Page 4
Powering on and Programming
1. Connect the 12 volts dc into the power in plug (refer to page 8)
2. Switch on the unit by pressing the switch towards position 1
3. The RED LED will be illuminated solid while it searches for a signal, when the signal has
been found the LED willchange from solid to flashing every 20 seconds. The unit is now
ready for use.
4. you can now programme your personal contact numbers into the alarm. This number
can be a mobile or landline number.
5. You will need to send an SMS text message as follows (please change the example
number for the number you wish to use)
Example (hash) (NUMB) (equals) (phone number) (hash)
#NUMB=07123456789#
6. The unit will reply back with ‘NUMBER STORED’
7. To change the number please send the text command #RESET# The unit will reply back
with the text acknowledgement ‘RESET COMPLETED’. You can then repeat steps
above to add a new number.
Activating the Alarm
There are two ways to activate the alarm. The first is by using the keyfob, the second is by
text message.
Remote Keyfob
Pressing a) will arm the alarm - the siren will beep twice to acknowledge the command
Pressing b) will disarm the alarm - the siren will beep twice to acknowledge the command.
When the alarm has been triggered, pressing B will stop the siren from sounding. If you
disarm the alsrm within 5 seconds of the alarm being triggered it will also stop the phone
alerts being sent. This is useful for false alarm situations.
Battery life on the keyfob is approximately 2 - 3 years on a button battery.
Text message Activation
Sending the text command
#Alarm=on#
This will arm the alarm. You will receive the text message acknowledgement ‘ALARM=ON’
Sending the text command
#Alarm=off#
This will disarm the alarm. You will receive the text acknowledgement ‘ALARM=OFF’
