8
Overhead guard
1.7 Roof installation
1. Attach the front roof (Fig. 6/1) to the
two front bars with four M6x20 flat
round screws, washers, M6 nuts
(Fig. 6/2) and four M8x20 flat round
screws, washers and M8 nuts
(Fig. 6/3).
2. Attach the rear roof (Fig. 6/4) with
four M8x20 flat round screws,
washers and M8 nuts to the two rear
bars.
1.8 Cover plate installation
Fit cover plate (Fig. 6/5) respectively
(Fig. 6/6) to the hopper using the existing
M6x10 flanged button head bolts (Fig. 6/7).
1.9 Clamping piece and seat
bearing installation
1. Insert sealing plugs F 12
(Fig. 6/8) into the holes of the seat
bearing (Fig. 6/9).
2. Position clamping piece (Fig. 6/10)
at left rear bar so that is located
between the two sealing plugs.
3. Align seat bearing so that the seat
plate is parallel to the chassis.
4. Tighten screws (Fig. 6/11) with
tightening torque of 15 Nm.
Fig. 6
4
3
2
5
7
8910
11
7
6
B175 R
B260 R
1
