Gorgy Timing LEDI NETWORK TDS V1 Bedienungsanleitung

MDE-LEDI-NETWORK-TDS-4099V2.0

LEDI

NETWORK TDS V1

LEDI

NETWORK TDS GPS

RAIL DIN TH35

TIME SERVER

USER MANUAL

MDE-LEDI-NETWORK-TDS-4099V3.0

WARNING! The following section provides the safety instructions for installation.

Please read it carefully before installing your device.

To protect your device, plug it into a grounded outlet.

The device must be connected to an electrical installation which is in accordance with

the NF C15-100 standard.

The wiring installation must include an easily accessible breaking device (circuit

breaker or disconnecting switch). This device must withstand the nominal voltage and

current values indicated on the device.

In Europe: in accordance with European regulations on the protection of individuals

and the environment, it is your responsibility to dispose of this equipment at a collection

site designed for this purpose (separately from household waste). For further

information, contact your reseller, your collection site or the relevant local authorities.

Any modification or opening of the product without the consent from the Customer

service department will void the warranty.

The LEDI® NETWORK TDS must only be installed, maintained and handled by

competent and knowledgeable persons.

All maintenance operations must be carried out with the power off, including for

systems connected to any relay outputs.

As a general rule, to avoid any interferences, the power (230V supply) and signal (time

information) cables must not be too close to each other. (keep a few centimetres apart)

CAUTION!After unpluggingthe LEDI®NETWORKTDS, thereis a risk of electric shock

from the power connector/plug socket for up to 2 seconds.

To avoid the risk of electrical interference, position the LEDI® NETWORK TDS as far

as possible from sources of radiation (Loudspeakers, antennas, high-frequency

equipment, electromagnetic alarms…).

Gorgy Timing disclaims all liability in the event of accident or damage caused by

improper use of LEDI® NETWORK TDS.

All GORGY TIMING products comply with the following standards: CE, EN60950-1,

EN55022 class B, EN50024.

IMPORTANT SAFETY INSTRUCTIONS

MDE-LEDI-NETWORK-TDS-4099V3.0

ENGLISH

General hazard –there is a risk of damage to the product if instructions are not followed

Electrical hazard –there is a risk of electrocution or personal injury if instructions are not

followed.

Equipment fully protected by double insulation.

Warnings

Please follow the precautions and instructions indicated below in order to ensure the safety of you and

your environment, and to prevent any potential damage to your device.

WARNING: An isolating switch in compliance with EN60947 standards is used as a

disconnecting device. It must be easily accessible and installed close to the power supply. It

must disconnect all active poles.

The LEDI® NETWORK TDS is intended for indoor use only, at an altitude of less than 2000

metres.

Waste disposal by users in private households within the European Union

This symbol on the product or its packaging indicates the product must not be disposed of with

your general household waste. Instead, it is your responsibility to dispose of your waste by

taking it to a designated collection point for the recycling of electrical and electronic appliances.

The separate collection and recycling of your waste contributes to the conservation of natural

resources and helps to ensure that recycling is environmentally and health friendly. For more

information about your nearest recycling centre, pleasecontact the shop where you purchased

your device, the household waste disposal services or your local authorities.

Technical features

TDS v1

TDS GPS Rail Din TH 35

Power supply

Voltage

110-250 Vac

18-72 VDC

Frequency

50-60Hz

Maximum current

0.1-0.2 A Max

Dimensions

Length

482 mm

209 mm

Width

266 mm

136 mm

Height

44 mm

73 mm

Operating conditions

Maximum operating temperature

50°C

55°C

Humidity (non-condensed)

90 %

EXPLANATION OF SAFETY SIGNS ON THE PRODUCT

4
MDE-LEDI-NETWORK-TDS-4099V3.0 
 
 
CONTENTS 
 
 
CONTENTS..........................................................................................................................4 
INTRODUCTION........................................................................................................7 
1. LEDI® NETWORK TDS V1 RACK....................................................................................7 
2. LEDI® NETWORK TDS GPS –RAIL DIN TH35................................................................9 
2.1. Version < 100m cable (solution with antenna GPS converter Part Number: 3Gxx)10 
2.2. Version > 100m cable (solution with RTBGPS Part number: 4048/xx)).................10 
A. RTB GPS antenna (part number: RTBGPS-4080) ................................................12 
QUICKSTART .........................................................................................................13 
1. PRODUCT CONNECTION..............................................................................................13 
2. MANUAL NETWORK CONFIGURATION........................................................................14 
3. TIME OUTPUT CONFIGURATION..................................................................................14 
4. ALARM CONFIGURATION .............................................................................................14 
GENERAL INFORMATION .....................................................................................15 
1. TIME ZONES ..................................................................................................................15 
2. LEAP SECOND...............................................................................................................16 
2.1. Definitions............................................................................................................16 
2.2. Protocols incorporating a leap second..................................................................16 
2.3. LEDI®Network TDS performance.........................................................................16 
2.4. Configuration recommendations...........................................................................17 
3. SYNCHRONISATION CONCEPTS .................................................................................17 
4. NOTIONS OFTHENTP PROTOCOL...............................................................................18 
4.1 Client/Server mode ...............................................................................................19 
4.2. Broadcast mode...................................................................................................20 
5. TIME SERVER STATUS.................................................................................................20 
6. SNMP (SIMPLE NETWORK MANAGEMENT PROTOCOL) AND MIB (MANAGEMENT 
INFORMATION BASE)...........................................................................................................21 
7 TIME INPUT INSTABILITY DETECTION..........................................................................23 
FRONT LCD DISPLAY............................................................................................24 
1. LIGHTS AND BUTTONS.................................................................................................24 
2. STARTUP .......................................................................................................................25 
3. TIME DISPLAY................................................................................................................25 
4. ALARM DISPLAY............................................................................................................26 
5. IPV4 / IPV6 CONFIGURATION........................................................................................28 
5.1. Display current IP addresses................................................................................28 

MDE-LEDI-NETWORK-TDS-4099V3.0 
5
ENGLISH 
 
 
 
4.5.2. Menu....................................................................................................................28 
4.5.3. IPv29....................................................................................................................29 
4.5.4. IPv6 .....................................................................................................................31 
4.6. RESTARTING................................................................................................................33 
5. WEB INTERFACE...................................................................................................34 
5.1. PRESENTATION.............................................................................................................34 
5.2. DESCRIPTIONOF WEB PAGES ....................................................................................35 
5.2.1. Navigation menu..................................................................................................35 
5.2.2. "Index" Page ........................................................................................................38 
5.2.3. "Network" Page....................................................................................................40 
5.2.4. "Alarms" Page......................................................................................................43 
5.2.5. "SNMP" Page.......................................................................................................45 
5.2.6. "NTP" Page..........................................................................................................48 
5.2.7. NTP Server Statistics Page..................................................................................54 
5.2.8. "Input" Page.........................................................................................................55 
5.2.9. "Output" page.......................................................................................................59 
5.2.10. "Interface" Page.................................................................................................64 
A. User Accounts ......................................................................................................64 
B. Front LCD.............................................................................................................65 
C. Other interfaces....................................................................................................66 
D. File system...........................................................................................................68 
E. SNMP Interface....................................................................................................69 
F. Telnet and SSH Interface......................................................................................70 
G. Command prompt.................................................................................................70 
H. File transfer..........................................................................................................74 
I. "Restart" Button .....................................................................................................74 
5.2.11. Update...............................................................................................................75 
5.2.12. "Diagnostics" Page.............................................................................................78 
6. APPENDIX A –CONNECTIONS.............................................................................81 
6.1. INSTALLATION VIEW.....................................................................................................82 
6.2. DCF-GPS ANTENNA ......................................................................................................84 
6.2.1. DCF Antenna.......................................................................................................84 
6.2.2. GPS antenna (converter unit)...............................................................................85 
6.3. AFNOR-NFS-87500 / IRIG-B OUTPUT ...........................................................................86 
6.4. SERIAL IMPULSION OUTPUT........................................................................................86 
7. APPENDIX B –OUTPUT CODES FORMAT ..........................................................87 

MDE-LEDI-NETWORK-TDS-4099V3.0

7.1. AFNOR/IRIG-BNFS87500 ..............................................................................................87

7.2. DESCRIPTION OF DCF AND TDF TIME CODES...........................................................90

7.3. POLARISED MINUTE PULSES ......................................................................................92

8. APPENDIX C –MAINTENANCE.............................................................................94

8.1. CARD REPLACEMENT +IMPULSION CARD POWER SUPPLY....................................94

8.2. MICROCONTROLLERS REPLACEMENT.......................................................................95

8.3. OUTPUT CARDS ADDRESSES SWITCHES..................................................................96

8.4. TOP AND IRIG-B DCLS TIME CODE OUTPUT SIGNALS..................................................97

8.5. SUPERVISION PROTOCOLS.........................................................................................98

8.5.1. Syslog messages catalogue...................................................................................98

9. APPENDIX D –TROUBLESHOOTING...................................................................99

MDE-LEDI-NETWORK-TDS-4099V3.0

ENGLISH

1. INTRODUCTION

This document is the instruction manual for the LEDI®NETWORK TDS V1 and the LEDI®

NETWORK TDS GPS Rail Din TH 35. These products are accurate and easily configurable

time servers.

Each server communicates through the following network protocols:

►IPv4 et IPv6

►HTTP(S)

►SNMP v1, v2c, v3

►Telnet

►SSH

►FTP

►SMTP

►Syslog

►(S)NTP

►ENDMI (to detect Gorgy Timing

products on the IP network)

Security features ensure that the server delivers reliable and continuous timing information.

1.1. LEDI® NETWORK TDS V1 RACK

The server synchronises through an NTP Ethernet 10/100 base T or DCF or GPS time input.

In case of a DCF or GPS input, the heart of the time base is a temperature-compensated

quartz oscillator (TCXO) which limits deviation when the time source is unavailable.

There are 3 available time outputs: AFNOR NFS 87500 / IRIG B, IMPULSION, NTP.

MDE-LEDI-NETWORK-TDS-4099V3.0

The use of the LEDI® Network TDS V1 has several advantages:

►Ethernet + IPnetwork interfacing.

►Simplified installation.

►Easy remote configuration and diagnostics.

►1U 19” rack easily mounted in many installations.

►3 configurable outputs:

- AFNOR NFS 87500 / IRIG-B

- NTP (V2, V3, V4): Unicast, Multicast et Broadcast

- Minute Impulses 24V //

ASSEMBLY

The rack must be fixed in a 19'' frame using 4 screws and cage nuts, shown in the image

below. (Screw 10-32 M6, tightening torque: 1.13Nm).

BOX CONTENTS

The box should contain the following items

►The 19" 1u rack, with the words "LEDI® NETWORK TDS" on the front panel

NOTE: The device code and configuration can be checked on the identification label on the

bottom or back of the device. It must correspond to the following number: 94031/opt (opt

depending on the device options).

►A non-locking IEC 60320 C13 mains power cable

NOT: only for models with alternative current (AC) supply.

►A 2-pin connector for DC power input

NOTE: only for DC models.

►One RJ45 network cable

►A DVD containing software and documentation

☛Please contact customer service if an item is missing

MDE-LEDI-NETWORK-TDS-4099V3.0

ENGLISH

1.2. LEDI® NETWORK TDS GPS –RAIL DIN TH35

The time server has GPS synchronisation input providing SNMP supervised NTP time

synchronisation.

Both an alarm visible on the front LED display and quick configuration from the front panel

buttons are available.

209 x 73 x 136 mm (WxHxD)

MDE-LEDI-NETWORK-TDS-4099V3.0

1.2.1. Version < 100m cable (solution with antenna GPS converter Part Number: 3Gxx)

MOUNTING

Fixing by rear panel in Rail Din (see image below).

►Kit contents (cable and GPS antenna not included):

- LEDI®Network TDS Rail Din

- One RJ45 network cable

- A DVD containing software and documentation

☛Please contact customer service if an item is missing.

►Power supply:

Direct current (DC) supply 24Vdc (18-72Vdc) on screw terminal block –10W max

1.2.2. Version > 100m cable (solution with RTBGPS Part number: 4048/xx))

►Mounting:

Rear panel mounting in Rail Din

Antenna to be positioned on the roof of the property and cable (not included) to be

routed to the time server. See reference table for model selection (IRIGB input).

Andere Handbücher für LEDI NETWORK TDS V1

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Gorgy Timing Netzwerkzeitserver Handbücher

Gorgy Timing

Gorgy Timing LEDI NETWORK iTS Bedienungsanleitung

Beliebte Netzwerkzeitserver Handbücher anderer Marken

EKOS

EKOS EKOSync 1588 Bedienungsanleitung

Meinberg

Meinberg LANTIME M200/GPS Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M600 Gebrauchs- und Pflegehandbuch

Meinberg

Meinberg LANTIME M300/MRS/AD10-AD10 Gebrauchs- und Pflegehandbuch

TPA

TPA S5 Bedienungsanleitung

Meinberg

Meinberg LANTIME M300/GPS/2LNE/AD10-AD10 Gebrauchs- und Pflegehandbuch

Mobatime

Mobatime DTS 4160.grandmaster Bedienungsanleitung

Meinberg

Meinberg LANTIME M300/GNS/RPS Gebrauchs- und Pflegehandbuch

Mobatime

Mobatime DTS 4128.timeserver Bedienungsanleitung

Meinberg

Meinberg IMS LANTIME M1000 Bedienungsanleitung

BRG Precision Products

BRG Precision Products NTP100B Bedienungsanleitung

Krontek

Krontek KT2000 Bedienungsanleitung

Meinberg

Meinberg LANTIME M300/TCR Gebrauchs- und Pflegehandbuch

Mobatime

Mobatime NTS Bedienungsanleitung

Bodet Time

Bodet Time Sigma H Anleitungen und Rezepte

Bodet

Bodet NETSILON 7 AC Bedienungsanleitung

Meinberg

Meinberg LANTIME M100 Bedienungsanleitung

Tekron

Tekron NTS 02-G Bedienungsanleitung