2
{Bits per second—9600.
{Data bits—8.
{Parity check mode—None.
{Stop bits—1.
{Flow control—None.
5. Follow the OAP module user guide to log in to the operating system of the OAP module through
the terminal emulation program.
Logging in through the management Ethernet port on the
OAP module by using SSH
1. Connect the management Ethernet port of the OAP module to the network by using a network
cable.
2. Log in to the OAP module through the console port and enable the SSH server function on the
OAP module.
3. Assign an IP address to the management Ethernet port of the OAP module. Make sure the
management Ethernet port and the SSH client (an H3C device or a PC with SSHclient software)
can reach each other.
4. From the SSH client, establish an SSH connection to the IP address of the management
Ethernet port on the OAP module.
After the SSH connection is successfully established, you are logged in to the operating system of
the OAP module.
Logging in through the internal Ethernet interface on the OAP
module by using SSH
When installed in the expansion slot of a device, an OAP module can exchange information with the
device through internal interfaces, including a fast Ethernet interface.
To log in to the operating system of an OAP module through the internal Ethernet interface:
1. Connect the SSH client (for example, a PC) to the Ethernet port of the device by using a
network cable.
2. Log in to the OAP module through the console port and enable the SSH server function on the
OAP module.
3. Assign an IP address to the internal Ethernet interface on the OAP module. Make sure the PC
and the fast Ethernet interface on the OAP module can reach each other.
4. From the SSH client, establish an SSH connection to the IP address of the fast Ethernet
interface.
After the SSH connection is successfully established, you are logged in to the operating system of
the OAP module.
Logging in from the CLI of the device
About logging in from the CLI of the device
From the CLI of the device, you can log in to the CLI of the OAP module. To return to the CLI of the
device, press Ctrl+K.
Restrictions and guidelines
The following OAP modules do not support logging in from the CLI of the device:
