Greenlee ES750 Bedienungsanleitung

INSTRUCTION MANUAL

ES750

Battery-powered Cable Cutter

45380—with 120 V Charger

45381—with 220 V Charger

Read and understand all of the instructions and

safety information in this manual before operating

or servicing this tool.

KEEP THIS MANUAL

Table of Contents

Description, Safety, and Purpose of this Manual ................................................................ 2

Important Safety Information........................................................................................... 3–7

Specications...................................................................................................................... 8

Operation............................................................................................................................. 9

Charger.............................................................................................................................. 10

Troubleshooting................................................................................................................. 11

Maintenance...................................................................................................................... 12

Illustration.......................................................................................................................... 13

Parts List ..................................................................................................................... 14–15

Description

The Greenlee Battery-powered Cable Cutter is intended to cut up to 750 kcmil copper

and aluminum cable. The cable cutter is driven by a 12-volt motor and is powered by a

rechargeable NiCd (nickel cadmium) battery. The motor is protected by a circuit breaker.

Safety

Safety is essential in the use and maintenance of Greenlee tools and equipment.

This manual and any markings on the tool provide information for avoiding hazards and

unsafe practices related to the use of this tool. Observe all of the safety information

provided.

Purpose of this Manual

This manual is intended to familiarize all personnel with the safe operation and

maintenance procedures for the Greenlee ES750 Battery-powered Cable Cutter.

Keep this manual available to all personnel.

Replacement manuals are available upon request at no charge at www.greenlee.com.

All specications are nominal and may change as design improvements occur.

Greenlee Textron Inc. shall not be liable for damages resulting from misapplication

or misuse of its products.

Do not discard this product or throw away!

For recycling information, go to www.greenlee.com.

ES750

IMPORTANT SAFETY INFORMATION

SAFETY ALERT SYMBOL

This symbol is used to call your attention to hazards or unsafe practices which could

result in an injury or property damage. The signal word, dened below, indicates the

severity of the hazard. The message after the signal word provides information for

preventing or avoiding the hazard.

Immediate hazards which, if not avoided, WILL result in severe injury or death.

Hazards which, if not avoided, COULD result in severe injury or death.

Hazards or unsafe practices which, if not avoided, MAY result in injury or property

damage.

Read and understand all of the instructions and safety information in

this manual before operating or servicing this tool.

Failure to observe this warning could result in severe injury or death.

IMPORTANT SAFETY INFORMATION

Cable Cutter

Electric shock hazard:

This tool is not insulated. When using this unit near energized electrical

lines, use proper personal protective equipment.

Failure to observe this warning could result in severe injury or death.

Wear eye protection when operating or servicing this tool.

Failure to wear eye protection could result in serious eye injury from

ying debris.

• Keephandsawayfromblade.

• Removethebatterybeforeinspectingorservicingthetool.

Failure to observe these warnings could result in severe injury or death.

• Usethistoolformanufacturer’sintendeduseonly.Useotherthanthatwhichis

described in this manual can result in injury or property damage.

• DonotcutsteelorACSR.

• Inspectthetoolbeforeeachuse.Replaceanyworn,damaged,ormissingitemswith

Greenlee replacement parts. A damaged or improperly assembled tool can break and

strike nearby personnel.

Failure to observe these precautions may result in injury or property damage.

ES750

Battery

IMPORTANT SAFETY INFORMATION

Do not dispose of battery in a re. The battery will vent harmful vapors and

can explode.

Failure to observe this warning could result in severe injury or death.

Do not allow any object to contact the battery terminals.

• Donotimmersebatteriesinliquid.Liquidmaycreateashortcircuitanddamagethe

battery.

• Donotplacethebatteryintoapocket,toolpouch,ortoolboxwithconductive

objects. Conductive objects may create a short circuit and damage the battery.

• Donotplaceabatteryonmoistgroundorgrass.Moisturemaycreateashortcircuit

and damage the battery.

Failure to observe these precautions may result in injury or property damage.

• Donotchargethebatteryifitiscoolerthan50°F(10°C)orwarmerthan

95°F(35°C).Damagetothebatterycanresult.

• Donotstorethebatteryatmorethan140°F(60°C).Damagetothebatterycanresult.

• Donotuseanothermanufacturer’scharger.Othermanufacturers’chargersmay

overcharge and damage the battery.

Failure to observe these precautions may result in injury or property damage.

• Donotexposethebatterytoliquidssuchaswater,oil,orsolvents.Liquidswill

damage the battery.

• Donotattempttoopenthebattery.Itcontainsnouser-serviceableparts.

• Usethisbatteryformanufacturer’sintendeduseonly.Useotherthanthatwhichis

described in this manual can result in injury or property damage.

• Inspectthebatterybeforeeachuse.Donotuseadamagedbattery.

Failure to observe these precautions may result in injury or property damage.

IMPORTANT SAFETY INFORMATION

Charger

Electric shock hazard:

• Useindoorsonly.

• Donotexposethechargertorain,snow,orwetconditions.

• Unplugthechargerfromthepowersourcebeforecleaningthe

charger.

Failure to observe these warnings could result in severe injury or death.

Greenlee recommends plugging the charger directly into a receptacle. If an extension

cord must be used:

• Selectanextensioncordwithacongurationthatexactlymatchesthatofthe

charger’splug.

• Inspecttheextensioncordforwearordamage.

Use of an improper or damaged extension cord could result in electric shock or re.

• Donotobstructtheventilationslots.Thisdevicegeneratesheatwhilecharging.

Excessive internal heat can result in a re.

• Donotuseorstorethechargernearaheatsource.Thisdevicegeneratesheatwhile

charging. Excessive internal heat can result in a re.

Failure to observe these warnings could result in severe injury or death.

ES750

IMPORTANT SAFETY INFORMATION

Charger (cont’d)

Use this charger to charge the supplied 12-volt rechargeable NiCd (nickel cadmium)

batteries only. Other batteries may burst if charged with this charger.

Failure to observe this warning could result in severe injury or death.

Do not place anything other than the supplied 12-volt rechargeable NiCd (nickel

cadmium) battery into the battery pocket.

• Keepdirtandforeignobjectsoutofthebatterypocket.

• Donotcreateashortcircuitacrossthecontactsinthebatterypocket.

Failure to observe this precaution may result in injury or property damage.

• Donotconnectthechargertoagenerator.Voltageuctuationscandamagethe

charger.

• Inspectthechargerbeforeeachuse.Replacetheunitifeitherthechargerorcord

show signs of damage or wear.

• Donotattempttorepairthecharger.Itcontainsnouser-serviceableparts.

• Usethistoolformanufacturer’sintendeduseonly.Useotherthanthatwhichis

described in this manual can result in injury or property damage.

Failure to observe these precautions may result in injury or property damage.

Speciﬁcations

Cutter

Weight (with battery)............................................................................................5 lb, 8 oz

Weight (with battery, charger, and case) ...........................................................9 lb, 10 oz

Height.................................................................................................................... 13-5/8"

Width ....................................................................................................................... 6-1/2"

Depth....................................................................................................................... 4-1/8"

Wire Type.......................................................................................... Copper or aluminum

Maximum Wire Size............................................................................................750 kcmil

Motor.....................................................................................................................12 VDC

Battery

Type .................................................................................. Rechargeable nickel-cadmium

Voltage........................................................................................................................ 12 V

Charger

Voltage.............................................................................................. 120 VAC or 220 VAC

Trigger

RESET

(yellow button)

ES750

Operation

1. Slide the direction control lever to select either FORWARD or REVERSE. Press the

switch to activate the cable cutter. Release the switch after the movable blade is

disengaged from the driver.

2. Place the cable to be cut against the stationary blade until it is engaged by the driver.

Close the movable blade around the cable.

3. Slide the direction control lever to FORWARD. Press the switch. After the cable is

completely cut, release the switch.

4. Slide the direction control lever to the center (LOCK) position.

Circuit Breaker

The following may cause the circuit breaker to trip:

• Cuttingmaterialthatistoolarge

• Cuttingmaterialthatistoohard

• Overheatingduetocontinuoususe

• Drawingexcessivecurrent

If the circuit breaker trips, the tool will stop. If necessary, allow the tool to cool down.

Press the RESET button. (Wait 10 seconds to 1 minute before resetting.)

Do not cut steel or ACSR.

REVERSE

Driver

Fixed Blade

Movable Blade

FORWARD

LOCK

Charger

The battery charger will recharge the battery in approximately one hour.

Do not connect the charger to a generator. Voltage uctuations may damage

the charger.

1. Setthechargeronarmlevelsurfaceoutofdirectsunlight.Besurethatthecharger’s

ventilation slots are not blocked.

2. Connect the charger to an appropriate power supply.

3. Insert the battery into the battery pocket of the charger. The LED will light to indicate

that the battery is charging. After approximately one hour, the LED will turn off to

indicate that the battery is fully charged.

4. Remove the battery from the charger.

Note: Allow the charger to cool for at least 15 minutes before charging another battery.

Andere Handbücher für ES750

Inhaltsverzeichnis

Andere Greenlee Cutter Handbücher

Greenlee

Greenlee GATOR Plus ESG50GL Bedienungsanleitung

Greenlee

Greenlee C3 Auto Whip Clad Cable Cutter Bedienungsanleitung

Greenlee

Greenlee ES750 Bedienungsanleitung

Greenlee

Greenlee 756 Bedienungsanleitung

Greenlee

Greenlee GATOR Plus ESG45GL Bedienungsanleitung

Greenlee

Greenlee Shear 30T Bedienungsanleitung

Greenlee

Greenlee GATOR EK425LXCJACSR Bedienungsanleitung

Greenlee

Greenlee 776 Bedienungsanleitung

Greenlee

Greenlee GATOR ESG45L Bedienungsanleitung

Greenlee

Greenlee ES85 Bedienungsanleitung

Greenlee

Greenlee 655 Bedienungsanleitung

Greenlee

Greenlee KP1022 INS Bedienungsanleitung

Greenlee

Greenlee 764 Leitfaden

Greenlee

Greenlee GATOR ETS12 Bedienungsanleitung

Greenlee

Greenlee 750 Bedienungsanleitung

Greenlee

Greenlee GATOR ESG105LXR Bedienungsanleitung

Greenlee

Greenlee 758 Bedienungsanleitung

Greenlee

Greenlee Gator ES20HVX Bedienungsanleitung

Greenlee

Greenlee GATOR ESG85GL Bedienungsanleitung

Greenlee

Greenlee SDG45 Bedienungsanleitung

Greenlee

Greenlee EBS12ML Bedienungsanleitung

Greenlee

Greenlee GATOR ES32 Bedienungsanleitung

Greenlee

Greenlee GATOR ETS8 Bedienungsanleitung

Greenlee

Greenlee ES25 Bedienungsanleitung

Beliebte Cutter Handbücher anderer Marken

Milwaukee

Milwaukee HEAVY DUTY M12 FCOT Bedienungsanleitung

Makita

Makita DCS552 Bedienungsanleitung

SignWarehouse.com

SignWarehouse.com Bobcat BA-60 Bedienungsanleitung

Makita

Makita 4112HS Bedienungsanleitung

GEISMAR STUMEC

GEISMAR STUMEC MTZ 350S Bedienungsanleitung

Hitachi

Hitachi CM 4SB2 Fehlerbehebungshandbuch

Dexter Laundry

Dexter Laundry 800ETC1-20030.1 Bedienungsanleitung

GCC Technologies

GCC Technologies AFJ-24S Bedienungsanleitung

DeWalt

DeWalt XR LI-ION DCS350N Bedienungsanleitung

Baudat

Baudat ES1 Bedienungsanleitung

Mafell

Mafell ZAF 200 Leitfaden

Makita

Makita 4100NH Bedienungsanleitung

Formax

Formax FD 574 Bedienungsanleitung

EINHELL

EINHELL TE-MA 1500 Bedienungsanleitung

Husqvarna

Husqvarna Cut-n-Break K 760 Bedienungsanleitung

CLEAN ROOM DEVICES

CLEAN ROOM DEVICES CRD130SS Bedienungsanleitung

TRI tool

TRI tool 301A Bedienungsanleitung

Roller

Roller King 1 1/4 Bedienungsanleitung