uses four search

methods:

Speak any text on the screen

Speak shortcut commands

Speak the name of a popular place

Speak an address

To speak any text on the screen:

1. Speak any word on the screen. For

example, from the Tools menu, you can

speak Routes or Page Down.

2. Listen for the voice prompt before

speaking your next command.

•

To speak shortcut commands:

1. Speak any shortcut command from the

Shortcut Commands table. You can use

shortcut commands from any screen.

2. Listen for the voice prompt before

speaking your next command.

Shortcut Commands

Audible Player Help

Cancel Route Main Menu

Detour Music Player

Find Address Stop Listening

Find City Tools Menu

Find Favorite Trip Computer

Find Place by

Category

View Map

Find Place by Name Volume Down

Find Recently Found Volume Up

Go Home Where Am I?

Hands Free Where To?

You can also speak Find Nearest to search

a location category. Location categories are

Point of Interest categories contained in

the nüvi. The Find Nearest command only

works from the Menu page, Where to? page,

and Map page.

To search using the Find Nearest

shortcut command:

1. Speak Find Nearest followed by a Point

of Interest category, such as Italian

Restaurant.

“Find Nearest Italian Restaurant”

Additional examples of Find Nearest

commands include:

Find Nearest Gas Station

Find Nearest Grocery Store

Find Nearest Bank

Find Nearest Movie Theater

•

To speak the name of a popular place:

1. Speak Find Place by Name from any

screen.

“Find Place by Name”

2. Listen for the voice prompt, and speak

the name of the place. The nüvi repeats

the name of the place as it is searching.

“Starbucks”

3. A list of places appears. Speak the line

number of the place you want.

“Line 1”

4. Speak Yes to navigate to the place, or

speak No to go back to the list of found

places.

“Yes”

To speak an address:

1. Speak Find Address from any screen.

2. Respond to the prompts to speak or spell

the city name, house number, and street.

Using Photo Navigation

Panoramio

™

provides photos that contain

location information called geotags. You can

load these geotagged photos onto your nüvi

or microSD card and navigate to them. See

http://connect.garmin.com/photos and your

owner’s manual for more information.

1. Select Where to? > Favorites >

Panoramio Photos.

2. Select a Panoramio photo.

3. Select Go! to navigate to the location.

Andere Handbücher für nuvi 800 series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Garmin Auto-Navigationssystem Handbücher

Garmin

Garmin nuvi 30 Bedienungsanleitung

Garmin

Garmin CAMPER 780 Gebrauchsanweisung

Garmin

Garmin Streetpilot C320 Bedienungsanleitung

Garmin

Garmin nuvi 140T Series Gebrauchsanweisung

Garmin

Garmin ecoRoute ESP Bedienungsanleitung

Garmin

Garmin Asus A50 Gebrauchsanweisung

Garmin

Garmin nuvi 310 Bedienungsanleitung

Garmin

Garmin 795 Bedienungsanleitung

Garmin

Garmin dezl 770 Series Bedienungsanleitung

Garmin

Garmin NavComm SL30 Bedienungsanleitung

Garmin

Garmin GVN 53 - Navigation System Bedienungsanleitung

Garmin

Garmin nuvi 205W Series Gebrauchsanweisung

Garmin

Garmin StreetPilot c310 Bedienungsanleitung

Garmin

Garmin Streetpilot C320 Bedienungsanleitung

Garmin

Garmin BMW Motorrad Navigator VI Bedienungsanleitung

Garmin

Garmin Streetpilot C320 Bedienungsanleitung

Garmin

Garmin GNC 355 Handbuch

Garmin

Garmin GPS 19x NMEA 0183 Bedienungsanleitung

Garmin

Garmin Cessna Caravan G1000 Bedienungsanleitung

Garmin

Garmin GNS 530 Bedienungsanleitung

Garmin

Garmin DEZL OTR700 Bedienungsanleitung

Garmin

Garmin Cessna Caravan G1000 Handbuch

Garmin

Garmin Nuvi 205 Series Gebrauchsanweisung

Garmin

Garmin 2565 Gebrauchsanweisung

Beliebte Auto-Navigationssystem Handbücher anderer Marken

Clarion

Clarion Navigation In-Car Entertainment Bedienungsanleitung

Rosen

Rosen DP-1001 Bedienungsanleitung

Alpine

Alpine INE-W970HD Bedienungsanleitung

Blaupunkt

Blaupunkt TravelPilot DX-N Bedienungsanleitung

Pioneer

Pioneer MZ360500EX Bedienungsanleitung

Sanyo

Sanyo NVM-4030 - Easy Street - Automotive GPS... Bedienungsanleitung

AvMap

AvMap Geosat 2C Bedienungsanleitung

Eonon

Eonon GE01B Bedienungsanleitung

Pioneer

Pioneer AVIC-Z920DAB Bedienungsanleitung

Nextar

Nextar M3-MX - Automotive GPS Receiver Bedienungsanleitung

Furrion

Furrion NV2200 Bedienungsanleitung

Mio

Mio MOOV 200-Series Bedienungsanleitung

Prestigio

Prestigio GeoVision 5150 Bedienungsanleitung

Magellan

Magellan Maestro 4210 - Automotive GPS Receiver Konfigurationshandbuch

Mazda

Mazda 107006AN Bedienungsanleitung

Toyota

Toyota TNS600 Bedienungsanleitung

Toyota

Toyota TNS 200 Bedienungsanleitung

Nav TV

Nav TV NNG-Honda 8 NTV-KIT582 Bedienungsanleitung

Garmin nuvi 800 series Gebrauchsanweisung

Beliebte Auto-Navigationssystem Handbücher anderer Marken