GE K0470 Bedienungsanleitung

Digital Solutions

Pressure Automated Calibration Equipment

User manual - K0470 Revision A

PACE Indicators

without notice. GE is a registered trademark of General Electric Company. Other company or

product names mentioned in this document may be trademarks or registered trademarks of their

respective companies, which are not affiliated with GE.

PACE Pressure Indicators User Manual

[EN] English i K0470 Revision A

Introduction

This manual contains Installation and operating instructions for PACE Pressure Indicators.

Safety

The manufacturer has designed this equipment to be safe when operated using the

procedures detailed in this manual. Do not use this equipment for any other purpose than

that stated, the protection provided by the equipment may be impaired.

This publication contains operating and safety instructions that must be followed to make

sure of safe operation and to maintain the equipment in a safe condition. The safety

instructions are either warnings or cautions issued to protect the user and the equipment

from injury or damage.

Use qualified * technicians and good engineering practice for all procedures in this

publication.

Pressure

Do not apply pressures greater than the maximum working pressure to the equipment.

Toxic Materials

There are no known toxic materials used in construction of this equipment.

Maintenance

The equipment must be maintained using the procedures in this publication. Further

manufacturer’s procedures should be done by an authorized service agents or the

manufacturer’s service departments.

Technical Advice

For technical advice contact the manufacturer.

* A qualified technician must have the necessary technical knowledge, documentation,

special test equipment and tools to carry out the required work on this equipment.

K0470 Revision A ii [EN] English

General Specification

Abbreviations

The following abbreviations are used in this manual; abbreviations are the same in the singular and plural.

Display LCD: Colour display with touch-screen

Operating temperature 10°C to 50°C (50° to 122°F)

Storage temperature -20°C to 70°C (-4° to 158°F)

Ingress protection IP20 (EN60529)

Operating humidity 5% to 95% RH (non-condensing)

Vibration MIL-PRF-28800 Type 2 class 5 style E/F

Operating altitude Maximum 2000 metres (6560ft)

EMC EN 61326

Electrical safety EN 61010-1, UL61010-1, CSA 22.2, No. 61010-1 and IEC61010-1

Power adaptor Input range: 100 - 240VAC, 50 to 60Hz, 660mA. Installation category II

Pressure safety Pressure Equipment Directive - class: sound engineering practice (SEP)

for group 2 fluids.

Pollution degree 2

Operating Environment Indoor use only. Do NOT use in potentially explosive environments

a Absolute min Minute or minimum

a.c Alternating current mm millimetre

ALT Altitude mV millivolts

ASCII American Standard Code for Information Interchange MWP Maximum working pressure

BSP British pipe thread No Number

CAS Calibrated airspeed NPT National Pipe Thread

CSK Countersunk PACE Pressure automated calibration

equipment

d.c. Direct current Para. Paragraph

DPI Digital Pressure Instrument PDCR Pressure transducer

etc. And so on PED Pressure equipment directive

e.g. For example psi Pounds per square inch

Fig. Figure PTX Pressure transmitter

ft Foot ROC Rate of climb (vertical speed)

g Gauge RS232 Serial communications standard

GPIB General purpose interface bus Rt CAS Rate of Calibrated airspeed

Hg Mercury Rt MACH Rate of MACH

Hz Hertz Rx Receive data

IAS Indicated airspeed SCPI Standard commands for

programmable instruments

IDOS Intelligent digital output sensor (GE product) SDS Sales data sheet

PACE Pressure Indicators User Manual

[EN] English iii K0470 Revision A

Related publications

i.e. That is SELV Separated (or Safety) extra low

voltage

IEEE 488 Institute of Electrical and Electronic Engineers standard

488 (for programmable devices with a digital interface) Tx Transmit data

in Inch UUT Unit under test

kg kilogram V Volts

kts knots +ve Positive

m Metre -ve Negative

mA milliampere °C Degrees Celsius

max Maximum °F Degrees Fahrenheit

mbar Millibar

K0467 User Guide and Safety Instructions

K0469 PACE Heritage Communications Manual

K0450 PACE Series Calibration Manual

K0472 PACE Series SCPI Manual

K0470 Revision A iv [EN] English

Symbols

WARNINGS

TURN OFF THE SOURCE PRESSURE(S) AND CAREFULLY VENT THE PRESSURE LINES BEFORE

DISCONNECTING OR CONNECTING THE PRESSURE LINES. PROCEED WITH CARE.

ONLY USE EQUIPMENT WITH THE CORRECT PRESSURE RATING.

BEFORE APPLYING PRESSURE, EXAMINE ALL FITTINGS AND EQUIPMENT FOR DAMAGE.

REPLACE ALL DAMAGED FITTINGS AND EQUIPMENT. DO NOT USE ANY DAMAGED

FITTINGS AND EQUIPMENT.

DO NOT EXCEED THE MAXIMUM WORKING PRESSURE OF THE INSTRUMENT.

THIS EQUIPMENT IS NOT RATED FOR OXYGEN USE.

This equipment meets the requirements of all relevant European safety directives.

The equipment carries the CE mark.

This symbol, on the equipment, indicates that the user should read the user manual.

This symbol, on the equipment, indicates a warning and that the user should refer to

the user manual.

Ce symbole, sur l’instrument, indique que l’utilisateur doit consulter le manuel d’utili-

sation. Ce symbole, dans le manuel, indique une situation dangereuse.

This symbol warns the user of the danger of electric shock.

Ce symbole alerte l’utilisateur sur le danger de choc électrique.

Do not dispose of this product as household waste. Use an approved organisation

that collects and/or recycles waste electrical and electronic equipment. For more

information, contact one of these:

- Our customer service department: www.gemeasurement.com

- Your local government office.

PACE Pressure Indicators User Manual

[EN] English v K0470 Revision A

THE GROUND LEAD OF THE INSTRUMENT MUST BE CONNECTED TO THE AC SUPPLY

PROTECTIVE SAFETY GROUND.

ISOLATE THE POWER SUPPLY BEFORE MAKING ANY ELECTRICAL CONNECTIONS TO THE

REAR PANEL.

Pressure units and conversion factors

Unit Conversion

Convert FROM pressure VALUE 1 in pressure UNITS 1 TO pressure VALUE 2 in pressure UNITS

2, calculate as follows:

VALUE 2 = VALUE 1 x FACTOR 1

FACTOR 2

Pressure units Factor (hPa) Pressure units Factor (hPa)

mbar 1.0 cmH2O @ 20°C 0.978903642

bar 1000.0 mH2O @ 20°C 97.8903642

Pa (N/m2)0.01 kg/m20.0980665

hPa 1.0 kg/cm2980.665

kPa 10.0 torr 1.333223684

MPa 10000.0 atm 1013.25

mmHg @ 0°C 1.333223874 psi 68.94757293

cmHg @ 0°C 13.33223874 lb/ft20.4788025898

mHg @ 0°C 1333.223874 inH2O @ 4°C 2.4908891

inHg @ 0°C 33.86388640341 inH2O @ 20°C 2.486413

mmH2O @ 4°C 0.0980665 inH2O @ 60°F 2.487641558

cmH2O @ 4°C 0.980665 ftH2O @ 4°C 29.8906692

mH2O @ 4°C 98.0665 ftH2O @ 20°C 29.836983

mmH2O @ 20°C 0.097890364 ftH2O @ 60°F 29.8516987

K0470 Revision A vi [EN] English

CONTENTS

Section Title Page

1Description 1-1

1.1 Introduction 1-1

2Installation 2-1

2.1 Packaging 2-1

2.2 Packaging for Storage and Transportation 2-1

2.3 Preparation for Use 2-1

2.4 Connecting the Instrument 2-2

2.5 Mounting kits 2-8

2.6 Electrical connections 2-10

3OPERATION 3-1

3.1 Preparation 3-1

3.2 Power-up Sequence 3-1

3.3 Measure Mode 3-2

3.4 Operation and Example Procedures 3-8

3.5 Global Set-up Selections 3-11

3.6 Supervisor Set-up 3-12

3.7 Instrument Status 3-13

4MAINTENANCE 4-1

4.1 Introduction 4-1

4.2 Visual inspection 4-1

4.3 Cleaning 4-1

PACE Pressure Indicators User Manual

[EN] English vii K0470 Revision A

4.4 Test 4-1

4.5 Calibration 4-1

5TESTING AND FAULT FINDING 5-1

5.1 Introduction 5-1

5.2 Standard Serviceability Test 5-1

5.3 Ethernet testing 5-1

5.4 Fault Finding 5-4

5.5 Approved Service Agents 5-4

6REFERENCE AND SPECIFICATION 6-1

6.1 Installation notes 6-1

6.2 Reference port 6-2

6.3 Icons 6-3

6.4 Measure Set-up 6-6

6.5 Status 6-7

6.6 Global Set-up 6-8

6.7 Supervisor Set-up 6-9

6.8 Calibration 6-27

6.9 Specification 6-27

6.10 Options 6-28

6.11 Installation and Ancillary Equipment 6-31

6.12 Return Goods/Material Procedure 6-31

6-13 Packaging Procedure 6-31

K0470 Revision A viii [EN] English

Intentionally blank

PACE Pressure Indicators User Manual

[EN] English 1 - 1 K0470 Revision A

1Description

1.1 Introduction

The PACE Pressure Indicator measures both pneumatic and hydraulic pressures and

displays, on a colour touch-screen, the measured pressure and instrument status. The

touch-screen enables selections and settings in measuring modes. The instrument can be

operated remotely through communication interfaces.

Figure 1-1 PACE1000 General view

The rear of the instrument houses all the electrical and pressure input connections. The

electrical connections provide a power supply, serial and parallel communication interfaces,

pressure ports and option ports.

The instrument can be used as follows:

• Free-standing instrument positioned on a horizontal surface.

• Rack-mounted in a standard 19 inch rack using the rack-mount option kit.

• Panel mount using the panel-mount option kit.

Inhaltsverzeichnis

Andere GE Touchscreen Handbücher

GE druck dpi 104 Bedienungsanleitung

GE IC754VGB06MTD Installationshandbuch

GE HiTech Bedienungsanleitung

GE druck dpi 104 Bedienungsanleitung

GE ATP2100 Bedienungsanleitung

GE SIMON XT Bedienungsanleitung

GE IC754VSI06STD Bedienungsanleitung

GE IC754VSB06MTD Installationshandbuch

GE Druck PACE1000 Bedienungsanleitung

GE 60-924-RF-TS Benutzerhandbuch

GE Druck DPI 104-IS Bedienungsanleitung

GE SIMON XT Montageanleitung

GE IC754CSL12CTD Bedienungsanleitung

GE IC754VSL06CTD Bedienungsanleitung

GE IC754CSL06MTD Bedienungsanleitung

GE Druck DPI 150 Gebrauchs- und Pflegehandbuch

GE QuickPanel+ IC754VGI06STD Bedienungsanleitung

GE IC754VBI12MTD Bedienungsanleitung

GE IC755CxW07CD SERIES Bedienungsanleitung

GE 17453- - Motion Sensing Utility Light 1 LED Bedienungsanleitung

GE FTP 1000 - Security Concord LCD Touchpad Bedienungsanleitung

Beliebte Touchscreen Handbücher anderer Marken

FlowLine

FlowLine Data loop Bedienungsanleitung

ALPEX

ALPEX AEx-8 P Series Bedienungsanleitung

Ltech

Ltech E5S Bedienungsanleitung

Harman

Harman AMX MODERO S MSD-701-L2 Bedienungsanleitung

Acnodes

Acnodes PC 1150 Bedienungsanleitung

AIS

AIS IP10IA99 series Bedienungsanleitung

IBASE Technology

IBASE Technology ASTUT-152-RE1S Bedienungsanleitung

YASKAWA

YASKAWA TP 610C Bedienungsanleitung

B&R

B&R Power Panel C Series Bedienungsanleitung

AXIOMTEK

AXIOMTEK GOT321W-521 Bedienungsanleitung

TRIDONIC.ATCO

TRIDONIC.ATCO x-touchBOX Bedienungsanleitung

Qomo

Qomo QIT1386 Bedienungsanleitung

DFI

DFI KS104-CD Bedienungsanleitung

AMX

AMX AXP-PPC Leitfaden

Sartorius

Sartorius X3 PR 5410 Bedienungsanleitung

AMX

AMX Modero X Series Bedienungsanleitung

Advantech

Advantech TPC-30 Series Bedienungsanleitung

B&R Industries

B&R Industries MAPPC900-ENG Bedienungsanleitung