Genie WONVR14P5 Bedienungsanleitung

Quick Start Guide

Please read these instructions carefully before operating the unit

and keep for further reference.

4 Channel H.265 Optimised

NVR with 1HDD Bay

WONVR14P5

Intro Section

Please read this instruction carefully before operating the product and keep it for further

reference. All examples and pictures used here are for reference only.

The contents of this manual are subject to change without notice.

This device should be operated only from the type of power source indicated on the

marking label. The voltage of the power must be veriﬁed before use.

CAUTION:

• Please check the device and the accessories after getting the device. If there are any

damages, shortages or defects, please contact your dealer immediately.

Contents

iii

1.0 Introduction..........................................................................................................4

1.1 Product Features...........................................................................................4

1.2 Product Dimensions.....................................................................................4

1.3 Speciﬁcation.................................................................................................5

2.0 HDD Installation...................................................................................................6

3.0 Rear Panel Instruction..........................................................................................7

4.0 Start Up and Shut Down......................................................................................8

5.0 Login and Disk Settings.......................................................................................9

5.1 Login .............................................................................................................9

5.2 Disk Settings ................................................................................................9

6.0 Conﬁgurations and Connections ........................................................................10

6.1 Network Conﬁguration & Adding IP Camera...............................................10

7.0 Record Settings....................................................................................................11

8.0 NAT.......................................................................................................................12

9.0 Manual Recording and Playback .........................................................................13

9.1 Manual Recording.........................................................................................13

9.2 Playback.......................................................................................................13

The Genie ‘Optimised’ WONVR14P5 PoE Network video recorder offers 4 channel recording

of up to 5 Mega Pixels on every channel. The WONVR14P5 NVR supports 4 channel

simultaneous playback and has 4 PoE ports.

1.1 Product Features

• Supports 4 channel 5MP, 4MP, 3MP, 1080p, 960p and 720p IP input

• Adopt standard H.265 and H.264 high proﬁle compression format to get high quality

video at much lower bit rate

• Intuitive and user friendly Graphic User Interface (GUI), Windows style operation by

mouse

• Multi-mode recording: Manual / Timer / Motion / Sensor

• Search : Time slice, time, event (Manual, sensor, motion), Tag search

• Express and ﬂexible backup via USB, network etc.

• 4 channel simultaneous playback

• Pentaplex : Preview, Record, Playback, Backup and Remote Access

• DHCP, DDNS, PPPoE network protocol and CMS supported

• Remote control via IE or CMS : Preview, playback, backup, PTZ and conﬁguration

• Dual stream technology for local storage with high deﬁnition, remote network

transmission and remote surveillance with mobile device

• Multi-user online simultaneously

• Authorisation management, log view and device status view

• 1080p HD output, true high resolution display

• Support PTZ preset and auto cruise, up to 255 presets and 8 cruises

• Support NAT function and QR code scanning by mobile phone and iPad

• Powerful smart phone & iPad surveillance with iOS and Android OS

1.2 Product Dimensions

1.0 Introduction

255mm

234mm

42mm

Quick Start Guide 4 Channel H.265 Optimised NVR with 1HDD Bay

1.3 Speciﬁcation

Model WONVR14P5

System OS Embedded Linux

Video

Network Input 4 CH IPC input

Network Access Format 5MP / 4MP / 3MP / 1080p / 960p / 720p @ 25 / 30fps

Output HDMI x 1 : 1920×1080 / 1280×1024 / 1024×768

VGA x 1 : 1920×1080 / 1280×1024 / 1024×768

Compression Standard H.265, H.264

Audio Network Input 4 CH IPC audio input

Audio Local Output No (HDMI supports the audio output)

Record

Record Stream Dual stream recording

Resolution 5MP / 4MP / 3MP / 1080p / 960p / 720p @ 25 / 30fps

Mode Manual, Timer, Motion, Sensor

Mobile Device OS iOS, Android

Storage HDD SATA x 1, up to 6TB per HDD

Playback

Simultaneous Playback 4 CH max.

Search Time slice / Time / Event / Tag search

Smart Search Highlighted colour to display the camera record in a certain period of time, different

colours refer to different record events

Function Play, Pause, FF, FB, Digital zoom, etc

Network

Interface RJ45 100 Mbps x 1

Protocol TCP / IP, PPPoE, DHCP, DNS, DDNS, UPnP, NTP, SMTP

IP Input Access / Transfer

Bandwidth 32Mbps / 32Mbps

Alarm

Mode Manual, Sensor, Motion, Exception

Input No

Output No

Triggering Record, Snap, Preset, E-mail, etc.

Remote

Monitoring

Immix Compatible with Immix via RTSP only (2-way audio not supported)

Sentinel Yes, Firmware 1.1.0 or later

Backup Local Backup USB Stick, USB mobile HDD

Network Backup Yes

Port USB USB 2.0 × 2

Remote Controller Optional

Others

Power Supply DC12V, 1.5A

Consumption <6W (Without HDD)

Working Environment Temperature: -10°C – 50°C,

Humidity: 10% – 90%

Dimensions 255 × 234 × 42 mm

This series of the product supports 1 SATA hard drive. Please make sure that the device is

powered off before the installation. The pictures of the installation are for reference only.

1. Loosen the screws to open the cover.

2. Place the HDD onto the bottom of the machine.

3. Turn over the machine and secure the HDD with the screws.

4. Connect the power and data cables.

5. Install back the cover and secure it with the screws.

Note: Please check the inside structure of the device and make sure that the cables are

connected well before installing the cover back. Please format the HDD before using.

2.0 HDD Installation

The interfaces of the rear panel are for reference only.

Rear panel for WONVR14P5

Rear Panel for WONVR18P5

3.0 Rear Panel Instruction

Name Description

VGA Connector for VGA output

HDMI Connector for HDMI output

USB Connectors for USB devices

LAN RJ 45 Ethernet port

PoE Ports 4/8 PoE network ports; connect to PoE IP

cameras

DC48V Connector for power input

Power

Switch

Power

Connector

Startup

1. Connect the monitor and the power.

2. The device will boot and the power indicator will display blue.

3. A wizard window will pop up.

Shutdown

Click “Start” and then select “Shutdown” icon. This will bring up a shutdown window. The

device will shut down by clicking “OK” button. Then disconnect the power.

4.0 Start Up and Shut Down

5.1 Login

You must conﬁgure the wizard window if you start the NVR for the ﬁrst time. Choose the

language and read the privacy statement. Then set the data, time and zone as needed.

After that, set the login password.

The default username is admin and the default password of admin is 123456. Set your own

password or use the default one when you use the wizard for the ﬁrst time. Enable pattern

lock and click “Edit” to set the pattern lock. Then set security questions and answers.

It is important for you to remember these answers, or you will not be able to reset your

password. Click “Next” to continue.

5.2 Disk Settings

You can view the disk number, disk capacity of the NVR and serial number, Read/Write

status of the disk. Click “Format” to format the disk. Click “Next” to continue.

5.0 Login and Disk Settings

6.1 Network Conﬁguration & Adding IP Camera

1. Enter IP address, subnet mask, gateway, etc. If using DHCP, please enable DHCP in both

the NVR and the router.

2. Enter HTTP port (the default value is 80) and server port (the default port is 6036).

3. The internal ethernet port is the port which connects all the PoE ports with the NVR

system. The PoE ports are available if the internal ethernet port is online, if it is ofﬂine,

all the PoE ports will be unavailable.

4. Add Camera. Click “Next” to go to the following interface.

Click “Refresh” to refresh the list of online

IP cameras which are in the same local

network with the NVR. Click + to add the

searched camera. Click “Add All” to add all

the cameras in the list. Click to delete the

added camera. Click “Delete All” to delete all

the added cameras.

5. Click to edit an IP camera as shown on the above left. Enter the new IP address,

subnet mask, gateway, username and password of the camera. Click “OK” to save the

settings. Click to edit the added camera as shown on the above right. Enter the

new camera name, IP address, port, username and the password of the camera. You

can click “Test” to test the effectiveness of the input information. Click “OK” to save the

settings. You can change the IP camera name only when the added camera is online.

Click “Next” to continue.

6.0 Conﬁgurations and Connections

Inhaltsverzeichnis

Andere Genie Messgerät Handbücher

Genie

Genie WONVR18P5 Bedienungsanleitung

Beliebte Messgerät Handbücher anderer Marken

Suaoki

Suaoki D40 Bedienungsanleitung

Elster

Elster BK-G1.6 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Deltabar FMD71 Handbuch

Duratool

Duratool D03128 Bedienungsanleitung

Vega

Vega VEGAPULS 65 Bedienungsanleitung

Tonghui

Tonghui TH2618B Bedienungsanleitung

Tenmars

Tenmars TM-801 Bedienungsanleitung

MSR

MSR 145 Bedienungsanleitung

TPS

TPS WP-82 Bedienungsanleitung

PCB Piezotronics

PCB Piezotronics 003C30 Bedienungsanleitung

Tenma

Tenma 72-10465 Bedienungsanleitung

Endress+Hauser

Endress+Hauser Proline Promag 50 Technische Daten

Siemens

Siemens SITRANS F Coriolis FCT030 Stücklistenhandbuch

KLINGER

KLINGER CMF V Series Bedienungsanleitung

Keysight

Keysight M8290A Bedienungsanleitung

Acterna

Acterna MS1400 Bedienungsanleitung

R&S

R&S ZPH Bedienungsanleitung

Datacolor

Datacolor ColorReader DC10-2 Bedienungsanleitung