Operating instructions for Workshop Crane
76000081
4
Retrofits, changes or modifications to the equipment are strictly prohibited. They require
consultation with and written approval by the manufacturer.
If during operation (residual) hazards and risks become apparent which are not described
in this manual, the operator is obliged to report this to the manufacturer.
Never exceed the rated lifting weight of the jack.
Use the workshop crane only on firm and level surfaces.
Never operate or reach under a raised load if you have not taken additional precautionary
measures to prevent the vehicle from rolling, slipping or tipping. The load should be well
secured by safety stands when the desired lift height is reached, if work will be done on or
below the raised load.
Do not change the setting of the safety valve. Before each use check for proper functioning,
especially the hydraulic oil level, and check for possible leaks.
Under high pressure, escaping fluids (hydraulic oil) can penetrate the skin and cause serious
injury! If injured contact a physician immediately! Risk of infection!
Before working on the hydraulic system lower the equipment and de-pressurise the system!
The workshop crane may be used only at points on the vehicle which are described as
suitable in the vehicle’s operating instructions.
Keep all supplied documents with the equipment for future reference if required. Keep the
purchase receipt for any warranty claims.
The life time of the workshop crane is 2 years
It is necessary that the operator can watch the lifting device and the load during all
movements
2.2 Precautionary measures
Always wear protective gloves when performing setup, maintenance and cleaning
work on the equipment, to prevent injury from sharp parts.
While working with and on the equipment wear protective work shoes that fit well.
Before each use always perform a visual and function check of the equipment to
identify damage and worn parts, and arrange for their repair by trained personnel
before use.
Before raising a load, make sure that the drain valve is closed.
Ensure that the workshop crane is always on a solid and stable base before the load is
lifted.
Never work under a raised load supported only by the workshop crane.
Lubricate all moving parts on the workshop crane regularly.
If you notice a spillage of oil, stop using the product and absorb the oil on the floor with a
cloth. Any reparation must be done by a professional.
If oil level is too low it should be replenished and the system bled before further use.
Observe the instructions in this manual!
