Hadex WN34 Bedienungsanleitung
1
Temperature Sensor
Model: WN34
Contents
1. Getting Started............................................ 2
1.1 Parts List........................................... 2
2. Overview.................................................... 3
2.1 Features ............................................ 5
3. Setup Guide................................................ 8
3.1 Installing battery............................... 8
4. Sensor Placement ..................................... 10
5. Wi-Fi Configuration with gateway........... 15
5.1 Pair with Gateway.......................... 16
5.2 Wi-Fi Connection for the Gateway. 17
6. View Online Data with WS View............. 18
7. Set Email Alerts........................................ 20
8. Specification............................................. 21
9. Warranty Information............................... 23
2
1. Getting Started
1.1 Parts List
One Temperature Sensor
One Mounting bracket for sensor
One Hose clamp for mounting to pole
One Hexagon M12 screw for mounting
One Screw ST D3.2*M2.0*6 for mounting
One User Manual
3
2. Overview
Figure 1: Temperature Sensor (cabled version)
4
Figure 2: Temperature Sensor (probe version)
5
Note: This temperature sensor has two
versions: a probe version (WN34S) and a
cabled version (WN34L) as your selection.
The probe sensor is mainly used to test the soil
temperature, while the cabled version is
mainly used to test water temperature.
The two versions will be recognized as the
same sensor type by the software. If you
purchased both, they will share the eight
channels together and the total supported
quantity of the two sensors could not exceed
eight for one receiver.
2.1 Features
Temperature Sensor
Measures temperature with a 3m (10ft)
6
cabled sensor for the cabled version or a
30cm (11.81inch) stainless steel probe
sensor for the probe version.
Extended wireless range up to 300 feet
(100 meters) in open areas.
Transmits readings every 77 seconds.
IP65 waterproof.
LCD display for current reading.
When paired with a GW1000/GW1100
Wi-Fi Gateway:
View temperature reading on the Live Data
page of the WS View app (requires that the
gateway and your phone are using the same
Wi-Fi network).
Up to 8 channels supported. Channel
names can be edited on the app.
Battery level information displayed on the
7
WS View App.
When paired with a Weather Station
Console (HP2551/HP3500/HP3501):
View temperature data in real-time on the
Display.
Up to 8 channels supported. Channel
names can be edited on the console.
When uploaded to Ecowitt Weather Server:
View current temperature data, history
records and graph on the website.
Receive email alerts from the server.
Remote monitoring with smart phone,
laptop, or computer by visiting the website.
8
3. Setup Guide
3.1 Installing battery
1. Remove the battery door on the back of the
transmitter by removing the screw, as shown in
Figure 2:
Figure 2: Battery installation
9
2. Insert one 1.5V AA battery (be aware of
polarity: flat side of the battery goes to the
spring side of the battery compartment).
The temperature reading will display on the
LCD screen immediately and will normally
update every 77 seconds (the sensor
transmission update period).
Note: If there is no reading on the screen,
make sure the battery is inserted the correct
way or a proper reset happens. Make sure the
battery is inserted correctly. Do not install the
battery backward.
4. Close the battery door by installing the
screw.
10
4. Sensor Placement
To mount the unit on a wall or wooden beam:
Use a screw (Screw ST D3.2*M2.0*6) to
fix the bracket on the wall, and then insert
the probe through the hole of the bracket,
as shown on figure 3-1:
(cabled version)
Inhaltsverzeichnis
Andere Hadex Messgerät Handbücher
