HealTech Electronics Glpro Mount Bedienungsanleitung
GIpro Mount
Instructions manual
Choose the proper shim
Insert the pin Fasten the clamp
Disassemble the clamp. Separate the plastic shims
and unroll the thin shim. Depending on the target
tube diameter, select the right shim and place on the
handlebar.
Slide the pin in place, making sure the threaded hole is
aligned with the bolt hole.
Tighten the bolt with an
M5 hex (Allen) wrench
to secure the clamp on
the bar in the desired
position.
Wind the arm around the target tube then close.
If a plastic shim is used, rotate it into proper position.
Fully adjustable handlebar mount for GIpro
Place the clamp on the bar
www.healtech-electronics.com
Thick Thin
21-23mm (7/8”) : Thick Shim
24-26mm (1”) : Thin Shim
27-29mm (9/8”) : Without Shim
Cut the tape cover
Mount the housing
Cut the green plastic tape cover (foil) at the back side
of the GIpro unit as shown.
Remove the bolt from the clamp, place the housing
in the desired position and fasten the bolt.
Put the GIpro unit into the housing and push it firmly
for a few seconds.
If you ever need to remove the GIpro from the
housing, use a small flat head screwdriver to lift it up.
Do NOT pull the cable!
Remove the smaller portion of the green plastic tape
cover. Keep the larger portion on the unit.
Do NOT remove the whole cover, otherwise you will
not be able to remove the display from the mount later.
Remove the tape cover
www.healtech-electronics.com
Place the unit in the mount
Andere HealTech Electronics Fahrradzubehör Handbücher
Beliebte Fahrradzubehör Handbücher anderer Marken
Sigma
Sigma BC 16.16 Bedienungsanleitung
Playcore
Playcore Dero Setbacks Bedienungsanleitung
VDO Cyclecomputing
VDO Cyclecomputing x3dw Bedienungsanleitung
Cateye
Cateye RAPID X2 Bedienungsanleitung
buratti meccanica
buratti meccanica Clorofilla Trail Bedienungsanleitung
Shimano
Shimano SG-8R20 Betriebsanleitung
