3
Performa™Winch 60.2 STP E/HY
Installation and Maintenance Manual - Mod.D
Introduction - Technical characteristics
Introduction
This manual gives technical information on winch installation and maintenance, including
disassembling and reassembling.
This information is DESTINED EXCLUSIVELY for specialised personnel or expert users.
Installation, disassembling and reassembling of the winch by personnel who are not experts may
cause serious damage to users and those in the vicinity of the winch.
Harken®accepts no responsibility for defective installation or reassembly of its winches.
In case of doubt the Harken®Tech Service is at your disposal at techservice@harken.it
This Manual is available only in English. If you do not fully understand the English language, do
not carry out the operations described in this Manual.
Technical characteristics
Power ratio Gear ratio
1st speed 20,30 : 1 4,80 : 1
2nd speed 61 : 1 14,40 : 1
The theoretical power ratio does not take friction into account.
Performance data
Winch 60.2 STP EL
(electric) horizontal motor vertical motor
12 V (1500 W) 24 V (2000 W) 12 V (1500 W) 24 V (2000 W)
1st
speed
2nd
speed
1st
speed
2nd
speed
1st
speed
2nd
speed
1st
speed
2nd
speed
line speed (m/min)** 17,7 5,9 21,4 7,1 20,3 6,8 24,4 8,1
max load (Kg) 600 1800 600 1800 600 1800 600 1800
**Line speed is measured with no load
motor nominal power (W) current absorption at winch
MWL (A)
12 V 24 V 12 V 24 V
winch 60.2 STP EL horizontal 1500 2000 250 140
vertical 1500 2000 225 120
Winch 60.2 STP HY
(hydraulic) 1st speed 2nd speed
line speed (m/min)* 30,3 10,1
max load (Kg)*** 600 1800
* at 20 L/min oil ow (5,28 Gal/min)
*** at 140 bar a 20 L/min
NOTE
The ratio the line load - pressure are evaluated at ow 20 l/min,
at different ow the line load - pressure ratio change and it's minimum at motor stall.
The pressure on the graph it's the pressure drop between in and out motor ports.
The perfermance are evaluated measuring the pressure and ow on the motor ports.
Performance data based on oli with a viscosity of 35mm^2/s [165 SUS] and temperature of 50° [120° F]
